Fan runs but no heat
First solution--check to make sure radiator is full of antifreeze. If not, top up to 1 inch below the top--then run engine 10 minutes--should be heating if antifreeze level was down a quart or more. Second solution--drive car 5 minutes--find open highway--dry road--floor the gas--if engine thermostat is sticking --this MAY blow it open. If there is now heat--the problem is a sticking thermostat. Thirdly, if no solution-- there is a possible plugged heater core--take to technician for testing. (This is under dashboard & extreme work needed to remove.)
SOURCE: I have a 2000 dodge durango, I have a code P0320.
I put in a new crank positioning sensor and it fixed my problem. 42.00 dollars from NAPA. took about 2 hours to change it.
SOURCE: fan belt diagram 04 dodge durango
Here is a diagram of you vehicle. Good Luck please leave a FIX YA comment if I fixed ya. http://www.2carpros.com/car_repair_information/tec_info/2004/dodge/durango/2004_dodge_durango_drive_belt_routing_diagram.htm
SOURCE: my 2000 dodge durango turn signal lights stop working.
Had the same problem,its the hazard light relay,it's located under drivers side under dash, it has a relay that is maybe an inch in size (square). its alitle tuff to get to. hope this is helpful...
SOURCE: replace thermostat in 2000 durango
If you look down on the radiator, on the left side, there is a larrge hose coming out of the radiator toward the engine. Where the hose ends there is a housing with 2 bolts. The Thermostat is found under that. Remove the 2 bolts an replace the thermostat. Unles your arms are very long and thin, you will probably need to do this from under the car.
Perfect time to flush/fill all coolant. Check and replace any needed hoses/clamps.
SOURCE: 2000 dodge durango driver side window problem
durangos have many problems with the windows motors and regulators, I know for personal experience , because I have one, ...when you try rolling the windows down do you hear any noise coming from inside the door..if so.. the cable is busted ..you will need the windows regulator, if no, is probably the motor..you will have to check for power and ground right at the motor connector...if power and ground are present, then you need a motor ....in mine ,I pull the motor and cleaned , and they have been fine for more than a year, I starter with one and them had to do the same to all of them..hope this help
869 views
Usually answered in minutes!
×