Question about Cars & Trucks

Open Question

Peugeot 307cc air bag fault - Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: i have just changed the indicator/wiper arm (this

you have to be careful with the airbag connectors, they may look fitted but sometimes they dont go fully in - so check. on the steering wheel there is a black earth wire connected to a male connector, you need to cut the end off the wire and put a round earth terminal on it, then drill a small hole in the metal part of the steering wheel and fit a self tapping screw through the electrical connector you fitted and screw it into the hole you drilled. that is the usual cause for the horn not working e.g. bad earth connector on steering wheel. if you are not sure ask someone that knows about electrics

Posted on Aug 02, 2009

venson101
  • 30 Answers

SOURCE: how to fit an electronic power steering pump on PEUGEOT 307cc

it is under the right front light of the car and you should replace in a peugeot center in order to set it up on the computer or it will not work.

Posted on Oct 19, 2009

alicantecoli
  • 22095 Answers

SOURCE: peugeot 307 HDI airbag warning goes on and blleps

common fault defective centralita computer sorry forgotten name in english been in spain too long .When they get hot where car is left in hot sun the lights start blinking ,these cars and citreons suffer from this fault but not often,cure new centralita ,Once vehicle goes to the test and they see it then its about 2000euros to fix because it will not pass without the relevant paperwork and certificates from dealer,Best advice sell it quick before it costs a lot of money to fix

Posted on Jan 17, 2010

  • 4793 Answers

SOURCE: Got a 307cc Stupid me left something on the back

UNFORTUNATELY, yes.(actually it should be relatively cheap to sort out,depending on any damage)

Posted on Jun 14, 2010

  • 1 Answer

SOURCE: how to remove and replace

Should look like a block with 10mm bolts. Right on top of the engine probably under some noise reduction panels. Which undo with a flat screwdriver 1/2 turn. Then undo the 10mm bolts and disconnect the electrical connector. And pull :-)

Posted on Jul 05, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Air bag fault and power supply fault


Has the battery been run dead or disconnected for some reason? If so you may need the fault cleared with a scan tool.

Sep 28, 2016 | 2008 Peugeot 207 CC

1 Answer

Al4 transmission gear fault 1st to 2nd


have you checked the fluid level as this is a symptom of low fluid , also get the OBD codes read as will tell you if a sensor/switch is faulty

May 14, 2014 | 2008 Peugeot 307cc 1.6

1 Answer

Diagnosis read fault p336


p0140 - 02 sensor circuit no activity detected, (bank 2 sensor 1)
P0170 - fuel trim malfunction (bank 1) MM6LP - fuel injection fault
P0336 - Crankshaft Position Sensor A Circuit range/performance SID801/4 - Engine speed signal coherence.
P0352 - Ignition coil B Primary/secondary circuit malfunction MM6LP - 2/3 ignition coil control. Open circuit, short circuit to positive, short circuit to earth. ME746 - NO.1 Ignition coil control function. Short circuit to earth. ME746 - NO.2 ign. coil control function. Short circuit to earth.
P0414 - Secondary Air Inj. system switching valve A circuit shorted. MM6LP - Air pump relay control failure.

Mar 21, 2014 | 2008 Peugeot 307cc 1.6

1 Answer

Peugeot 807


it is possible the clock spring i agree,it is the common problem of the open circuit at the system

Jan 27, 2014 | Cars & Trucks

1 Answer

Peugeot 307cc window


Mabe of the runners

Sep 20, 2013 | Cars & Trucks

1 Answer

I have a peugoet 307cc and fault has come on boot mechanism faulty when i try to put my roof down


Unfortunately, there is almost nothing that you can do yourself with this. It will require a manufacturer reset at your local Peugeot Garage.

Feb 28, 2011 | Peugeot 405 Cars & Trucks

1 Answer

Air bag fault


In my opinion there might be a problem of wiring after changing the indicator console as there is connection problem of air bag in steering wheel. If there is a loose connection for any air bag the light goes on. You have to recheck the wiring and any loose connection for your air bag of steering wheel. But be sure to disconnect the battery terminals before you try to find out any fault in this area.

Jan 18, 2010 | Peugeot 405 Cars & Trucks

1 Answer

How to fit an electronic power steering pump on PEUGEOT 307cc


it is under the right front light of the car and you should replace in a peugeot center in order to set it up on the computer or it will not work.

Oct 19, 2009 | 1987 Peugeot Liberte

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

178 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...