Question about 1991 Lincoln Continental
This is not a bolt on hub but rather a press on hub, the wheel bearing will need replacing also, remove wheel, remove the caliper and hang off to side, next remove the brake rotor, next is to remove the axle nut. a matter of fact you without power tools should do this first,before even removing the wheel use a big rachet and pipe for leverage, remove the axle nut first. with axle nut removed,brake caliper hanging off to side and rotor off. next you will discconnect tierod from spindle and remove nut from lower ball joint, sperate balljoint from spindle. next remove bolts from strut to spindle. note if you have abs make sure to dissconnect wire before trying to remove spindle, with strut bolts out remove spindle. at this point i wouls say a press is needed, take to your local shop and ask them to replace the hub. heres a picture of the hub asm. hope this helps you. good day.
Posted on Feb 20, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
hi you will have to remove the wheel,grease cap from the hub remove the brake caliper and move aside (do not seporate rubber line). (discard caliper bolts can not be reused) remove rotor,wheel hub retainer nut (and discard nut can not be reused) in order to remove the hub
hub and new nut and tighten new nut to 189-254 ft.lbs
rotor new grease cap seal
brake caliper with 2 new bolts tighten to125-170 ft.lbs
wheel tighten to85-104 ft.lbs
pump the brake pedal befor moving car
Posted on Feb 06, 2009
SOURCE: one wheel wont turn
Turn, I assume you mean turn right and left?
Yes, that arm is likely the tie rod. There is no pin that can be replaced, the unit needs to be replaced.
If it is the outside tie rod end, you have an easy job ahead of you. Cost about $30 or so. You'll need a front end alignment.
If it is an inside rod end, you should replace your rack. Cost around $100. You'll need a front end alignment.
Posted on Mar 12, 2009
SOURCE: Front right headlight
Hello. I can assist you. To replace the headlight you have to remove the cover on the outside using a phillips head screwdriver. Once you are in to the bulb it just unplugs and you plug in a new one. If you need a little free assistance just drive to any autozone autoparts store where they offer a free service including use of their tools and use of one of their clerks to assist you. In many cases, they just show you by doing the job for you. good luck.
Posted on Nov 16, 2009
Testimonial: "Thanks i'll give it a try!! "
Tips for a great answer:
Oct 25, 2014 | 1996 Lincoln Continental
Jan 17, 2013 | Cars & Trucks
May 24, 2012 | 1999 Lincoln Continental
Apr 11, 2012 | 1995 Lincoln Continental
Dec 30, 2011 | 1999 Lincoln Continental
Mar 15, 2011 | 1999 Lincoln Town Car
Aug 07, 2010 | 1998 Lincoln Continental
May 17, 2010 | 1995 Lincoln Continental
Jun 14, 2008 | 2001 Lincoln Continental
Apr 06, 2014 | 1991 Lincoln Continental
239 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: