Question about 1999 Oldsmobile Cutlass

1 Answer

Front low beam replacement and does this cost

I could use your help on how to replace my passenger low beam light. Do I have to take wheel well covers off to do this?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Look at the top of the headlight assembly. There is a plastic panel on top of the assembly that is held in place by two plastic pins. Remove those pins by lifting the center of the pin and then pull out the pin. Remove the panel. Then you will find two small plastic levers that will lift about 1/2 inch. They do not come out but they will release two studs that secure the assembly. After the assembly is released, slide it forward to access the bulbs you need to replace. Installation is the reverse of these procedures.

Posted on Mar 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 1995 Ford Explorer Limited and the high beams work but the low beams and fog lights do not, please help....


These trucks are known for bad multifuction switches.
the switch that i talk of is the signal switch , the handle is the switch, it bolts to side of steering column . this switch controls the signals and the headlights and high /low beams. the other thing is the headlight switch connector, the connector some times goes bad and starts to melt or just comes out of the connector. you will need to remove the cover to steering column, the screws are located under the bottom cover in holes. remove cover and check connector and then test for power if you have power going into switch but not coming out then switch is bad.

the last thing is to make sure the bulbs are good , make sure the headlight bulbs are good , and also the driving light bulbs, test for power at the connectors to those lights to.
You will need to do a little testing to find the problem.

Nov 22, 2012 | Cars & Trucks

1 Answer

2007 Lexus 350 ES, 60,000+ miles. My left low beam light went out. A few minutes later both low beam lights went out. High beam and low beam work. Next night both lights were on small and a tiny - mild...


Bulbs are never covered under warranty because they are a wear item (like tires). The factory might do a courtesy repair if the car was near new.
Order the bulbs online and install them yourself. I believe the bulb is D2s, you can find them online for $30-$60.

Jan 22, 2011 | 2007 Lexus ES 350

2 Answers

2003 Kia Sedona replaced low beam bulbs checked fuses still won't work high beams n fog lights work can u help


IF THERE IS NO POWER AT EITHER LOW BEAM LIGHT SOCKET & YOU ARE SURE ABOUT THE FUSES, SWAP THE WORKING HIGH BEAM BULBS WITH THE LOW. IF THAT DOESN'T DO IT YOU NEED TO REPAIR OR REPLACE THE BEAM SELECT SWITCH, { DIMMER SWITCH } KNOWN AS THE COMBINATION SWITCH, UNDER THE STEERING WHEEL. CAN USUALLY BE DONE WITHOUT PULLING THE STEERING WHEEL. TEST BEFORE BUYING, MAY BE COSTLY. GOOD LUCK , DR.VOLT

Jan 21, 2011 | 2003 Kia Sedona

2 Answers

Right headlight low beam does not work, high beam does. Left side headlight works fine


I had the same problem with my 2004 ram, passenger side low-beam wouldn't work after replacement. Online I saw many things from socket replacement to Fcm replacement. What worked was to remove fcm (front control module) and clean appropriate contacts with small nail file . Repair took less than 1 hour and cost 0$, wish I could give credit where I found info.

Nov 28, 2010 | 2004 Dodge Ram 1500

2 Answers

Passenger side low beam and same side front and


There is a box behind the head light,it is a converter,it has most likely gone out,and it is a dealer item.

Apr 23, 2010 | 2001 Lexus RX 300

2 Answers

Bulb replacement for passenger side low beam on 2003 Mazda6


Google "mazda6club" - a very good forum and search "changing headlight bulb. Hope this helps.
Cheers,Peter

Mar 01, 2010 | 2003 Mazda Mazda6

2 Answers

Audi A4 2002 Low beams & Right front turn signal stopped working


For Audi A4 the fuse box is located on the left side of dashboard behind a plastic cover (for left hand steering wheel vehicle). On inner face of the plastic cover you will find the fuse diagram.
First fuse on first row from left upper corner is Fuse Nr.20 = F20 (15A) - RH headlamp low beam, headlamp adjustment.
First fuse on second row from left upper corner is Fuse Nr.21 = F21 (15A) - LH headlamp low beam, headlamp adjustment.

Feb 15, 2010 | 2002 Audi A4

1 Answer

I am trying to replace the low beam bulb on the passenger side of a 2007 Mazda CX7 . Can't seem to figure out how to get to it. Any help?


Open the 2007 CX-7 Owners Manual (here is you don't have one http://www.mazdausa.com/MusaWeb/pdf/manuals/2007CX7OM.pdf)
Go to page 8-35 (P. 331 in the pdf). Close the hood, you're in the wrong place. Remove the cover in the front of the wheel arch to expose the headlight assembly.

Jun 08, 2009 | 2007 Mazda CX-7 Grand Touring

1 Answer

Hello im currently working on a 96 sunfire with the same problem i have high beams only on the right side passenger side is low and drivers is high plus theres no low beam or drl i fixed what i seen for...


There a DRL relay up front that I think is part of your problem. If you go to the front of the car, lay underneath and look up between the rad. and the front bumper, you'll see a set of wires going to a small relay fasten to the bumper. That is the DRL(daytime running lights) Careful removing it and have it replace, can get it at a local part store. After repaceing it, see what problems you have now.
Maybe high beams work now but no low beams? If so, you need to check the blue wire for a open connection. This blue wire controls the low beams. Please take the time and get a manual at your local auto store so you can see the wiring on the lights, this will help you pin point the blue wire.
Just keep checking the blue wire for conutity, through out the blue wire, you'll have to open up the casing cover over the wires to see where they leaded. Hope you find it!

Apr 25, 2009 | 2002 Pontiac Sunfire

1 Answer

Replace low beam headlamp, passenger side, 2004 Navigator


Remove the front radiator air deflector.
Remove the three bolts and the headlamp assembly.
    • Disconnect the electrical connectors.
ef5d2b9.jpg
Remove the headlamp bulb protective cover.
1 Low beam cover. 2 High beam cover.

babb381.jpg
b8093f8.jpg

Feb 13, 2009 | 2003 Lincoln Navigator

Not finding what you are looking for?
1999 Oldsmobile Cutlass Logo

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...