Question about 2001 Oldsmobile Alero

Open Question

Where can i find the engine mounts in my 2001 oldsmobile alero?

When I put the car in drive it look like the engine wants to move out of place but i do not know where the location of the motor mounts are to see which one is broken?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: 2001 oldsmobile alero

If the "check engine" or "service engine soon" light is flashing, it could be the engine is miss firing. This could be caused by a bad spark plug wire or spark plug. How old are they? After changing the plugs on my 2001 Olds Alero (at 125k miles) I noticed the engine occasionally miss fired and the "service engine soon" light started blinking. I used a timing light to determine which cylinder was miss firing and changed that spark plug wire. Advise would be to change the whole ignition wire set, but I was cheap and just changed the one wire, which cost $23 from a GM dealer. That was 14 months ago and the car runs great.

Posted on Nov 22, 2008

Ad
  • 416 Answers

SOURCE: What type of motor oil do I put in my 2003 Oldsmobile Alero the

There is no V8 Oldsmobile Alero 2003 and 2007 Olds Alero
for V6 Olds Alero 2003
Valvoline / 1 gal. SAE 10W-30 All Climate Motor Oil
Pennzoil / 1 gal. SAE 10W-30 Advanced Protection Motor Oil
Any Brand Syntetic Motor Oil SAE 10W-30
The same for 4 cylinder
Good Luck

Posted on Jan 14, 2009

dealt_soul
  • 296 Answers

SOURCE: MAP sensor

Located on the MASS air flow attatched to the air box

Posted on Feb 16, 2009

  • 14036 Answers

SOURCE: 1999 olds alero timing belt

2.4L engine dont have timing belt.it has a timing chain.fixing timing chain dont cost much.but the damage that occur when it broke.you probably got bent valves.damage piston heads.you can buy car if they dont charge arm and leg.you can repair timing chain your self for at least .$300.00.you have to buy timing chain.it come in a set.you get timing gears and tensioners.about.$190.00 and .$40.00 for timing cover gasket and seal.dealership going to charge you at least.$600.00 including labor.

Posted on Jun 27, 2009

toneman2121
  • 775 Answers

SOURCE: 2001 Olds Alero oxygen sensor bank 1 P0135

p0135 indicates bank 1 sensor 1 which is before the cat.

Posted on May 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2000 oldsmobile alero and I can't get sound out of my rear speakers good speakers and connection just no sound


OLDSMOBILE ALERO 2000 speakers - Sonic Electronix

www.sonicelectronix.com/oldsmobile-alero-2000-car-speakers.html
OLDSMOBILE ALERO 2000 speakers - find speakers that fit your ... sound. This size is capable of delivering exceptional mid-bass that can't be found in smaller ...

2001 Oldsmobile Alero Car Radio Stereo Audio Wiring ...

www.modifiedlife.com/2001-oldsmobile-alero-car-radio-stereo-audio-wi...
Easy Plug and Play Wiring Adapter. ... 2001 Oldsmobile Alero Car Radio Stereo Audio Wiring Diagram ... If you can't find your car audio wire diagram, car stereo wire diagram or car radio ... Right Rear Speaker Positive Wire (+): Dark Blue ... olds alero and I have replace the stock stereo and have found that the sound out put ...

Request a Oldsmobile Car Radio Stereo Wiring Diagram


Jan 21, 2016 | Oldsmobile Cars & Trucks

1 Answer

How to put on a crank sensor for a 2.4 engine of a 2001 oldsmobile alero?


The crankshaft position sensor on your vehicle goes through the engine block and is held by a single mounting bolt.
Disconnect the electrical connector.
Remove the mounting bolt securing the sensor to the engine block.
Using a "twisting back and forth" motion, remove the sensor from the engine block.
NOTE: it is common for these to be coated with carbon deposits that may cause them to stick and make them difficult to remove. Be careful to pull STRAIGHT out and use the twisting motion mentioned above, to avoid breaking the sensor off inside the engine block.
The crankshaft position sensor is located on the left side of the engine block near the oil filter.

Oct 23, 2011 | 2001 Oldsmobile Alero

1 Answer

Where is the front oxygen sensor located on my 2001 Olds Alero having a 4 cylinder engine.


Under hood , center, rear engine area, above exhaust pipe flange, mounted in exhaust manifold. May be behind a heat sheild that will have to be removed.

Jun 23, 2010 | 2001 Oldsmobile Alero

2 Answers

My engine is jumping when i put my car in drive?


if you mean that it feels like the engine lifts up and slams down again, check the motor mounts for at least 1 to be broken.

Mar 10, 2010 | 1999 Oldsmobile Alero

1 Answer

How to replace 2000 Alero cmp sensor?


On the 2.4 litre engine it is mounted on the cylinder head.
On the 3.4 litre engine it is mounted under the throttle body near the area where the transmission and engine meet.
Both sensors are held in place by one bolt.

Feb 24, 2010 | 1999 Oldsmobile Alero

1 Answer

Can't find the transmission on my car [2001 Oldsmobile Alero]


It is customarily bolted to the back end/ left side of the engine if a front wheel drive and on the back end of the engine going underthe car if a rear wheel drive. It is usually silver or aluminum in color and the engine is painted. Good Luck, _Ned_

Oct 31, 2009 | 2001 Oldsmobile Alero

1 Answer

I have a 2001 Oldsmobile Alero, 3400 V6.


could be. have someone verify that you have good fuel pressure 35-40PSI , at 130k miles could be the fuel pump.

Sep 21, 2009 | 2001 Oldsmobile Alero

4 Answers

How do you change a serpentine belt on a 2003 Oldsmobile Alero?


Brute force - you have to pry up the tensioner pulley. The way we did it was put the belt over the alternator and A/C compressor, and get it back in place around the main bearing pulley. Then we took a bar and forced up the tensioner and slid the belt over the main bearing pulley. Voila . . .

Jan 14, 2009 | 2001 Oldsmobile Alero

1 Answer

Oldsmobile alero 2001


Hi, It seems most of your prob could be from worn engine mounts. Have a helper shift from 1st to reverse and see how much the engine moves. [at a fast idle, brake held firm, stand to the side]
This will not cure the prob! Yet My thought is that you will now need to check all the wiring that was involved in this movement.Hope this helps you! Frankster016

Oct 23, 2008 | 2001 Oldsmobile Alero

Not finding what you are looking for?
2001 Oldsmobile Alero Logo

Related Topics:

220 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...