Question about Ford Cars & Trucks

Open Question

How to bleed ford mondeo radiator

How to bleed radiator system in mondeo

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

freetek
  • 5568 Answers

SOURCE: A3 2.0 TDI changed radiator, how do you bleed the system

If you have no radiator cap that can be removed, you will probably have to do repeated cycles of engine temperature and just add coolant to the overflow until the engine stops draining it. This isn't like a hydraulic (brake) system so the chance of leaving bubbles behind is far less.
With a radiator cap, it's pretty simple; run the engine until the coolant is visibly circulating and add coolant as the level drops.

Posted on Oct 08, 2009

  • 197 Answers

SOURCE: cooling fan problem

NO DON'T!!!!!!!!!!! You'll blow it up! Go to someone like Forddirect who will get you the fan without changing the rad. What is cheaper, a radiator from a scrappies, or a new engine? They are set up for a reason, not for fun. Good Luck.
Forddirect.co.uk
Regards
Dave

Posted on Oct 09, 2009

SOURCE: how to bleed 2009 mondeo

Don't bleed fuel injection
air will blow thru injectors
on start up

Posted on Feb 09, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to bleed the fuel system in the 2009 Mondeo after changing the fuel filter on a diesel


You don't. You just crank the engine until it starts. Modern vehicles work on a pressurised system with a return back to the tank. The fuel is pumped from the tank to the injectors and excess fuel is returned to the tank.

May 12, 2016 | Cars & Trucks

1 Answer

02 ford explorer 4.0 overheating and suddenly blowing cold air, then hot again while engine runs cool but not long


Most likely you have air trapped in your engine, particularly in the heater loop. You need to properly bleed the air out of your radiator cooling system. The hot and cold blasts of air coming from first hot water followed by air.
Read up on how to bleed air out of your radiator system. Some systems are very difficult to bleed.
If after doing a good bleed of the radiator system the problem returns, you may have a bad head gasket or other leak in your cooling system which is injecting air into the cooling system (radiator/water cooling system).

Aug 12, 2014 | 2002 Ford Explorer

1 Answer

Thermastat diagram install


Thermostat - 3.0L (2V) Removal and Installation
  1. Partially drain the engine cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
  2. Remove the three thermostat housing bolts. Fig. 25: Removing Thermostat Housing Bolts
    Courtesy of FORD MOTOR CO.

  3. Remove the thermostat O-ring seal.
  4. To install, reverse the removal procedure.
Thermostat - 3.0L (4V) Removal and Installation
  1. Raise and support vehicle. For additional information, refer to JACKING & HOISTING .
  2. Remove the front splash shield. For additional information, refer to FRONT END BODY PANELS .
  3. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
  4. Remove the cooling tube bolt. Fig. 27: Removing Cooling Tube Bolt
    Courtesy of FORD MOTOR CO.

  5. Lower the vehicle.
  6. Remove the radiator upper cooling tube bolt. Fig. 28: Removing Radiator Upper Cooling Tube Bolt
    Courtesy of FORD MOTOR CO.

  7. Disconnect the upper radiator hose and engine vent hose. Fig. 29: Disconnecting Upper Radiator Hose And Engine Vent Hose
    Courtesy of FORD MOTOR CO.

  8. Remove the two bolts, and separate the radiator tube from the thermostat housing. Remove the thermostat. Fig. 30: Removing Bolts And Separating Radiator Tube From Thermostat Housing
    Courtesy of FORD MOTOR CO.

  9. To install, reverse the removal procedure.

Apr 22, 2012 | 2002 Ford Taurus

1 Answer

I have looked under the car and what looked like a small radiator was hanging down but a bigger radiator was still in place. could you tell me what this component is because i have never seen this...


This is likely the transmission cooler. Does the vehicle have an automatic transmission? It is also possibly a steering system cooler but unlikely. Follow the attached hoses and see where they go.

Sep 05, 2011 | Ford Focus Cars & Trucks

1 Answer

How to bleed 2009 mondeo fuel system after changing fuel filter


Don't bleed fuel injection
air will blow thru injectors
on start up

Feb 09, 2011 | Ford Merkur Scorpio Cars & Trucks

1 Answer

Cooling fan problem


NO DON'T!!!!!!!!!!! You'll blow it up! Go to someone like Forddirect who will get you the fan without changing the rad. What is cheaper, a radiator from a scrappies, or a new engine? They are set up for a reason, not for fun. Good Luck.
Forddirect.co.uk
Regards
Dave

Oct 09, 2009 | Ford F Cars & Trucks

2 Answers

Ford mondeo mk3, intermitent dumping of water from cooing system,found crack in header tank, changed same,ran car at idle, temp guage at normal & heater blowing hot , took car for run , temp guage off...


You may have an air pocket in your system which some times happens.  One way to get rid of it is to take the upper hose off on the engine side,  fill your system with water until it runs out from your engine block, replace the hose, start your car turn you heater on and set to hi keep the radiator cap loose until the temp start to rise then close tight.  Once the air pocket had been remover you can drain some of the water from the radiator using the lower drain plug and add antifreeze.   

Mar 09, 2009 | 2001 Ford Taurus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

265 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...