Question about 2001 Chevrolet Cavalier

Open Question

How much antifreeze do you put in a 2000 chevy cavalier

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 6982 Answers

SOURCE: How much antifreeze to put in?

There should be a mark there somewhere...generally filling to 3/4 full is fine. If you overfill a bit the worst that will happen is that it will spit out the excess....better than under-filling. Also since you needed to add coolant I suggest you take a good look to make sure there aren't any leaks. Better to take care of any while they are small and not causing big problems.

Posted on Sep 20, 2009

ZJLimited
  • 17970 Answers

SOURCE: replace a fuel pump on 2000 chevy cavalier

REMOVAL & INSTALLATION
(see Figures 1 and 2)

CAUTION The fuel injection system remains under pressure, even after the engine has been turned OFF. The fuel system pressure must be relieved before disconnecting any fuel lines. Failure to do so may result in fire and/or personal injury.

  1. Relieve the fuel system pressure using the recommended procedure.
  2. Disconnect the negative battery cable.
  3. Drain the fuel tank, then remove the fuel tank from the vehicle.
  4. While holding the modular fuel sender assembly down, remove the snap-ring from the designated slots located on the retainer.

WARNING The modular fuel sender assembly may spring up from its position. When removing the modular fuel sender from the tank, be aware that the reservoir bucket is full of fuel. It must be tipped slightly during removal to avoid damage to the float.
  1. Remove the external fuel strainer.
  2. Detach the Connector Position Assurance (CPA) piece from the electrical connector and detach the fuel pump electrical connector.
  3. Gently release the tabs on the sides of the fuel sender at the cover assembly. Begin by squeezing the sides of the reservoir and releasing the tab opposite the fuel level sensor. Move clockwise to release the second and third tabs in the same manner.
  4. Lift the cover assembly out far enough to detach the fuel pump electrical connection.
  5. Rotate the fuel pump baffle counterclockwise and remove the baffle and pump assembly from the retainer.
  6. Slide the fuel pump outlet out of slot, then remove the fuel pump outlet seal.

To install:
  1. Install the fuel pump outlet seal, then slide the fuel pump outlet in the slots of reservoir cover.
  2. Install the fuel pump and baffle assembly onto the reservoir retainer and rotate clockwise until seated.
  3. Install the lower retainer assembly partially into the reservoir. Line up all 3 sleeve tabs. Press the retainer onto the reservoir making sure all 3 tabs are firmly seated.

Gently pull on the fuel pump reservoir from retainer to assure a secure fastening. If not secure, replace the entire fuel sender.
  1. Attach the fuel pump connector.
  2. Fasten the CPA connector to the fuel sender cover.
  3. Install a new external fuel strainer.
  4. Install the modular fuel sender.
  5. Install the fuel tank in the vehicle.
  6. Connect the negative battery cable.
  7. Pressurize the fuel system and verify no leaks.
35a484a.jpg

Fig. 1: The module fuel sender assembly is mounted in the fuel tank

fbd4d43.jpg

Fig. 2: Modular fuel pump component identification




Hope this help to solve your problem (remember comment and rated this).

Posted on Apr 25, 2010

Gozer
  • 435 Answers

SOURCE: 2000 Cavalier: Spark plug gap for a 2.2L Chevy Cavalier 2000...

The plug gap is .040

Posted on Jun 02, 2010

cooter_01
  • 43 Answers

SOURCE: "trac off" light on on 2000 chevy cavalier

YOU HAVE AN ABS PROBLEM- TAKE TO REPAIR SHOP.

Posted on Nov 26, 2010

tunde007
  • 2382 Answers

SOURCE: where do i put antifreeze into my 1993 chevy

Hi, the surge tank is located on the passenger's side of the engine compartment. There is probably a sticker that reads "Use DexaCool Coolant Only."

Posted on Jan 10, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Antifreeze mist coming through the vents in my 2000 chevy cavalier


check your heater core for leaks. you will likely find damp carpet on passenger side floor.

Mar 23, 2013 | 2000 Chevrolet Cavalier

1 Answer

2000 Chevy cavalier first my car had a horrible smell of antifreeze coming out of heater vents. then i noticed the floor only behind the passenger seat was soaked with antifreeze. after 2 weeks of...


The heater core is not plugged, it is leaking and will have to be replaced. It will have to be accessed from under the dash on the passenger side. This can be a very difficult item to replace and very time consuming. Plan on it taking a full day.

Jan 29, 2011 | 2001 Chevrolet Cavalier

1 Answer

My 2000 Chevy Blazer will not produce enough heat. The radiator has been flushed with new antifreeze added. The thermostat reaches 180 degrees.


Did you do the flush and fill yourself? did you put pure antifreeze in with distilled water at a 50/50 ratio? If your antifreeze mixture is pure or almost pure antifreeze, then it will not transfer your heat and will not heat the cab well at all.

Jan 24, 2011 | 2000 Chevrolet Blazer

1 Answer

Where do i put antifreeze into my 1993 chevy cavalier


Hi, the surge tank is located on the passenger's side of the engine compartment. There is probably a sticker that reads "Use DexaCool Coolant Only."

Jan 10, 2011 | 1993 Chevrolet Cavalier

1 Answer

How do you drain antifreeze on a 96 chevy cavalier


LOWER LEFT SIDE RADIATOR WHEN FACEING FRONTOF VEHICLE THERE IS WHAT IS CALLED A PETCOCKSOME TIMES ITS LIKE A THUM SCREW SOME TIMES YOU NEED A WRENCH PUT A FUNNEL UNDER IT AND LOSEN ITCATCH IN BUCKET HOLDS A LITTLE OVER A GALLON HOWEVER THIS OLNY DRAINS RADIATOR THERE IS A LOT MORE IN ENGINE

Oct 15, 2010 | 1996 Chevrolet Cavalier

1 Answer

2000 chevy cavalier smokes out the tale pipe


FUEL FIlter may need Replaced...OK...

Aug 02, 2010 | 2000 Chevrolet Cavalier

1 Answer

How do u drain the coolant from a 2004 chevy


Drain from the resevoir by removing the lower hose by pinching the clamp together and pulling, Drain from the radiator via the drain fitting on the bottom...

Oct 08, 2009 | 2004 Chevrolet Cavalier

Not finding what you are looking for?
2001 Chevrolet Cavalier Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...