Question about 2005 Chevrolet SSR

Open Question

Trunk won't open chevy ssr

Trunk lid will not open on chevrolet ssr. (2005) when you pull the fuse out and put it back in the relay will click. I swapped relays with the horn and still nothing.

Posted by on

6 Suggested Answers

  • 512 Answers

SOURCE: fuse box and relay diagram

raise hood ...standing at drivers fender the row closest to the firewall...the relay closest to you is the horn relay..i would check the 20 amp fuse closest to the relay and see if it is blown. this same fuse powers the cigar lighter

Posted on Sep 27, 2008

Scorpedo
  • 111 Answers

SOURCE: 2005 Chevy express Fuel pump relay meltdown 6.0L

The horn relay was shorting out but not activating the horn. When you swapped it out it sounds like the fuel pump was running all night killing the battery. It sounds like the relay had a dead short inside and melted itself to the fuse box. Depending on the extent of the damage you might have to replace the fuse box as well as the relays.

Posted on Dec 12, 2008

  • 1 Answer

SOURCE: 2005 Chevy express Fuel pump relay meltdown 6.0L

i need diagram for fuse box 1998 chevy van

Posted on Jan 26, 2009

  • 1596 Answers

SOURCE: 2005 Town Country front blower motor inop fuse/relay ok

Break Down And Replace The Blower Motor


REMOVAL

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIR-BAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN AN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY OR DEATH OR DEATH.

NOTE: The blower motor is located on the passenger side of the vehicle under the instrument panel. The blower motor can be removed from the vehicle without having to remove the HVAC housing.

  1. Disconnect and isolate the negative battery cable.
  2. Remove the passenger side cowl trim panel.
  3. Position the carpet to access the front upper screw that secures the air inlet housing.
  4. Remove the recirculation door actuator.
  5. Disconnect the blower motor wire lead connector from the blower motor resistor or power module, depending on application.
    1. Remove the one screw (from the top) that secures the lower air inlet housing to the upper air inlet housing.
    2. Remove the four screws (from the bottom) that secure the lower air inlet housing to the upper air inlet housing and remove the lower HVAC housing.
    3. Push the rubber grommet through the opening in the lower air inlet housing.
    4. Route the blower motor wire lead through the opening in the lower air inlet housing and remove the lower air inlet housing from the vehicle.
    5. Position the recirculation-air door as necessary to access and remove the three screws that secure the blower motor to the lower half of the HVAC housing.
    6. Gently flex the recirculation air door downward to gain access to remove the blower motor from the HVAC housing. NOTE: To aid in installation, note the position of the blower motor mounting tabs prior to removal
      1. Remove the blower motor from the HVAC housing by rotating and tilting the blower motor as necessary.
      INSTALLATION

      1. Gently flex the recirculation-air door downward to gain access to install the blower motor into the HVAC housing.
      2. Position the blower motor to the HVAC housing and tilt and rotate the blower motor as necessary to install it into the HVAC housing.
      3. Align the blower motor mounting tabs to the locations noted during removal and install the three screws that secure the blower motor to the HVAC housing. Tighten the screws to 2 N·m (17 in. lbs.).
      4. Route the blower motor wire lead through the opening in the lower air inlet housing and seat the rubber grommet.
      5. Position the recirculation door pivot shaft into the lower air inlet housing and install the inlet housing.
      6. Install the four screws (from the bottom) that secure the lower air inlet housing to the upper air inlet housing and the lower HVAC housing. Tighten the screws to 2 N·m (17 in. lbs.).
      7. Install the one screw (from the top) that secures the lower air inlet housing to the upper air inlet housing. Tighten the screw to 2 N·m (17 in. lbs.).
      8. Connect the blower motor wire lead connector to the blower motor resistor or power module, depending on application.
      9. Install the recirculation door actuator.
      10. Reposition the carpet.
      11. Install the passenger side cowl trim panel.
      12. Reconnect the negative battery cable.
      13. Perform the heater-A/C control calibration procedure.

Posted on Feb 07, 2009

  • 3 Answers

SOURCE: 2003 Chevy Cavalier Horn Relay Location

under the dash in far left top corner iis a small panel inside are the flashers relays and buzzers which are difficult to remove and install.

Posted on Mar 25, 2009

  • 27 Answers

SOURCE: Where is the horn relay

horn is under the hood, usually on the firewa, how ever there us a horn relay somewhere unfder the dash on drivers side, pull it and makes sure it makes a clickin sounn if u hook power to it

Posted on Jul 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Fuse to open the luggage lid for 2006 Chevrolet Malibu LS


The power block that includes the fuse and power relay for the power trunk lid are located inside the trunk. After you have opened the trunk lid (using a key), look at the left wall to locate the access flap that is cut into the trunk lining. The fuse block is underneath this flap. The 10 amp mini fuse for the power trunk lid is at location #22 and the mini power relay is at location #36. Check the schematic on the fuse block cover for exact locations.

Feb 10, 2015 | 2006 Chevrolet Malibu

1 Answer

I have a 2004 chevy Malibu would anyone happen to know Is there a way i can get Into my trunk from the inside of my car, my key stop working to the trunk and so did the trunk release button, all of my...


