Question about Cars & Trucks

1 Answer

Install starter on 63 buick skylark

Which wires go where

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

  • Expert
  • 37 Answers

You have 2 small 16 g wires to soloniod,try switcing,will do no damage.

Posted on Feb 19, 2012

  • troy tucker Feb 19, 2012

    can you explain where they are coming from

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

dgjtex
  • 405 Answers

SOURCE: 97 buick skylark wont start

if starter fluid made it chug, I would suspect fuel pump fuse, relay or pump, also fuel filter.

Posted on Dec 29, 2008

  • 1596 Answers

SOURCE: plug wire diagram

Firing order on 2.5L 1 3 4 2 CounterClockwise rotation on Distribitor >>>>>>>>ROTATION>>>>
#4

#4 #1
#3

#1 Cyl # 2 Cyl #3 Cyl #4 Cyl

Front of Car

I Can't Send the Real Picture as FixYa Does NOT Support The Format BUT IF YOU DRAW A LINE FROM DISTRIBITOR PLUG WIRE TOWERS TO THERE MATCHING CYLINDER THEN YOU HAVE THE DIAGRAM. Again I'm So so sorry I am Unable to send the Real Picture , but if You Know your Stuff you can Take it from here. PLEASE Remember to RATE Me here as Most Folks DON'T For Any More INFORMATION you May Email me at this FixYa Screen NAME @ aol.com feel free ! ! ! Tank You

Posted on Mar 29, 2009

  • 2 Answers

SOURCE: My 91 buick skylark won't start. The battery is

More Information pleas, but I think it might be the neutral safety switch. Try starting the car in Neutral and see if it starts, if it does you need to have the NSS, replaced.

Posted on Jun 21, 2009

  • 145 Answers

SOURCE: 93 Buick Skylark 3.3: WON'T START...new starter,

check the wires of crankshaft position sensor and if OK change the sensor.
i seen this problem several times on the same car.

Posted on Jul 19, 2009

  • 484 Answers

SOURCE: I need a wiring diagram for a starter for a 1997

If you want to buy a manual for your car, i would suggest a Haynes. They have excellent wiring diagrams. If you just want to get a peak at one, log on to Autozone.com and register for a free account. Once you do, you can add your vehicles to an online garage and view online manuals that include wiring diagrams.

Hope this helps,
matt

Posted on Oct 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

97 buick sky lark, replaced the starter. There is a two prong connection yes yellow and purple wires. Cannot find were it goes ?


The purple wire should be from the ignition switch. It would go to the "S" terminal of the starter solenoid.
You may also be able to look up a free wire diagram at Autozone.com in the repair section.

Sep 09, 2011 | 1997 Buick Skylark

1 Answer

Where is the starter located on a 1990 buick skylark


at the end of the positive battery wire.

Oct 19, 2010 | 1990 Buick Skylark

1 Answer

How do i change a starter for a 95 buick skylark 3.1 v6


disconnect battery,,,jack up car,,(put jack stand on frame)) remove starter wires,,then starter bolts,,

May 15, 2010 | 1995 Buick Skylark

1 Answer

How do you replace a starter in a 96 buick skylark? easy to do or not?


It is not that hard and should take about 30 minutes. You will need to jack up the engine a few inches before you take the bolts loose from the starter. You will need those three inches to pull the starter out. It needs to fit between the frame and the engine block and it will come right out. After you pull the starter bolts and starter wires.

Oct 15, 2009 | 1996 Buick Skylark

1 Answer

I think the solinoid is bad ,it wont engage into


it's 1 of those jobs that you probably want a mechanic to do unless you can see your starter
f it hangs off the back of the motor then have a mechanic change it as the exhaust is probaby right over top of it abd it has to go downwards and can only be accessed from the botom
if it is on the front of your motor then disconect the baterie and look for 2-3 nolts then hold the starter to the motor or trany
after you remove te\he bolts remove the wires dont be afraid to make a diagram of the wires
heck use masking takpe and tie the wires that go together together and mark them usualy ther are 2 terminals 1 for main power and 1 for the starter circut and the starter circut is usualt red and a lighter guage wire

Aug 03, 2009 | 1993 Buick Skylark

1 Answer

1998 buick skylark engine wont turn when you turn key power good


There should be a click sound from the engine to know that you have the starter relay going. If there is none check that out if it is working or if the wires are connected properly. If there is check out the starter motor if it is connected properly or if it is working at all. Check also the ground wires if they are connected properly.

Jun 26, 2009 | 1998 Buick Skylark

1 Answer

93 Buick Skylark replacing starter...old one had positive post and one smaller...new one has pos post and two smaller...what wire goes where?


Just hook small wire on the same post that it was on the old starter, don't worry about the other post, sometimes the starters are made for different applactions.

May 06, 2009 | 1993 Buick Skylark

1 Answer

97 buick skylark wont start


if starter fluid made it chug, I would suspect fuel pump fuse, relay or pump, also fuel filter.

Dec 29, 2008 | 1997 Buick Skylark

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...