Question about 1991 Nissan Stanza
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Dipstick is to the left of the engine. Should be a small yellow dipstick. Add fluid through the dipstick hole. The vehicle should be running when you do this. It is best to have driven at least 20 miles before adding trans fluid so everything has had time to get hot.
Posted on Feb 11, 2009
SOURCE: how to replace front wheel
I can tell you on a 93 Altima that you have remove the entire wheel knuckle and press it out from the rear. Yeah, the knuckle, remove the strut tower bolts, drive train ( which can be lighty pressed out ), caliper and bracket, and remove the ball joint. There's a snap ring at the back of the wheel knuckle that holds the bearing, then press it out with a socket and a table vice or something to that effect. By the way the going commercial rate if you take it to a shop and have them do it starts at $150 for labor. Worth it, oh yeah.
Posted on Aug 15, 2008
When you turn the key, you should at least hear the starter solenoid click. When you turn the key the ignition switch sends 12 volts to the Starter solenoid ( really just a relay). The Solenoid closes and applies 12 volts (at a high current) to the starter motor to crank the engine. If you have a way to measure voltage, you should get 12 volts at the small terminal on the starter solenoid. The solenoid is mounted on the top of the starter motor.If you get 12 volts but no cranking, the solenoid is not working. If you get 12 volts and the starter doesn't crank the starter is defective. At this [point take a small hammer and tap the starter motor, not hard, just medium. Sometimes this will cause the starter motor to catch next time you turn the key. Best bet is to remove the starter motor (with solenoid attached) and take it to an Auto Zone type store where they can check it out for you. Be dure you disconnect the ground terminal of the battery before you attempt to remove the starter motor.
Hope this helps Good luck loringh PS Please leave a rating for me if appropriate Thks
Posted on Nov 17, 2008
Tips for a great answer:
Dec 04, 2013 | Cars & Trucks
Oct 09, 2013 | 1991 Toyota Corolla
Sep 12, 2012 | 1991 Geo Storm
Aug 31, 2012 | 1990 Nissan Stanza
Aug 01, 2011 | 1991 Nissan Stanza
Oct 17, 2010 | 1997 Nissan Pickup
May 19, 2010 | 1991 Nissan Stanza
Apr 03, 2010 | 1991 Nissan Stanza
Feb 27, 2010 | 1998 Nissan Pathfinder
Feb 04, 2010 | Nissan 240SX Cars & Trucks
109 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: