Question about Toyota HiAce

Open Question

Head bolt tension for 2RZ toyota hiace

Head bolt tension for toyota hiace van model 1991 2rz motor

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

stevenhurc
  • 450 Answers

SOURCE: head bolt tension setting

these specs straight from service info
single cam
25Nm + 70deg+ 70deg+ 30deg
twin cam
25Nm+70deg+70deg+ 30deg

alot of after market gasket sets are the 25Nm and 3 lots of 60deg and the extra 10deg bolts are meant to be replaced (use once only) alot of bolts tend to start stretching when doing last 10 deg use oil on threads and washers under bolts 25 and 3 lots of 60deg is correct and more commonly used.

Posted on May 28, 2009

  • 50 Answers

SOURCE: toyota hiace 3L 2.8 diesel

possibly the firing order on the other car and the firing order on this one are diffrent. if it has a disributar, look at both manuals and make sure the spark plug wires are going to the right piston.

Posted on Jun 20, 2008

  • 3 Answers

SOURCE: 1992 Toyota Previa van,Oil dripping onto exhaust manifold, replace head gasket? need a free manual!

The toyota previa uses a formed silicone gasket for the valve cover and the cover is held in place by metric shoulder bolts ( 10mm). The valve gasket leaks because you can't get enough preload on the bolts to re-seat the old gasket when it gets old and shrinks. The shoulder bolts only allow you to tighten the gasket enough to seat the shoulder on the bolt. If you continue to torque down the suspected bolts, you will snap the bolt off ( don't ask me how I know this ). You can either 1.)replace the old gasket with a new one or 2.) remove the existing bolts around the leak area and put in new metric bolts that do not have a shoulder. You may want to put in a small sleeve into the existing bolt hole but shorter than the thickness of the valve cover to account for the smaller diameter bolt. You can now torque down the bolt and get enough preload to seal the valve cover without removing the old gasket. Make sure you use a torque wrench ( in-lbs) or be very careful not to snap these small valve cover bolts.

Posted on Jul 15, 2009

  • 1 Answer

SOURCE: how to change gearbox oil on a toyota hiace van...

Creating Gears Problem 1st and 3rd sleeping gears, how to romove this problem

Posted on Oct 17, 2010

  • 1 Answer

SOURCE: how to remove and replace the water pump in a toyota hiace van

van is overheating .thinks it may be water pumps

Posted on Mar 05, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the gap setting for a Toyota Hi Ace, 1992 Commuter. Engine Number 2RZ 0248 127


spark plug settings? ' IH8MUD Forum

https://forum.ih8mud.com > ... > Vehicle Tech Forums > 95-older Toyota Truck Tech
  1. Cached
Apr 6, 2007 - i changed my spark plugs and feel my truck is running worse. i was told ... of the gap in my old plugs. any one know if that is the right setting or not? ... ps most Toyota plugs come pre gaped!! hehe!! ... 1992-86 L-4 22RE 1233 .032 9799 .... Flat Land Cruisers · NM- High Desert Cruisers · OK- Green Country ... Missing: ace ‎commuter

TOYOTA ' denso

www.denso.com.au/sparkplug/make/10/toyota
  1. Cached
  2. Similar
150+ items - Model, Engine, Year, Standard Plug, Gap (mm), Iridium Power ... Engine Year Standard Plug ? 3VZE VZN130 V6 1991 on K16RU 3.5L? 2GRFE V6 11/2006 on FK20HR11

Toyota HiAce 89-05 2.4L NGK Spark Plug Set BPR5EY

https://www.fullforceracing.com.au/toyota-hiace-89-05-2-4l-ngk-spark-plug-set-bpr5...
  1. Cached
NGK Spark Plug Set Suitable For Use With -Toyota HiAce 08/89 - 05/05 2.4L ... Notes, It is recommended that all spark plug gaps be checked prior to instalation. Missing: 1992 ‎commuter

Toyota Manuals - Workshop manual store

www.theworkshopmanualstore.com/Toyota-Manuals/index.php
  1. Cached
  2. Similar
Sep 8, 2011 - Keywords: http://www.workshoprepairmanual.com.au/Item/toyota-hi-lux-ln-series- ... It utilized a typical truck setup of A-arms plus coil springs inside front along with .... 2.7559 2.1654 SPARK PLUG SPARK PLUG DISTRIBUTOR IGN. ...... inside 1990 plus 1992) Juha Kankkunen (Champion inside 1993) plus ...
gap setting for Toyota Hi Ace 1992 Commuter Google Search

Nov 15, 2016 | Toyota HiAce Cars & Trucks

1 Answer

Where is the thermostat located and how to replace thermostat on hiace van 2.4 petrol


in the thermostat housing at the motor end of the upper radiator hose .usually 2 bolts holds the housing to the block . then using a scraper pry up clean well and use gasket cement and put in a new one proper side up rebold and away you go .

Feb 20, 2015 | Toyota HiAce Cars & Trucks

2 Answers

Where can I download a free toyota hiace 2.7 petrol 2009 owners manual?


Just google free manual for your model, make sure you put all model specs.

Jan 11, 2015 | 2007 Toyota Hi-Ace 220

1 Answer

Toyota Hiace With 2RZ Engine Has Higher Fuel Consuption Than Before,what May Be The Fault And How May I Rectify It?


run the fault codes as it may be O2 sensors , maf/vaf sensors , blocked cat converter. The codes will tell if it is electronic or mechanical.

Aug 20, 2014 | Cars & Trucks

1 Answer

Hi I have a 1999 2.5 diesel Toyota Hiace. For the past year it has been leaking oil what seems to be around the head,towards the front. The van drives ok and doesn't overheat or lose water. Have taken it...


The oil galley is in this area and the leak is probably from oil pressure and a gasket tension problem. A proper head stud re-tension may help but the fix most probably willbe a new head gasket

Jul 28, 2014 | Toyota HiAce Cars & Trucks

1 Answer

Why would 1995 toyota hiace with 2rz motor with carby shuts down when hot.


what you should have in the electronic distributor is an ignition module with a coil outside wired to the distributor. The ignition module creates the pulses needed for the coil to generate extreme high voltage . If that coil is incorrect voltage for the system then it is most probably overheating and failing to work. There are to voltage coils that can be used . One is a straight 12 volt coil that starts and runs on 12 volts and the other is a start on 12 and runs on 7.5 volts with the run circuit going through a resistor or resistor wire . Check out which coil should be in your car and if correct (7.5) check the voltage to the coil with a multimeter and it be should read 7.5 volts when the ignition is in the run position

May 04, 2014 | 1995 Toyota Hi-Ace

1 Answer

Tension figures for head gasket bolts


instructiones should have been in the head gasket kit.. if not the parts store can give the specs to you..

Dec 15, 2013 | Cars & Trucks

1 Answer

Numbers for re-tensioning head gasket bolts on 2002 toyota hiace van


its in the fsm.
torque and the important sequence.

log in to alldata.com , and see all that. all the time.

Dec 14, 2013 | 1992 Toyota Previa

1 Answer

Toyota Hiace panel van 06 central door locking suddenly stopped working off the key, however still works off the button on the drivers door


central locking not working only has a fob no key hole in door on my toyota hiace van do i need to change motor and is it easy ?

Nov 03, 2011 | Cars & Trucks

1 Answer

2002 toyota hiace van front wiper reservoir refill point


I have the 1990 model and just so happened to stumble on its unusual location today as I was replacing the door hinges. On the passenger side open the door and look above the step, there should be a little plastic cap with the wiper icon on it. hope this helps!

Oct 23, 2009 | 2002 Toyota Highlander

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

142 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...