Question about 2004 Chevrolet Malibu

Open Question

Where is the Neutral Safety Switch on 2004 malibu

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 291 Answers

SOURCE: neutral safety switch

most gm nuet safety is yellow and purple .....out of ignition switch is a big yellow wire that is crank out and input to nuet saf switch......out of nuet switch is color purple that goes strieght to start selenoid.....purple wire also goes to the crank fuse 5amp.. in the fuse box under dash... this fuse goes to the pcm main computer.. same for auto and clutch

Posted on Sep 04, 2009

  • 1 Answer

SOURCE: Neutral safety switch chevy silverado 02'

Hi Is a waterpump on a L300 4wd balt driven ?

Posted on Feb 26, 2010

kapishtech
  • 2272 Answers

SOURCE: where is the neutral safety switch on a 96 camero

The neutral safety switch is located on the driver side mid rear of the transmission.
Thanks. you can rate this solution and show your appreciation.

Posted on May 21, 2010

ZJLimited
  • 17970 Answers

SOURCE: Where is the neutral safety switch on my 2004

Its possible that your have some "no start" condition or intermittent problem about this; to test it, shift the Trans into Neutral, if the engine starts in Neutral, the problem is the Neutral Safety Switch. If the engine still will not start then the problem will be in the Ignition Switch.

The heat of the engine is usually what does in the starter motor. The Neutral Safety Switch is not common at all. It is fairly easy to remove, it is bolted to the drivers side of the transmission where the shift cable attaches. The problem you run into when replacing the Neutral Safety Switch is that the connectors are glued into the switch and will not come out. This will require replacement of the connectors if you replace the switch.

Hope helps (remember to rating this answer and leave a testimonial comment). Thak you for using Fixya.

Posted on Oct 12, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 Chevy Malibu would'start. Put it in dive and back to start and it started.What is wrong that I have to do that.


Maybe a bad Neutral Safety Switch.
  • Neutral safety switch sends a signal to the on-board computer to allow the engine to start and to engage the transmission
  • When not replaced, vehicle may experience no start and/or transmission will not shift out of park.Here's a link to what it look's like.
Duralast Neutral Safety Switch SW5142 Read Reviews on Duralast SW5142

May 30, 2017 | Cars & Trucks

1 Answer

Where is the neutral safety switch on a2004 chevy Malibu, 3.5 L engine


The transmission range (TR) switch is part of the park/neutral position (PNP) and back-up lamp switch assembly (1), which is externally mounted on the transmission manual shaft. The TR switch contains four internal switches that indicate the transmission gear range selector lever position. The PCM supplies ignition voltage to each switch circuit. By grounding one or more of the switch circuits, the PCM detects the selected gear range by the state change of the switch input. Refer to Transmission Range Switch Logic . Switch input to the PCM is represented on the scan tool as HI and LOW. HI indicates an ignition voltage signal. LOW indicates a zero voltage signal. The four parameters represent transmission range switch signal A,B,C and Parity.

Look on transmission where the shifter cable hooks up !

Dec 06, 2016 | 2004 Chevrolet Malibu

1 Answer

2004 Chrysler Sebring. How do I check to see if the neutral safety switch is bad.


The switch is called a PRNDL switch and is located on top of the valve body, inside the transmission.

May 18, 2014 | 2004 Chrysler Sebring

2 Answers

Where is the neutral saftey switch on an 2004 chevy cavalier


It should start in neutral position. Neutral safety switch is usually located under the shift console by the shift lever.

Mar 27, 2013 | 2004 Chevrolet Cavalier

1 Answer

2009 malibu not cranking


Have you checked the neutral safety switch ?
Will it crank in neutral ?

Dec 16, 2012 | 2009 Chevrolet Malibu

1 Answer

Neutral safety switch What is it. Son pulled key out of ignition with the tramission not in park.Can not even turn ignition switch over. Is the neutral safety switch the problem


A neutral safety switch will stop the path of battery power going to the starter motor if the gear shift isn't in park or neutral. I dont believe your issue is here, I would say the ignition lock assembly.

Aug 12, 2010 | 2003 Chevrolet Malibu

Not finding what you are looking for?
2004 Chevrolet Malibu Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...