Question about Cars & Trucks

Open Question

Reverse lights dont work on holden rodeo

Where is the reverse light switch

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: 1994 isuzu holden rodeo injection timing adjustment

try u-pull our patrs

Posted on Sep 12, 2008

Ad
snownbird33
  • 120 Answers

SOURCE: Holden 94 rodeo petrol

Good Day
Vale clearance cold
intake .006 in (.15 mm)
exhaust .010 in (.25 mm)

Timing
1. With transmission in Neutral or park, start engine and warm to normal operating temp. turn eng,and all accessories off. connect Tachometer. Connect timing light to no 1 spark plug wire.

2. Disconnect and plug fuel vapor canister purge hose and EGR vacuum hose. Start and ensure idle is 900 RPM. adjust idle as required. Check ignition timing ( 12 @ 900)

3. If adjustment is required, loosen distributor hold down bolt and turn until timing is within specification. Tighten distributor hold down bolt and recheck timing. adjust idle speed as required.

hope this helps

Cheers

Posted on Sep 30, 2008

  • 1 Answer

SOURCE: holden rodeo turbo diesel 2007

I KNOW SOMEONE WITH EXACT PROBLEM.
CONTACT ME ON 0400432502 U CAN SHARE YOUR INFOS.
TA21

Posted on May 07, 2009

stevenhurc
  • 450 Answers

SOURCE: 1990 holden rodeo /isuzu pick-up temp sender

from memory it is in inlet manifold some were in front middle section bottom, (underneath) 4ZE1?
single wire possibly yellow

Posted on Jun 25, 2009

johnjohn2
  • 5763 Answers

SOURCE: my reverse lights dont work and i need to no where at on trans.

its on side of trany single round switch. some rev switchs are part of neutral switch.

Posted on Sep 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Could some one please tell me where the reverse light switch on the gearbox is on a holden rodeo ra 05 thank you


07 Rodeo Reverse light switch...where is it? - Rodeo,Colorado and ...

forum.australia4wd.com > ... > Rodeo,Colorado and DMAX Technical

Nov 5, 2011 - 7 posts - ‎4 authors
posted in Rodeo,Colorado and DMAX Technical: My reversing lights ... switch as per workshop manual..could someone throw me a bone here...thanks. ... Started By rodeo5 , Nov 05 2011 04:35 PM ... My 4WD:RA 07 Rodeo; State:NSW ... would say the reverse switch would be on the gear box some where ...

Locate & Repair 96' Pajero Reverse Light Switch - YouTube

? 1:45
https://www.youtube.com/watch?v=osie5D_m-dA
Nov 12, 2010 - Uploaded by TwoMagadan
Locate & Repair 96' Pajero Reverse Light Switch ... Replacing ABack Up Light Switch On A Manual ...

Dec 14, 2015 | Holden Cars & Trucks

1 Answer

RA rodeo disel 4wd reverse light switch location


Could some one please tell me where the reverse light switch is on the gearbox of a holden rodeo ra 05 model thank you

Jul 03, 2013 | Cars & Trucks

1 Answer

Dash lights not working in holden rodeo 1998??


Pull the dimmer switch out for the dash lights and see if it has battery (+) present when the headlights are n, if it does then likely the dimmer switch is defective.

Nov 07, 2012 | Cars & Trucks

1 Answer

I have no rear tail lights on my rodeo 2005 but I got every other light works would love some help on this


Some times the circuit boards go out that hold the lights try this first. they unscrew from the back of the lights the inserts melt.

Apr 07, 2012 | 2005 Holden Rodeo

1 Answer

The reverse lights not working on my 2002 Holden astra


that would suggest the reverse light switch is not working , this is located on the gearbox and has , usually , two wires to it and screws out like a bolt , hope this helps

Jan 31, 2012 | Holden Astra Cars & Trucks

1 Answer

I hav a rodeo 88 and when I turn on my lights the wipers come on when I remove the relay they stop


Sounds like a short if the light switch is on the turn signal swich the its the turn signal swith itself

Jan 05, 2012 | 2005 Holden Rodeo

1 Answer

Turn signals reverse lighs dont work need a wire diagram for this 1997 izuzu rdeo 4x4


Reverse light are operated by the range selector switch on the side of transmission aka. gear selector lever. A problem with the t/s lights would be in the turn signal combo switch.

Jan 11, 2011 | 1997 Isuzu Rodeo

1 Answer

I own a 1998 holden rodeo diesel 4x4 all my lights work except my brake lights. all my fuses are fine and both globes are ok as well


It sounds like the brake light switch has failed. It is located on a bracket under the dash near the top of the brake pedal arm. You could put a bridging wire across the terminals to confirm if the switch is out and the rest of the wiring is OK. If the lights then work replace the switch.

To remove switch, disconnect wiring, loosen locknut and unscrew switch. Replacement is reverse procedure. To adjust, screw in switch until operating button is fully depressed by pedal arm, tighten locknut and reconnect wires. Check for correct operation of lights.

Nov 07, 2010 | 1998 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

352 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...