There is a relay in the rear fuse block for the trunk release. marked trunk relay #36. It is marked on the under side of the lid. If you knew how they worked you could open it by jumping pin 30 to pin 87 in fuse box. on the side of the relay is a diagram of what pins are what . This system uses an electronic control module called ( the BCM ) body control module .When you push the inside release button , that sends a signal to the BCM ,then the BCM activates the relay opening the trunk . Well that won't help ,you won't believe where the fuse box is ! Fuse Block - Rear
In the rear compartment, behind the left wheel well. You could jump the wire at the BCM that goes to the relay. Can't you pull down one of the rear seats to gain access ?

Dec 27, 2014 | 2004 Chevrolet Malibu

1 Answer

Trunk on my malibu keeps clicking to open with no one around or touching anything. what to do


Step 1:

The year of your Malibu should not matter.

Step 2:

Locate the electrical fuse panel inside the passenger compartment. It should be located behind a plastic panel (kick panel) to the left of the drivers feet or to the right of the front passengers feet.

Step 3:

If you have your cars factory Owners Manual, it can assist you in locating the fuse panel. Once you have located the fuse panel and have removed the plastic cover, read the sticker that is attached to the back of the fuse panel cover. It should show you which fuse is associated with the trunk lock or trunk latch.

Step 4:

If this fuse is found, remove the fuse and determine if the trunk latch has stopped clicking. If you can not find the responsible fuse, you can do the following-

Step 5:

You can pull one fuse at a time until you find the one for the trunk latch (remember, a fuse often is responsible for more than one circuit), or

Step 6:

You can locate the back side of the in-cabin trunk switch, disconnect the connector that attaches to the switch and see if that stops the involuntary activation of the switch. If it does stop, you can safely conclude that the switch that you push to open the trunk will need to be replaced.

Step 7:

Apr 12, 2013 | 2004 Chevrolet Malibu

2 Answers

My trunk won't open, I have tried my trunk button and the key won't work, it worked fine a few hours, but even when i try to do it manually it won't open. Also I would look in and try the...


There are 3 phases to fixing your car's trunk lid release problem.

Phase 1: First check the fuse - once you know that's OK, then proceed to phase 2 (below).
The fuse for the trunk lock is
the bcm (pwr) 15A fuse in the instrument panel fuse box (behind panel at drivers right foot)

Check that fuse, as it is the power supply for the button on the dash that sends power to the actuator in the trunk.

Phase 2: Get the trunk open (without taking it to the dealership).
If you have remote keyless entry to the trunk, you could try that - but with the actuator
dead/dying, it shouldn't work.

Here are a couple of ideas to try to enter trunk while (a) actuator isn't working, and (b) all
valet lockout features (designed to deny valets access to the trunk) are in the "Lock" position:

There is the lock cylinder, which you stated is not functioning - put the key in, and it doesn't
turn. Just to be sure, consider: lubricate key with Graphite lock-type lubricant, and retry.

The trunk has 2 valet safetys...the locking rear seats which require access to the trunk to unlock, and then there is a valet switch in the trunk that locks the button on the dash from working to keep valet parking attendants out of the trunk. That may be in the lock position.

You can try accessing the center area of the fold down rear seat and see if you can unhinge the rear seat from there. Maybe reach in with your hand, or an extension-type tool.

there may be a way to fold the hinge away from the seat back so it can be removed from the hinge and give you access to the safety latch in the trunk and open it that way (white handle in trunk).
The white-handled safety latch release is desiged to prevent accidentally trapping children, and
if you can pull it with your extending-type or grasping-type tool, the trunk will open whether or
not the actuator motor is working.

Phase 3: Replace the Problem part.

Your failed part may be either (1) Trunk Release Relay, or (2) Trunk Lock Release Switch

My Satrun ION manual doesn't cover either of these parts, and the online parts houses, e.g.
http://www.rockauto.com/catalog/x,carcode,1431624,pgname,Electrical-Switch%2B%2526%252338%253B%2BRelay,a,search.yahoo.com%2BSearch%2Bfor%2B2004%2BSATURN
fail to provide instructions. One of those times a mechanic has to t=rely on his/her native
handiness and/or experience.
To identify which of these parts is bad, locae the Trunk Release Relay (call your dealer parts
dept. for helpful tips on finding it), then operate the dashboard trunk release button with your
ear close tothe relay - if it makes a noise, the problem is the Trunk Lock Release Switch in
the trunk lid, otherwise its the relay.

Aug 15, 2011 | 2004 Saturn ION

2 Answers

Where can I get a fuse block for a 2005 chevy ssr


check with these folks - http://www.chevyclassifieds.net/resources/chevrolet-ssr-sale.html

Mar 15, 2011 | 2005 Chevrolet SSR

1 Answer

My husband plane will be leaving soon and his rental car which is a chevy impala trunk is stuck shut and he is unable to obtain his luggage and will be missing his flight. No one can help him at the rental...


If back seats fold down like my 2003 Impala, you should be able to access trunk through back seat. There is an emergency release in the trunk to open trunk lid

Oct 26, 2010 | 2005 Chevrolet Impala

8 Answers

Chevy Malibu Trunk Problem


i have a 2005 chevy malibu and i close the trunk with the keys inside and the little button on the door is stock but the car is open is and other way to open the trunk from inside of the car?

Aug 10, 2009 | 2004 Chevrolet Malibu Maxx

3 Answers

Trunk will open


fold down the rear seat and crawl to the back...there is a latch inside at the center of the trunk lid to open. All newer cars are mandated to have the inside release to prevent children from locking themselves in the trunk

Mar 24, 2009 | 2006 Chevrolet Impala

Not finding what you are looking for?
2005 Chevrolet SSR Logo

Related Topics:

273 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...