Question about Cars & Trucks

1 Answer

Turn signal,heater,wiper,windows,and back up lights quit workin at same time

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

Sounds like its in your main egnition circut. Try turning the key back slighty when the car is started. Relay may not be disengaging.

Posted on Feb 18, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
gregstobbe
  • 56 Answers

SOURCE: I have a1992 ford explorer the front and rear wipers quit workin

check for power at the wiper motor. If power at the wiper motor but no wiper action then replace the motor. if no power at the motor then use a jumper wire and put power to the motor. Does motor run? if so check for open circuit in the wire someplace.

Posted on Dec 27, 2008

  • 109 Answers

SOURCE: fuel gage turn signals and heater (fan) won't work.

Reversing polarity at the battery is a very bad thing and can cause a host of unpredictable problems. You are lucky that you didn't fry the alternator diodes (the battery is charging, I hope). Each of the problems you describe will have to be treated separately. 1. try replacing the turn signal fuse and flasher unit. 2. fuel gauge has a delicate resistor... probably the easiest fix is to replace the instrument cluster. 3. Heater blower fan has a resistor pack for different fan speeds, this may be replaceable, otherwise a new blower assembly may be the best way to fix it. Hope this helps

Posted on Mar 19, 2009

  • 10 Answers

SOURCE: Problems with tun signal/wiper arm on 2004 chevy venture mini-van

I had the same thing - it also affects the 4 way flashers.  you'll end up replacing the entire control arm (turn signal lever)
Good luck!

Posted on Apr 09, 2009

mechanicm639
  • 253 Answers

SOURCE: windshield wipers quit working on 2003 chevrolet trailblazer. relays and fuses are okay.

There were some issues with ignition switches in those vehicles.It is easy to change and does not cost but about $30. Remove the column covers, unplug the switch, and depress the 2 white tabs holding it in place. Good Luck

Posted on May 23, 2009

buffalonyman
  • 1865 Answers

SOURCE: No running lights or wipers or turn signals or

Check your fuses

Posted on Jul 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My turn signals, windshield wipers and rear window defroster stopped working all at the same time. The fuse and multi-function switch are both fine.


Check all fuses with test light or multimeter. I tend to agree with you that it is probably a fuse. Not knowing of any "hidden" fuses or in-line fuses on that system. But sometimes other fuses that are not labeled as wiper or turn signal might be used for power also. So, check all fuses including the ones under the hood.

Feb 22, 2015 | 2002 Chrysler Sebring

2 Answers

2003 cts cadillac/ window wipes start when they want .


The problem is you don't know how to use it. Try and flick it right back to get it out of the intermittent mode. Also when you turn the wipers on it will stay on unless you turn it off, it's like a light bulb..

Apr 28, 2014 | 2003 Cadillac CTS

1 Answer

Heater, turn signals and wipers quit working


change wiper control on steering column it also controls your heater,it is called a multiple function switch

Feb 10, 2013 | 2001 Audi A6

1 Answer

Windsheild wipers


It doesn,t matter what kind of vehicle it is, You have a short in the wireing some where that will have to be taken into a shop to be check out,

Nov 11, 2012 | Cars & Trucks

1 Answer

Heater, turn signals and rear wiper do not work


https://s9.postimg.org/4k77afpa7/turn_signal.jpg

Click on the link. I looked at turn signal wiring. Check fuse 15--20 amp under hood fuse box. Not only check the fuse, use a testlight and check fuse circuit for voltage, hot all the time. At the combo flasher, there is also, ignition/run voltage, goes hot with the key on, you can see wire color.
There could be other issues. As you can see, turn signal switch is part of ground circuit.
I could post whole diagram on one link, but, too small to read. Usually with multiple issues, I just pick one and check it out. Fixing one issue may or may not fix the others?

Jun 29, 2017 | 1996 Plymouth Voyager

1 Answer

Windshield wipers, power windows & heater motor quit when it is raining hard. turn off engine & restart. these will work for short time or rain quits.


had a rainy day. problem occured. went to dealer with engine running. they pluged in dianogstic computer. found bad relay. replaced. problem solved. thank you.

Jan 03, 2010 | 2007 Chevrolet Uplander

1 Answer

88 Jeep Cherokee problems


That happen to me 3 days ago. The problem is on the ignition key. When you turn it to start the engine, once the engine starts, turn it back a little. is suppose to get back by itself but, get stuck because the cold weather.

Nov 23, 2009 | 1988 Jeep Cherokee

1 Answer

Turn signals and back up lights dont work, bulbs and fuses good. Blinker lights only work in dash when emergency flashers are on.


Test the circuit board wires on the back side of your taillights where the bulbs go in to see if power is going there with the blinker on, if yes replace the circuit board (quite common with these trucks). If there is no power back there check your flasher relays for each turn signal, assuming they dont click off and on when you tip the turn lever. if all else fails, head for the multifunction switch behind your steering wheel inside the column that your turn signal/wiper/cruise control lever is connected to.

Mar 06, 2009 | 1991 Chevrolet C1500

1 Answer

The turn signals and hazard lights quit working temporarily


About the only thing that would cause both the turn signals and hazard lights not to work at the same time would be the flasher relay.

Nov 11, 2008 | 2007 Ford Expedition Eddie Bauer EL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14405 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...