Question about 1999 Dodge Durango

Open Question

Check engine light comes on off; I have scaned and po5o5 has popped up it is the idler air controll motor; replaced three times ; and still no progress what is the problem please help

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 2559 Answers

SOURCE: 1999 dodge ram 1500 motor 318 sputter or chugs.

Check your EGR valve.Sounds like that would be the problem as the symptoms would suggest it is sticking.

Posted on May 01, 2009

  • 1 Answer

SOURCE: cant get ck engine light off...po5o5 code..comes

did u check the gas cap. if it is leaking it will throw an emission code. not familiar with those po5o5 codes i have a reader and it said gross leak. replaced the gas cap and off to the races.

Posted on Jan 20, 2010

  • 2049 Answers

SOURCE: check engine light Po 505 idle air control system

Check for open and short in harness and connector between EFI main relay (Marking: EFI MAIN) and IAC valve, IAC valve and ECM

Posted on Apr 13, 2010

  • 189 Answers

SOURCE: check engine light on scaned with obd 11

#5 injector probaly bad

Posted on Apr 14, 2010

  • 51 Answers

SOURCE: check engine light blinking also loose power while driving

there is no code for replacing a coil pack, you must be getting a random mifire P0300. if plugs and wires are ok, check fuel injectors and for vacuum leaks around intake, especially if fuel trim shows lean

Posted on Jul 07, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What is idling relearn procedure fo dihatsue mira 2008 car?

Idle Air Control System needs adjusting. The throttle body has the butterfly in the wrong position.
Take it to a specialist!

Jun 21, 2017 | Cars & Trucks

1 Answer

My 2005 automatic PT Cruiser lights all PRND all at the same time, the check engine light comes on and the speedometer stops working, and it won't shift out of the first gear. The RPMs just get highe

Jesse A Shelby, my best guess is the
(transmission control module) you said check engine light is on that means codes are being stored , OBD needs to be scaned that's a start. (interesting name).

Sep 08, 2014 | 2005 Chrysler PT Cruiser

1 Answer

Engine idle extremly high

check for vacume leak, if the check engin light is on have it scaned
throttle position sensor could be causing the problem but most likely its the idle air controll motor stuck fully open located on the thottle body not bad to replace held on by 2 torks hed srews

Mar 11, 2014 | Dodge Intrepid Cars & Trucks

1 Answer

1990 Buick Park Ave.

clean the idler on the intake and also clean the throttle sensor, it would also be best to change the air filter and clean the maf sensor. Idler does more than just idle vehicle it controls low revs, and drop down from reves. throttle sensor tell ecu what air to add to the fuel. and the MAF tells ecu how much air is coming into the intake. also check for broken cracked vacuum lines.

Jul 17, 2017 | Cars & Trucks

1 Answer

Iscv 33

There is a digital stepper motor installed in the idle air control valve and it is operated by the ecm after taking all the outputs from various sensors.
Check engine light error code 33. The idle air control valve circuit open or shorted to ground. There could be three possibilities which can trigger this code and the check engine light comes on.
1. Check the wiring harness for open circuit or short to ground. Check the idle speed control valve connector for looseness,corrosion of poor contacts. Jiggle the harness at various places to find any damaged wire.
2. Idle speed control valve defective. (replace. Merely replacing the electronic part of the valve can also solve the problem)
3. ECM defective. (replace)

Dec 12, 2013 | 1999 Toyota Corolla

1 Answer

Very low miles 1995 Hyundai ELANTRA 1800 cc 16 dohc. CHECK ENGINE LIGHT frequently comes on. Stop engine, retart after light goes off...sometimes goes for hundred miles and three times new timing belt...

If the timing belt keeps breaking and bending valves, the timing belt and cylinder head repair is not being done correctly. It's as simple as that. Are you changing the tensioner and idler pullies when replacing the belt? Is it timed correctly? Was the timing belt tension adjusted properly? Were the cam journals checked for damage? If not, you are asking for another belt failure.

If you want to know why the check engine light is coming on, you will have to ask your engine computer. Every time the light comes on it is storing a fault code to tell you why. You must scan your engine control module to retrieve the fault code(s) so you can get it properly diagnosed and repaired.

Jul 04, 2011 | 1995 Hyundai Elantra

1 Answer

Cant get ck engine light off...po5o5 code..comes and goes..changed every sensor..need to keep light off

did u check the gas cap. if it is leaking it will throw an emission code. not familiar with those po5o5 codes i have a reader and it said gross leak. replaced the gas cap and off to the races.

Jan 19, 2010 | 2000 Dodge Durango

Not finding what you are looking for?
1999 Dodge Durango Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides