Question about Vauxhall Vectra
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Check out this video it's a pretty good description of how to fix it.
Posted on Feb 12, 2011
FIRST CHECK THE CABLES THAT RUN INTO THE DOOR BECAUSE THEY CAN GET CUT THOUGH COMMON PROBLEM (JUST WERE THE DOOR HINGES INSIDE RUBBER BOOT.) DOOR PANEL REMOVAL...... PRIZE OUT THE TRIM PANEL AT THE BASE OF ARMREST UNDO TWO SCREWS (DRIVERS SIDE) OR ONE SCREW ACCESSIBLE THROUGH THE ARMREST UNDO THE SCREW AT THE BASE OF THE DOOR TRIM IN THE CENTRE. STARTING AT THE FRONT EDGE CAREFULLY PULL THE TRIM PANEL (ABOVE THE INTERIOR RELEASE HANDLE ) AWAY FROM THE DOOR TO RELEASE THE CLIPS, THEN SLIDE IT TO THE FRONT TO UNHOOK THE REAR EDGE OF THE TRIM PANEL.UNDO THE 4 SCREWS IN THE TRIM PANEL RECESS NOW PULL THE DOOR PANELAWAY FROM THE DOOR FRAME RELEASING THE RETAINING CLIPS, SOME FORCE WILL BE NEEDED PREPARE FOR SOME CLIPS TO BE BROKEN THEN LIFT THE DOOR PANEL UP SQUARELY NOW YOU CAN EASILY GAIN ACCESS TO ELECTRIC MOTOR.HOPE I WAS SOME HELP TO YOU THANKS STAN
Posted on Feb 23, 2009
There are plastic clips that hold the door panel inplace .. First look for any hidden screws near the door handle . there might be a little plastic cover that you need to remove with a small screw driver to find the screws.. look under the handle also to see if there are any hidden screws . next take a flat blade screw driver and start at the bottom corner and try gently prying the door panel off . try to stay close to the plastic clips not to damage them by prying real hard .. once you have snapped them loose all the way around .. lift up on the door panel to remove it from around the window lip and out it should come.. holler if you have any problems.. usually The mirrors on the chevys are up above the panel and there is a triangle plastic cover over it on the inside .. it will pry off also gently and there are 3 nuts there that need to be removed .. use caution these fall behind the door panel ... holler if you need more. Jerry
Posted on Apr 24, 2009
looke for all hiden scews under arm rest by handels and the just pry off if your in s.c. go to jag of greenville body shop and they will help
Posted on Jul 26, 2009
SOURCE: vectra c reset service light
to the right of the dash clocks is a button.
start with the ignition off. press and hold the button.
switch ignition on and wait, after approx 10 seconds your new interval should be displayed and the message insp appears for 2 seconds. wait until "---" is displayed. release the button. switch off ignition.
Posted on Jul 27, 2010
Tips for a great answer:
Apr 25, 2015 | Vauxhall Cars & Trucks
Jul 05, 2014 | 2004 Land Rover FreeLander
Sep 08, 2012 | 2004 Mazda 6
There are few help links to complete this task of removing door panels.Click the link below:---
How to remove the door panel to install a new window regulator?
window motor, regulator and door panel removal?
How to Remove Door Panels ?
How to Access car door panel?
Vehicle door panel components?
This will help.
Jun 07, 2012 | 2004 Cadillac Escalade
Aug 23, 2010 | 2004 Chrysler Sebring
Jul 25, 2010 | 2004 Volkswagen Jetta
Apr 04, 2010 | 2006 Land Rover Range Rover
Apr 03, 2010 | 2004 Ford F150
Feb 21, 2009 | 2004 Audi A4
Jan 11, 2009 | 2004 Chevrolet Impala
2,940 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: