Question about Cars & Trucks
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: serpentine belt diagram:
The belt routing diagram is located on the top radiator cross member by the hood latch. You should see it when you open the hood. If it is not there, all Chrysler, Dodge, and Plymouth minivans, from 1993 to at least 1999, used the same 3.3L engine setup, so find someone with one and look for the diagram where I described.
Posted on Jul 18, 2008
Here is a digram of your belt. Good Luck and thanks for using FIX YA. http://www.2carpros.com/car_repair_information/tec_info/1999/ford/contour/1999_ford_contour_drive_belt_routing_diagram.htm
Posted on Jan 24, 2009
HI. i have posted the diagram requested below.
Posted on Aug 24, 2009
Testimonial: "This was exactly what we needed, Thank you so very much. "
Here's your belt diagram.
if it's not correct let me know and I'll get you all the routing diagram for that year ram 1500.
Hope it helps.
Posted on Nov 17, 2009
Looking at the engine from front (right side of the Van): Stating at the Top, Going Left to Right and Clockwise:
Over the Alternator
To under the Idle Pulley,
To Over the AC Compressor.
To the Left Side of the Water Pump.
To the Right side and Under the Crankshaft Pulley
To the Right side and Over and Down the Tensioner
To Under the Power Steering Pump
And Back up-to the Left side of the Alternator.
Advise when puting it on:
Put the Belt around everything else accept for the Alternator. After it is around all the rest of the Pulleys - Pull the belt up - tight from the Power steering Pump and the Idle Pulley to form a loop, holding the Belt close to the Altenator Pulley.
Using the 15mm wrench or belt tensioner bar - rotate the Tensioner Pulley towards the front of the Van and then place the belt over the Alternator.
Let me know if this helped or if you have additional information or questions. Feel free to contact me at FixYa.com!
Posted on Jan 22, 2010
Tips for a great answer:
Aug 24, 2013 | 1999 Dodge Avenger
Apr 19, 2013 | 2008 Dodge Avenger
Oct 13, 2010 | 2008 Dodge Avenger
Aug 20, 2010 | 2007 Dodge Avenger R/T Sedan
Aug 06, 2010 | Dodge Avenger Cars & Trucks
Aug 24, 2009 | 2000 Dodge Avenger
Jul 06, 2009 | 1996 Dodge Avenger
Jan 15, 2009 | 1999 Dodge Ram
Jun 27, 2008 | 1993 Dodge Caravan
Sep 22, 2017 | Opel Cars & Trucks
214 people viewed this question
Usually answered in minutes!