Question about Peugeot Partner
New discs and pads rear wheel cys and master cyl replaced . brakes bled but still too much travel on brake pedal . is there a bleed valve on abs unit
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: spongy brakes after bleeding
If the brakes are spongy, THERE IS STILL AIR IN THE SYSTEM. Bleed brakes again, and a 3rd time if necessary. If you are MANUALLY bleeding, by having a helper pump up the brakes, make sure they hod the PEDAL DOWN till you close the bleeder valve, or you will **** back in more air. Start bleeding the brakes from FURTHEST WHEEL, which is usually R/R. Hope this helps
Posted on May 12, 2009
Honestly your guess is as good as mine. But I don't think the master cylinder is NOT bad you still have air in the system. Get a big bottle of brake fluid bleed all four sides until you run out of fluid or your brakes work properly. You should divide the bottle's content in four, then use each quantity in each side. You'll be removing air and contaminated fluid from the system. Get a small hose that fits on the bleeders and an appropriate container. I have a good feeling if you do this your brakes will work just fine. I don't know how you are bleeding the brakes. I'll let you know the proper way just in case. This is a two man job, with the wheel off, have someone start the car. Have them pump the brakes a few times to get pressure. 1With the brake pedal UP open the bleeder, 2then have your assistant press the brake pedal all the way down and leave it completely pressed down. 3Close the bleeder valve, once close and only with the valve closed have'm release the brake. Repeat as necessary, bake depressed, open valve first then press brake. DO NOT depress until valve completly closed. Close valve THEN depress. Good Luck!
Posted on May 15, 2009
SOURCE: spongy brakes
Does sound like you need a new master cylinder. On a 2000 you wont need to back bleed. You will just need to follow the instruction and bleed the master and all four points. you will probably need to bleed the ABS block and proportioning valve but only if they have bleeders on them.
Posted on Jun 01, 2009
SOURCE: bad brakes on gmc suburban,
Gravity bleed your brakes starting at the wheel farthest from the master cylinder. No pweddle pumping. I Fill M/C and leave cover off. Then open the bleeder and watch what is coming out. Uou can see bubbles. When the fluid drips steady and without bubbles, cole and do the same to the other three. Don't let the master cykinder get low because thr fluid level helps move the fluid and air through the lines.Periodically tap the break lone with your wrench to keep everything moving.. When sll bleeders drip clean and steady. Make sore your rear brakes are adjusted to barely touch the drum. Then top off the master cylinder, cap it and give yourself a "break". :)
Posted on Jun 15, 2009
Tips for a great answer:
Sep 07, 2013 | Chevrolet Cars & Trucks
Jan 22, 2013 | Cars & Trucks
Apr 12, 2011 | Pontiac Grand Am Cars & Trucks
Sep 30, 2010 | Chevrolet Blazer Cars & Trucks
Dec 03, 2009 | 2001 Chevrolet Venture
May 21, 2009 | 1999 Chevrolet Silverado 1500
38 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: