Question about 1994 Chevrolet S-10 Blazer

1 Answer

Trans or what?

Yesterday when i was on the freeway,my truck made a hesitating motion and then started decelerating.As i was pulling off to the side of the road,my steering wheel was locking up.And while the engine was still on,it basically just stopped.I went to try and start it a cpl minutes later and it actually did,and i made it home,but now it wont start.I've been having problems with my ignition/starter for awhile so im not sure if thats the cause or if its my transmission or its if due to my heating and cooling,which ive had problems with also.When i would go to turn the fan or heat on,it makes my engine bog like its using alot of power just to turn the fan on.I had some unrelated repairs done a few mths ago and it seemed that the vents werent a problem anymore but i could be wrong.Any suggestions would be greatly appreciated! Thanks for reading...

Posted by on

  • cindylc Nov 19, 2008

    thanks so much for your suggestions...i finally got it looked at today and it would seem that the fuel pump is bad....i'll update once it's confirmed...thanks again for your help!!

  • kmcguire24 Dec 04, 2008

    wont shift into drive



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Chevrolet Master
  • 959 Answers

It could be the trans. But I would check some other things first.
You mention that the motor runs down when you activate the blower motor, and the starter was acting up... This leads me to think it is an electrical issue .
Are the battery cables clean and tight?

Posted on Nov 18, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Ford taurus overheated now wont start

run fault codes but from what you describe it may be a replacement motor

Dec 23, 2013 | Ford Cars & Trucks

1 Answer

Power steering very stiff after rapid deceleration

i think it might be ur rack and pinion going bad

Feb 20, 2013 | 1998 Acura TL

1 Answer

My 91 honda accord drives fine,but after driving for a while it starts to hesitate and only drives when i accelerate and decelerate what's the problem?

If the car starts to hesitate at right around 2000 to 2300 RPMs then the EGR ports on the intake manifold need to be cleaned out. The exhaust gas is flooding only one cylinder and causing the hesitation(misfire of that flooded cylinder) since all the other ports are blocked off with carbon build-up. This happen right when the EGR valve opens, letting in the exhaust gas. To find out if this is indeed your problem, remove and plug up the rubber vacuum hose going into the EGR valve and drive the car. If it stops hesitating, that's the problem.

Dec 22, 2012 | 1991 Honda Accord

1 Answer

1998 ford explorer gearshift solenoid

Sounds sort of like an internal wear issue, that may never
be determined, even after a complete disassembly to
rebuild it.

I know that is a vague answer & not a solution or good
guess, but having once owned a trans repair shop, I would
have to show you units apart & you would see wear but
nothing related to your noise or operating issues,just the
way it is with an automatic trans

Nov 15, 2012 | Ford Cars & Trucks

2 Answers

I have a 1998 Buick Century. Yesterday while driving the car's oil light would turn-on when I stopped at a stop sign and when I accelerated the oil light turned-off. I pulled into a gas station and...

The oil light coming on when stopped at a stop sign tells me your engine was already damaged before you had the power loss problem. I would not waste the 650 to put in an oil pump. You would be further ahead to just replace the engine.

Aug 24, 2011 | 1998 Buick Century

1 Answer

Cruise control and tranny problems. possibly related.

sorry the cost of the repair is more than the car is worth ,recon gearbox needed

Jan 23, 2010 | 1992 Chrysler New Yorker

1 Answer

2000 Buick Century started pulling to the right on freeway.

if you hold the steering wheel straight ahead does the car move side to side or does the steering wheel fight you to move side to side.

Aug 24, 2009 | 1999 Buick Century

2 Answers

Tercel out of order

dear friend-it sounds like you have lost a cv joint or diff,isuggest you check that first,then the gearbox.

Oct 28, 2008 | 1997 Toyota Tercel

Not finding what you are looking for?
1994 Chevrolet S-10 Blazer Logo

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides