Question about 2002 Isuzu Rodeo

Open Question

Replacing rear brake shoes for 2002 isuzu rodeo

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 84 Answers

SOURCE: replace the alternator on a 97 isuzu rodeo

from Yahoo answers
The alternator is located on the passenger side of the motor at the bottom. There is a bracket attached to the motor and the alternator. You need not take the bracket off to remove the alternator. Two bolts hold the alternator to the bracket. One bolt is on the front top of the alternator and one bolt is located on the bottom front of the alternator. The bottom front bolt is attached to the tension adjustment for the alternator. Loosen the tension screw then remove the bolt going through the tension adjustment. After you loosen the top, front bolt, the alternator should be loose enough to move side to side. Remove the top, front bolt. Now you must disconnect the alternator from the power supply. Behind the alternator is a screw with a wire attached via nut. Remove this wire. Nextly there is a series of wires with a plug on the end. It is plugged into the side of the alternator. Uplug this item. You can also access both of these from the passenger side front tire well. Something to consider is that remanufactured alternators in Rodeo's as well as the Honda Passport (which has the same engine as the Rodeo) do not work and the problem(s) associated with a bad alternator,ie; not charging, no fan blower, battery light and brake light on, still exsist after replacing alternator with reman. Use a factory original alternator if possible. It will cost a little more than a reman but will most likely save you a lot of time and headache!

Hope this helps you out!!
L

Posted on Sep 29, 2008

Ad
keithheavili
  • 410 Answers

SOURCE: New brakes still making grinding noise

Sounds like it is your hub bearings.  Jack the car up and check for play in the hub bearings.  More than likely this is your issue and the bearings need to be replaced.  Hope this helps.  Thanks for an honest rating.

Posted on May 19, 2009

honeymokey
  • 3113 Answers

SOURCE: water pump replacement 96 isuzu rodeo

Remove belt, fan, fan shroud and fan bracket. Remove timing covers, timing belt and water pump. Replace timing belt and the hydraulic tensioner with new ones. I suggest you get a mechanic to do this as you can easly get it out of time. Not an easy job.

Posted on Jul 03, 2009

citroenchris
  • 600 Answers

SOURCE: 2002 isuzu rodeo. rear wiper continues to run

probably a worn motor, they have a brass slider that rubs on a track on a gear in the motor this gives it the park position, usually it gives an earth return to the motor, to set it going the switch provides an earth, when you turn it off it runs until the slider detects the park position,with wear and water ingress this all goes unreliable

Posted on Nov 30, 2009

  • 233 Answers

SOURCE: where is the thermostat for a 2002 isuzu rodeo?

The thermostat is located at the end of the top radiator hose on engine.

Posted on Feb 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Problems with the brakes isuzu rodeo 2004?


http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?pageId=0996b43f80376053 Here's how to bleed.If it still doesn't help,your rear wheel cylinder or cylinders could be leaking,to check ,remove rear drums and inspect cylinders for leaks,if leaking,check your shoes for spillage,you may need to replace brake shoes,can cause them to get hot and crack.Also inspect inside of drum for wear.

Aug 15, 2012 | 2004 Isuzu Rodeo

1 Answer

Can not get rear drum off to replace brake shoes


look on the back side of the brake backing plate. there should be a little rubber plug, remove it, and use a screwdriver to back the adjuster off, and relieve the pressure on the brake shoes, and the drum will come right off.

Oct 23, 2011 | 1991 Isuzu Rodeo

1 Answer

Are there any recalls for 1999 Rodeo 2.2 engine?


Hello! Yes, there are five...Guru...............saailer


APR 28, 2000 ' Recall ID# 64250

STRUCTURE:BODY VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. THESE VEHICLES FAIL TO COMPLY WITH THE PERFORMANCE REQUIREMENTS OF FMVSS NO. 201, "OCCUPANT PROTECTION IN INTERIOR IMPACT."...

SEP 22, 2010 ' Recall ID# 51618

SUSPENSION:REAR ISUZU IS RECALLING CERTAIN MODEL YEAR 1998-2002 ISUZU RODEO AND MODEL YEAR 2002 ISUZU AXIOM VEHICLES, AND HONDA IS RECALLING CERTAIN 1998-2002 HONDA PASSPORT VEHICLES, THAT WERE ORIGINALLY SOLD, OR ARE CURRENTLY REGISTERED, IN THE STATES OF MAINE, NEW HAMPSHIRE, VERMONT, MASSACHUSETTS, RHODE ISLAND, CONNECTICUT, NEW YORK, NEW JERSEY, PENNSYLVANIA, DELAWARE, MARYLAND, THE DISTRICT OF COLUMBIA, WEST VIRGINIA, OHIO, INDIANA, MICHIGAN, ILLINOIS, WISCONSIN, MINNESOTA, IOWA, MISSOURI, AND KENTUCKY. VEHICLES THAT HAVE EXPERIENCED SUSTAINED EXPOSURE TO HIGHLY CORROSIVE MATERIALS USED IN SOME JURISDICTIONS FOR ROAD DEICING PURPOSES MAY EXPERIENCE EXCESSIVE CORROSION IN THE VICINITY OF THE FORWARD MOUNTING POINT BRACKET FOR THE LEFT OR RIGHT REAR SUSPENSION LOWER LINK PRIOR TO THE TIME THAT SUCH CORROSION WOULD NORMALLY BE EXPECTED....

UN 03, 2002 ' Recall ID# 40179

SERVICE BRAKES, HYDRAULIC:ANTILOCK ON CERTAIN SPORT UTILITY VEHICLES THAT ARE EQUIPPED WITH AN ANTI-LOCK BRAKING SYSTEM (ABS), THE VEHICLES CAN EXPERIENCE EXTENDED STOPPING DISTANCES IN CERTAIN TYPES OF BRAKING EVENTS....

MAR 02, 2000 ' Recall ID# 30771

SUSPENSION:REAR VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. PAINT WAS APPLIED UNEVENLY ON THE REAR AXLES, RESULTING IN INSUFFICIENT PAINT HARDNESS. SHOULD THIS OCCUR ON THE SURFACE THAT CONTACTS THE REAR AXLE LOWER LINK BRACKET BOLT HEAD AND/OR NUT, THE NUT MAY LOOSEN...

MAY 29, 2001 ' Recall ID# 20739

ENGINE AND ENGINE COOLING:ENGINE THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. VEHICLE DESCRIPTION: 1998-2000 RODEO (UE) AND AMIGO (UA) MODELS EQUIPPED WITH 2.2L 4-CYLINDER ENGINES. THE TIMING BELT COULD BREAK BEFORE THE RECOMMENDED SCHEDULED MAINTENANCE....





Dec 07, 2010 | 1999 Isuzu Rodeo

2 Answers

Parking brake cable stretched beyond adjustment how do you replace


Rear Brake Shoes- You'll need to know how to remove the rear brake shoes to remove the parking brake cable. REMOVAL AND INSTALLATION Amigo and Rodeo
  1. Raise and safely support the vehicle.
  2. Remove the rear wheels.
  3. Remove the brake drums.
  4. Remove the brake return springs.
  5. Remove the leading shoe holding pin and spring, and then the leading shoe.
  6. Remove the self-adjuster and the adjuster lever.
  7. Remove the trailing shoe holding pin and spring.
  8. Disconnect the parking brake cable from the trailing shoe and remove the trailing shoe. Remove the parking brake lever from the trailing shoe. To install:
  9. Attach the parking brake lever to the trailing shoe.
  10. Connect the parking brake cable to the parking brake lever.
  11. Apply a thin coat of high temperature grease to the shoe contact points on the brake backing plate (locations A and C in the accompanying illustration), piston contact surface (B), and self-adjuster (D). Fig. 1: Exploded view of the rear drum brakes — Amigo and Rodeo 93026g56.gif

  12. Position the trailing shoe on the backing plate and install the hold-down pin, spring, and retainer. Don't stretch the return spring when fitting the shoes onto the backing plate.
  13. Connect the upper return spring and the leading shoe to the trailing shoe and position the leading brake shoe on the backing plate.
  14. Install the adjuster assembly and the hold-down pin, spring, and retainer.
  15. Use a brake spring tool to install the lower return spring.
  16. Install the self-adjuster lever and adjuster spring.
  17. Adjust the shoe-to-drum clearance to 0.0098–0.0157 in. (0.25–0.40mm) and install the brake drum.
  18. Check the brake drum for scoring or other wear. Machine or replace as necessary. Check the maximum brake drum diameter specification when machining.
  19. Install the rear wheels. Lower the vehicle.
  20. Road-test the vehicle.
prev.gif next.gif

Aug 17, 2010 | 1997 Isuzu Rodeo

1 Answer

Rear brake drum removal


Remove the caliper and make sure the E-brake is off, the drum should fall off. If not, a couple whacks with a lead hammer will knock it loose. The rotor and drum are one. The brake shoes on the E-brake are never worn, they don't see much use when moving. they just lock the wheels. Hope this helps.

Jul 02, 2010 | 2002 Isuzu Rodeo

1 Answer

I do not know how to remove the rear brake drums on my 1999 isuzu rodeo. Is there a set screw that holds these in place? What is the best way to remove the drum?


the first thing you need to do is back off the brake shoes which is done through a slot on the backing plate (you will need a brake adjustment tool) then some imports have 2 or 3 screws holding the drums on to the axle flange yours may not. you should be able to pull the drums off but they may need some persuasion with penetrating oil around the axle flange and a hammer tapping the drum free be careful not to hit to hard as these are made out of cast iron and break easily

Sep 07, 2009 | 2002 Isuzu Rodeo

1 Answer

New brakes still making grinding noise


Sounds like it is your hub bearings.  Jack the car up and check for play in the hub bearings.  More than likely this is your issue and the bearings need to be replaced.  Hope this helps.  Thanks for an honest rating.

May 19, 2009 | 2002 Isuzu Rodeo Sport

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

166 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14384 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...