Question about Cars & Trucks
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Mud Flaps
It is'nt difficult at all theres a couple of bolts at the top of the flaps to hold them in place just take old ones out and put new ones in whith mud flaps on.
Posted on Jul 30, 2008
SOURCE: Hi, I'm thinking of fitting
fitting rear flaps is a simple job depending on the kit you buy......you may find the rear window gets dirtier with flaps fitted,due to spray being finer.(citroen is the same a puegeot)
Posted on Feb 15, 2011
That depends on the design of the mud flaps. Typically they have holes in the top for sheet metal screws. Look for any existing sheet metal screws in the fender wheel behind the wheel that match with the holes in the flaps - you can just remove those, put the mud flap up and put the screw back in if it is long enough (if the mud flap doesn't have a metal strip across the mounting edge, you'll need a large washer under the screw head to distribute stress across the material or it will crack).
If you don't have matching holes, you'll have to drill them. If you are going into steel, use a bit sized for the shank of the sheet metal screw, or just drill the screw in directly. After you get the screw in, take it out and fill the hole with rust-protecting sealant, then put the screw back in. If your mounting hole is on fiberglass or plastic, use a nut and bolt with fender washers under both the screw head and the nut. I recommend either stainless steel or cadmium plated hardware for corrosion protection; this is a harsh environment.
If you don't have a straight surface for mounting the mud flap, you may have to bend a heavy galvanized steel strap with holes in it (perhaps a pipe hanger) to make a mounting bracket. Attach one end to the vehicle as described in the previous paragraph, and attach the mud flap to it.
I would expect a new mud flap set would include the necessary hardware to adapt it to different vehicles. If you've already purchased a new set without any of this material, you can look at some of the other sets on the market for ideas on mounting brackets. The exact method you use is not critical, so long as it holds the flap without breaking anything (consider the stresses from flapping back and forth and try to envision where the greatest stresses and material fatigue would be), and is reasonably protected from corrosion.
Posted on Nov 05, 2011
Tips for a great answer:
Aug 21, 2016 | Dodge Cars & Trucks
Feb 18, 2015 | Ford Falcon Cars & Trucks
Nov 04, 2011 | 2011 Dodge Ram Pickup 1500
Feb 15, 2011 | Renault Sportwagon Cars & Trucks
Mar 25, 2009 | 2008 Land Rover LR2
113 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: