Question about 2006 Mercury Grand Marquis
I'd have to test when problem is ongoing. When you first turn on key, no crank, you should hear the pump run for a few seconds then stop. For initial prime, the computer doesn't need rpm signal. Engine cranking, the computer needs to see rpm signal or it won't ground the fuel pump relay. W/o rpm signal, no spark at the plugs and no fuel injector pulse. I know your talking about fuel, but, when problem is ongoing, check spark and fuel injector pulse, engine cranking.
Intermittent problems are a pain, have to test when problem is ongoing.
Posted on Feb 27, 2017
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
you may need to run a wire from a keyed ignition source that has power while cranking and running to the fuel pump relay and bypass the pcm to test wether it will run, if it runs put a more permanent wire in place.Not too sure what tests youve done but it seems that fuel is what your focusing on so a quick test is too spray engine start up the intake tube to see if the engine trys to run if it does it eliminates a lot of other potential reasons for a no start condition.Also try squeezing the fuel return line to see if the added pressure will try to make engine run.Could be time to replace fuel pump etc anyway let me know how it goes good luck with it
Posted on Dec 12, 2008
with the battery fully charged try scraping the positive over the terminal on the battery and see if it sparks like a draw is sucking out amps if theres no draw on the battery it wont spark at all (good) if it sparks (bad) you have something grounded and killing your battery.. gl
Posted on Jan 06, 2009
Well when you turn the keys on the pump will only run for a few seconds A test light works ok but i would use a volt meeter at th efuel pump power and groung wires and measure the voltage while cranking the car
Posted on Jan 18, 2009
Sounds like it might be either the fuel filter or the fuel pump, cause if you ran the tank down, you probably had sludge in the bottom of the tank that you sucked into the engine, you can try using a fuel system cleaner, you may have sucked sludge into the injectors running it, Zmax sells a fuel system cleaner, or there is one called RUN RIGHT, I would try putting some of that in letting it sit a few min then after it sat a few to soak in and break down the sludge, then start the car up, kick your idle up to around 1500 RPM do not go higher then that cause you will damage the engine, try that and see if that works for you, if not then I is probably the fuel pump or filter.
hope this helps.
Posted on May 29, 2009
Tips for a great answer:
Feb 25, 2017 | 1999 Mercury Grand Marquis
Nov 04, 2015 | 2002 Mercury Grand Marquis
Oct 11, 2014 | 2000 Mercury Grand Marquis
Jun 23, 2012 | 2000 Mercury Grand Marquis
Jun 09, 2012 | 2000 Mercury Grand Marquis
Feb 27, 2017 | 2000 Mercury Grand Marquis
Jul 17, 2011 | 2000 Mercury Grand Marquis
Sep 10, 2009 | 2000 Mercury Grand Marquis
95 people viewed this question
Usually answered in minutes!