Question about 1996 Hyundai Accent
Yes you can but there will be no benefit to your vehicle or your pocket book.
Posted on Feb 18, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: How do I Replace a
The flashers are usually located on the interior fuse block, either on the front or the back of it. Simply pull out the old one, and plug the new one in.
Posted on Jul 22, 2008
hi from uk location of fuel safety shut off valve/switch on uk r/h drive accents is on the engine bay bulkhead in front of drivers side it is a square box with red rubber top press button may be on opposite side on l/h drives ? if activated? just press button till click ? to reset these normally only cut off on impact ? to stop elec fuel pump continuing delivering if involved in an R.T.A fire prevention
Posted on Jan 08, 2009
SOURCE: Changing Camshaft seal
Install the camshaft after lubricating the journal of the camshaft with engine oil.
Install the camshaft bearing caps.
3. Install the ignition coil. 4. Install the rocker arm and rocker arm shaft. Refer to "Rocker Arms and Rocker Arm Shafts" section. 5. Using special tools, Camshaft Oil Seal Installer (09221-21000), press fit the camshaft oil seal. Be sure to apply engine oil to the external surface of the oil seal. Insert the oil seal along the camshaft front end and install by driving the installer with a hammer until the oil seal is pulley seated. 6. Install the camshaft sprocket and tighten the bolts to the specified torque.
Posted on Jun 02, 2009
remove door panel which is attached by screws,peel away plastic liner and look inside door at back of door handle..using needle nose pliers pop off the small steel rods that are for inside door mechanism,then remove the one bolt that attaches the handle to the inside of door and from outside of door remove handle.Replace in reverse order!
Posted on Jul 22, 2009
Tips for a great answer:
Sep 30, 2013 | 1996 Hyundai Accent
Sep 25, 2012 | Hyundai Cars & Trucks
Apr 09, 2011 | 2000 Hyundai Accent
Feb 08, 2010 | 1996 Hyundai Accent
Jan 07, 2010 | 1996 Hyundai Accent
Oct 14, 2009 | Hyundai Motor 1995 Accent
Oct 05, 2009 | Hyundai Motor 1995 Accent
May 26, 2009 | 1997 Hyundai Accent
Dec 21, 2008 | 2001 Hyundai Accent
Feb 19, 2016 | 1996 Hyundai Accent
137 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: