Question about 1997 Saab 900

Open Question

Reset radio code for saab 900

Convertible

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

ilragatzzo78
  • 241 Answers

SOURCE: saab 900 convertible roof not functioning properly

what's going on ??
stuck ??
jerking ??

Posted on May 24, 2008

  • 1 Answer

SOURCE: 1999 Saab 900 radio reset code

whenever the battery is removed (or car experiences any loss of power) you must type in security code for  radio (this is the case with BMWs and Volvos as well).  Go to any saab dealership and they can remove the radio and get your radio's 4 digit code, they all have one.  Yes, I have done this before ` they didn't charge me and I was in and out in ten minutes. 

Posted on Jan 04, 2009

Saaboheme
  • 76 Answers

SOURCE: how to relace clutch cable on 1995 saab se 900 turboon saab 900se

1. Remove the battery.
2. Remove the clutch cable end from the clutch arm end at the wire stop.
3. Slide out the rubber doughnut from the gearbox housing which holds the clutch cable
4. Move the distribution box nut and the alarm pin attached to it (some modules)
5. Disconnect the clutch cable holder from the fender and the data link holder.
6. Remove the drivers lower panel below the steering wheel and remove the air duct as well as the knee shield.
7. Slide out the fuse box holder and ICE Box (should be a black box with many wires going to it). You can remove the instrument cluster at this point but you can also do this without removing the cluster with a little patience
8. Move the pedal spring to one side and remove the eye catch for the cable.
9. Remove the clutch cable by pulling it out from the engine compartment
10. Reinstall in the reverse. Saab actually came out with a bulletin which Needed one to install two washers at the back of the new cable instead of one. The factory cable comes with one but you can remove the 2nd washer off the old cable and install it on the new cable so two exist. This helps take up excessive pedal slack.

Posted on Apr 29, 2009

  • 5 Answers

SOURCE: where do you find the radio code 1994 saab 900

If you buy a cheap set of "din" tools, they poke into the holes in the front of the radio to pull the radio out and often they have written the code on the back of the radio.

Posted on Jun 20, 2009

saabreur
  • 51 Answers

SOURCE: 19886 saab 900 convertible roof not working.

Hi David:

First, check the fuses for the hydraulic motor; if they're blown, replace and monitor (why did they blow? Perhaps an overload, or ...) These fuses are located in the engine bay on top of the fender by the front right wheel housing.

Next check the voltage supply to the top switch, possibly a loose connection or broken wire.

Also check relays C (raising top) and D (lowering top) under the rear seat.

Lastly check for voltage at the pump, also under the rear seat, when the switch is actuated, and that the voltage polarity reverses when the switch is actuated the other way (up or down).

After that, it's a hydraulic/mechanical problem. Check the fluid level in the pump reservoir (use SAAB fluid to top up if low) Fluid level should be at the upper marker with top down, and at the lower marker with top up.

Check behind the rear seat side panels that the piston shaft is still properly attached to the roof mechanism bracket at one end, and the piston itself is still firmly attached to the body. Look for any leakage from the system.

If all tests out OK and looks good under the rear seat and behind the side panels, then there is the possibility that the piston seals have failed and the fluid is just circulating around without activating the piston. Pistons are available (http://www.convertibletopguys.com/cgi-local/displaycat.cgi?cat=584 - scroll down) but the entire system should be removed to avoid getting hydraulic fluid on the interior.

However, that fact that you can operate the hood using the bypass valve (manually) would indicate that the hydraulics are likely OK, and that it's probably an electrical or mechanical problem.

Good luck!

Saabreur

Posted on Aug 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Need the radio code to reset after battery was disconnected.


Afraid there is no radio code as such....the Saab headunit is paired to the car with Saab Tech 2 software.
A dead battery swap shouldnt lose the radio if it was working before you changed the battery.
Have you checked the fuse for the radio?

You should also post on Saabcentral

Jan 14, 2016 | Saab 95 Cars & Trucks

1 Answer

Need radio code for a 1998 saab 900


The codes are not for the Saab but for the radio.
You need to take the radio to a dealer of that brand of radio. There is not just one brand that can be installed by Saab. a Saab dealer can help, but none of us can, because each radio has its own code. But a dealer has the tools to reset it.

Apr 11, 2010 | 1998 Saab 900

1 Answer

I need a "radio code" for a 97 Saab 900 SE turbo convertable SN#YS3DF78N3V7004527 can you help with this or do I need to go to a dealer? I believe the radio is original with the car when new


yes the dealer is the only one that can supply a code for a radio seeing they have the code generation software. they sometimes do it over the phone if your real nice. good luck

Mar 04, 2010 | 1997 Saab 900

2 Answers

I HAVE a 1995 saab 900s and i need the code for the radio i do not have the manual.


my 1995 saab 900s actually has the code written on the casing of the radio once you pull it out

Nov 12, 2009 | 1995 Saab 900

1 Answer

Any one know the code to reset the radio for a 1997 Saab Convertible SE is there some factory setting code


no factory code.look in the paper work for your car.if you don't have the code you must have car vin. model,year,radio style,then you can get the code.

Jul 15, 2009 | 1997 Saab 900

1 Answer

Have 4 digit code, don't know how to reset it. Saab 900 S 1996


Your radio should say CODE when you tune it on. Type the 4 digit code in using your Radio Preset buttons 1 thru 6. If you type in the wrong code more the 3 times the radio will lock you out for a lengthy amount of time...

Hope that helps

Jul 12, 2009 | 1997 Saab 900

3 Answers

Anti theft radio code wont accept number. radio wont work


Disconnect the negative terminal on your battery and reconnect after 10 seocnds. That should reset the radio and you can enter the code.

Apr 18, 2009 | 1997 Saab 900

2 Answers

Where do you find the radio code 1994 saab 900


Upon disconnecting the battery the radio will flash code until you enter the code. If you enter the code incorrectly you must either hold the band button down until the word code reappears or leave the key on for one hour until the word code reappears. This procedure depends on the year of the car. If you do not have the radio code and would like to get it you must call your local Saab dealer with the serial number off the top of the radio. Many times radio owners will write the radio code on top of the radio once you have the correct code. Typically the radio code is in the owners pouch and is a small card with the numbers on it.

NOTE: If this helps you, please, please give me a good rating!!

Mar 16, 2009 | 1994 Saab 900

1 Answer

Can't turn ON the radio. How to use the code?


check and see if theres a Lock-Out code for the unit

Mar 09, 2009 | 1997 Saab 900

1 Answer

1999 Saab 900 radio reset code


whenever the battery is removed (or car experiences any loss of power) you must type in security code for  radio (this is the case with BMWs and Volvos as well).  Go to any saab dealership and they can remove the radio and get your radio's 4 digit code, they all have one.  Yes, I have done this before ` they didn't charge me and I was in and out in ten minutes. 

Nov 01, 2008 | 1996 Saab 900

Not finding what you are looking for?
1997 Saab 900 Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saab Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

rgbypoet

Level 2 Expert

166 Answers

Are you a Saab Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...