Question about 2000 Buick LeSabre
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: service engine soon light, code
The Volume Airflow (VAF) / Mass Air Flow (MAF) / Intake Air Temperature (IAT) sensor is located on the air intake housing tube inlet.
Your code is P0102 - Mass Air Flow (MAF) Circuit Low Input, them basically this means that there is a problem with the Mass Air Flow (MAF) sensor or circuit. A more technical description would be that the MAF circuit had lower than expected voltage (air flow). Other MAF sensor circuit DTC trouble codes are P0100, P0101, P0103, and P0104.
Fig. Identifying mass air flow sensor connector-3.5L, 3.8L, 3.9L and 5.3L engines
Symptoms: You will likely not notice any serious drivability problems, although there may be symptoms such as a general decrease in power or sluggishness.
Causes: A code P0102 may mean that one or more of the following has happened:
The MAF may be disconnected, or a wiring connection may be bad
The MAF may be dirty or otherwise contaminated (Note: if you use a reusable oiled air filter, be careful not to apply too much oil or that can contaminate the MAF).
The MAF sensor may be faulty
The vehicle computer may be faulty (very rare)
Possible Solutions: The simplest thing to do is to reset the code and see if it comes back. Then start with the cheapest, easiest repair procedures:
Verify that the Mass Air Flow Sensor wiring is connected properly and that there are no broken / frayed wires.
Inspect for any air leaks near the MAF sensor.
Take the MAF out and clean it using a spray cleaner such as brake cleaner or electrical contact cleaner. Be gentle with the sensor.
Check the voltage of the MAF sensor (refer to a repair manual for vehicle specific information)
Replace the MAF sensor.
Then, like a reference guide check this TSB DTC P0102 MAF and this article about Mass Air Flow sensor, what does it do and how it does it.
Test, check it and keep us updated.
Abotu Oxygen Sensor - O2 codes, will need look some code as P0420 in your OBD II codes reader to check O2 sensor wiring for damage from resting on exhaust pipe or frayed wiring.
Hope this helps.
Posted on Jul 09, 2011
Tips for a great answer:
Aug 20, 2016 | 2002 Volvo S40
Mar 04, 2015 | Volvo Cars & Trucks
Apr 23, 2009 | 1999 Oldsmobile Intrigue
123 people viewed this question
Usually answered in minutes!