Question about 1995 Mazda Protege

1 Answer

10a eng fuse blows when key turned on,on a 95 mazda protege

Turn key to on possition and it blows

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert that has over 500 points.

  • Expert
  • 462 Answers

Wire short or ignition module need replaced

Posted on Mar 02, 2015


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Ignition fuse keep blowing

it sounds like either the wires or module inside the distibutor take the cap off and see if you see anyting melted or any kind of bare wires you can also ohm out the wires checking the resistance that can tell you if you have and open or shorted circuit .a new or used distibutor should fix your problem

Oct 07, 2013 | Cars & Trucks

1 Answer

How to reset check engine light

turn the key to the ON possition and turn it back off again... 4 times in a row. The final (4th) dance , leave the key in the ON possition... the lights on the dash will do their thing... and the temperary codes will be reset..

(NOTE : do not START the car... just turn the key to the ON , not START)

Mar 24, 2013 | 2000 Dodge Neon

1 Answer

No dashboard light

In the main fuse block, check the 15A TAIL fuse to restore instrument lights. In the joint box, check the 10A ROOM fuse to restore interior lights

Oct 11, 2012 | 2003 Mazda Protege

1 Answer

Is there a blower motor relay or fuse on a 1995 Mazda Protege lx?

That fuse sounds like it powers the ac compressor.
The blower motor usually takes a 30 amp fuse.
Does the blower motor work if you hook it to direct voltage ?

Jul 04, 2012 | Cars & Trucks

1 Answer

My 95 protege wont turn over it kicks it just wont turn over and start

have you checked your battery or starter? Either one could cause this. does it try to turn or just click?

Jun 09, 2011 | 1995 Mazda Protege

1 Answer

Security light is on and the key can turn the iginition on however the engine wont turn over. Is there a way to reset the security so the car can start and be driven to a repair shop.

disconect the possitive wire on your battery, reconect then try to start the car three times....on the third try leave the key in the on possition for 20 to 30 minutes then start it up. engine will run ruffly and want to stall just keep giving it gas lightly and drive it to shop.

Dec 27, 2010 | 2008 Mazda Rx-8

1 Answer

How to remove the ignition from hyundai accent ?

take the steering column plastic cover off now you should be able to put your key in and turn it to the one possition. with the key in the on possition there should be a hole in the top or bottom of the column rite under where the lock cylinder goes in, use a small screwdriver to push in the hole and just pull the ingnition lock cylinder out. if you dont have a key a lock smith is your best bet

Apr 05, 2010 | Hyundai Motor 1998 Accent

Not finding what you are looking for?
1995 Mazda Protege Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides