Question about Cars & Trucks

Open Question

Toyota FG-25 clutch repair - Cars & Trucks

Posted by on

  • yadayada
    yadayada Feb 19, 2012

    I have no idea what a FG-25 is?? Is this a model soldĀ American?

×

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My ford F6 FG 2009 model ford only engages the cruise control sometimes. what i the problem?


check for sensor adjustments on the brake pedal /system, clutch pedal sensor ( if manual). Run fault codes to check sensors in the transmission and rpm' sender unit.

May 21, 2014 | Ford Cars & Trucks

1 Answer

How to change a clutch master cylinder on a 2006 toyota tacoma


remove line from the side of clutch master cylinder two bolts or nuts on firewall inside vehicle is a pin on the upper side of clutch remove and pull old unit out bench bleed new master by filling and pressing in on the piston of the master cylinder. if you dont have a hose fitting dont bench bleed bleed it in vehicle( this method takes longer) install back in vehicle and hook it all back up torque bolts to 25 ft lbs then bleed the slve cylinder from under vehicle near back of motor just like bleeding brakes pump up hold and release the line pressure by opening valve on slave cylinder.

Apr 06, 2013 | 2006 Toyota Tacoma

1 Answer

The clutch will not engage properly on my 1988 toyota pickup. Already replace clutch master cyclinder and clutch slave?


There are a couple of possibilities; worn clutch plate, failed pressure plate, possible hanging up of the throw-out bearing. Also, some hydraulic clutches have a throw adjustment on the slave cylinder that may need adjustment after replacing the slave cylinder.
If you plan on more DIY maintenance, I would highly recommend buying a Haynes service manual, you'll find the $25 well-spent:
Toyota pickup manual

Mar 31, 2011 | 1988 Toyota Pickup

1 Answer

How much should I expect to pay at a repair shop to replace the clutch in my 1988 Toyota Camry (5spd standard transmission)??


labor charges for clutch repair vary from shop to shop --- your best bet would be to find a shop that deals with late model Toyotas on a regular basis. time wise should be 4 to 6 hours and the cost should be anywhere from $450 to $750 in labor and parts. ( not a hard clutch to replace ).

c...

Jan 03, 2011 | 1998 Toyota Camry

1 Answer

How do i adjust my cluth on a 2003 tacoma


The slave cylinder in these trucks makes the clutch non adjustable. If you have a soft clutch pedal which goes to the floor and can not shift as easy as it used to the slave cylinder is low on fluid or weak. Check the reservoir of the slave cylinder to see if its full. If low fill it with the recommended Power Steering fluid which is DOT3 approved I do beleive and pump the clutch pedal about 25 times with the engine off. The clutch should operate correctly. If it tends to get worse the slave cylinder needs to be replaced

Jul 11, 2010 | 2003 Toyota Tacoma

1 Answer

LOCATION OF AUDIO AMPLIFIER IN A 2003 Z4?


http://www.realoem.com/bmw/showparts.do?model=BT53&mospid=47799&btnr=65_1209&hg=65&fg=25
trunk behind carpet left side. use that site its good for bmw owners realoem.com

Nov 06, 2009 | 2003 BMW Z4

2 Answers

I need to know how to replace a clutch on a 1989 4 runner toyota pickup 6 cylinder engine


2Ways 1 take the Engine out and fit the new clutch if you have a block and tackel or crane to lift it.
2nd Jack up truck as high as possible and fit stands under,, Rmove gear levers/tail shafts/ transfer box and all other parts before removeing X member on box/ and put jack under engine/before removing all bell housing bolts and starter motor..remove box assy.. fit new clutch, refit box etc in reverse of removal.. But engine out is the BEST WAY

Oct 02, 2009 | 1989 Toyota Pickup SR5

1 Answer

My clutch catches at the last 25% on the top is there a way to adjust it so it will catch lower?


No the clutch is self adjusting and if it drives the last bit then your clutch is r/s
In other words worn out and on its last legs and you will soon get clutch when you take off or put your foot down to pass another car THEN its time to take it in and have a new complete assy fitted.
Sorry about that have a goodday

Apr 26, 2009 | Toyota RAV4 Cars & Trucks

1 Answer

2003 Toyota 4 runner Issues


Replace your magnetic clutch relay.
TSB EL011-05 : A/C LIGHT FLASHING - MAGNETIC CLUTCH RELAY 6/3/2005 - 2001 – 2004 Toyota Camry, ECHO, & Celica. 2002 – 2004 4Runner, Corolla, & MR2 Spyder. 2003 – 2004 Matrix, Sienna, & Solara. This bulletin is to provide information regarding countermeasures to the A/C magnetic clutch relay for A/C light flashing (inoperative A/C) issues on some vehicles equipped with a magnetic clutch compressor.
Applicable Warranty*:
This repair is covered under the Toyota Comprehensive Warranty. This warranty is in effect for 36 months or 36,000 miles, Whichever occurs first, from the vehicle’s in-service date.
* Warranty application is limited to correction of a problem based upon a customer’s specific complaint

Sep 02, 2008 | 2003 Toyota 4Runner

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...