SOURCE: power steering - 1999 chevy silverado
You're going to have to bleed the system alot on those trucks. Just remove the return line and have an assistant turn the steering wheel back and forth just enough to engage the pump and filling the resevour while doing this. Keep bleeding until you have a good flow of P/S fluid out with no air bubbles. This can take a while.
SOURCE: high pressure power steering hose on a 1995 surburban
PUMP R&R PROCEDURE at Bottom
Do I need to pull the power steering pump off of the 1995 surbuban 350 engine in order to replace the high pressure hose?<-You Ask.
NO Not on the 95 and If you do need or want to REMOVE the PUMP it Comes off Without the Removal of P/S Pump Pulley. Now if you are replacing the P/S Unit Yhere is A Special tool fo pull off Pulley .
Ist a Universal tool for Ford & GM just P/S Pump Pulley Removal Tool Auto Zone has en for $40.00 or rent it from them.
POWRE STEERING PUMP R&R
Removal/Installation
Notes
SOURCE: How do you replace power steering hoses on 1999 Alero with 3.4l
disconnect battery make sure your radio is turn off first so you want lose radio code. you have to reprogram it again before it plays. you need to remove drive belt . alternator and air filter. to get your arm to it.have to remove the lower transmission mount its going to be in your way.remove power steering fluid with a siphoner or large syringe. good luck.
SOURCE: I'm replacing the Power Steering Pressure Hose on my 1995 Chevy
buy a new hose assembly and get some line wrenches the lines are very tight.when you remove the old hose it will spill some hyd. oil.catch it in something. install the hose and fill to the just above the add line.
SOURCE: replace power steering pump on 1995 K1500
You must replace the line. Holes in the lines can not be patched. The pump would not be the problem, if it was the whole line would blow apart.
1,995 views
Usually answered in minutes!
×