Question about 1989 Ford F 350

Open Question

How to change fuel filter in f350 with 7.5 motor

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

How can I repair high fuel consumption problem in my car? Will the change of fuel filter make fuel consumption better and solve this problem?


what motor do u have in the car , there are only a small number of things you can do to help this , a good tune up , K&N air filter , headers ,good tires with proper air . make the car lighter depending on the size of your motor these are the main things you can but if you have a big block motor in yout car , get another car , if you have a 4 cyl already , you really are getting good milage per gallon , get a bike if you are a cheap skate

Dec 26, 2014 | Audi A4 Cars & Trucks

1 Answer

Fuel filter location


there is no external fuel filter on your jeep, in 1997 they changed the design and put a filter sock over the fuel pump intake in the fuel tank. they only get changed when you end up replacing the fuel pump

Mar 21, 2014 | 1998 Jeep Cherokee

2 Answers

How do i depressurize the fuel line to change the fuel filter


Remove fuel pump relay or fuse, start engine, till it dies, now your ready to change out the fuel filter.

Sep 24, 2010 | 1991 Toyota 4Runner

1 Answer

Fuel filter light came on motor stoped runing changed filter ran good for 20 milessame thing happened again filter looked good this is a 1989 ford 250 disel with less than 90 thousand miles on it. have...


I have run into this concern many times and have had to replace the fuel heater at the bottom of the filter housing but also check for floating metal particles in the part,if they are present replace the filter again

Aug 31, 2010 | 1988 Ford F 250

1 Answer

Changed fuel pump and fuel filter, now x5 2002 won't start


1. use scanner to find out if there's trouble code.

2.. it's not clear if the starter (motor) turns as you try to start the engine, if not, check starter motor including intermittent (maybe) problem with the ignition switch.

3.if starter motor turns everytime you try to start: check the electrical ignition system: coils & spark plugs

Apr 30, 2010 | 2002 BMW 5 Series

1 Answer

Van dies after 10 min drive when pulling into


Try removing the idle speed motor on side of throttle body, and spray it clean, as well as the port it came out of, with throttle body spray cleaner. Don't pull and extend shaft of idle motor, just leave it in position it's in, and make sure you don't lose small "O" ring on idle motor. Re-install and try it. If it cures it for a while, then starts to do it again, replace the idle speed motor.

Apr 03, 2010 | 1995 Plymouth Voyager

1 Answer

Car wont start after service, 2003 Audi A4 1.9 fuel, air & oil filters changed


definetly something with the fuel filter...could have been installed with the direction of fuel flow backwards...have f filter rechecked 1 test is to disconnect filter from motor side..to see if fuel spills....that will tell u if fuel is passing thru.....GL

Nov 21, 2009 | 1997 Audi A4

1 Answer

Where is the fuel filter located on a 1997 s-10?


It depends on which filter you want to change. There are 2 filters, one along the frame, the drivers side
, and the other is on the motor, just before the injection system. If its carborated the fuel filter will be along the frame, if its injected it will be on top of the motor. Theres 2 clamps that hold it in on both types that hold it in. If its along the frame, it will be a steel line into a rubber hose into filter then back into steel. Ifs its injected, it will be infront or back of the injecters.

Nov 15, 2009 | 1997 Chevrolet S-10 Pickup

1 Answer

Changing fuel filter on 2006 dodge ram 2500 diesel


fuel filter housing on driver side of motor. need the correct size of socket to remove the lid. unscrew lid and pull straight up to remove filter. remove old filter from lid and install new filter and seal. drain old fuel/water from housing. then reinstall filter into housing. tigthten lid then make sure the petcock is closed from draining it earlier. bump the starter a couple times to fill the filter housing then start engine. clean any spilled fuel and your done

Jan 21, 2009 | 2006 Dodge Ram 2500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...