Rebuilding a 1993 honda civic dx 1.5 engine do not know the torque settings on the piston connecting rods
SOURCE: Replacing head gasket on 1995 honda civic, require torque specs and secquence
7.3 ft.lbs Go from middle, to back right, to back left, to front right, to front left. if your standing in fron of your header. 11 or over usually shears the bolt.(if you have stock bolts)
Make sure you dap some rtv on the sharper 4 corners of the gasket where the cam seals are.
James Mac
SOURCE: TORQUE SETTINGS ISUZU RODEO FOUR CYLINDER
I dont know the specific answer for your question, but I own a 1995 Rodeo and there is an online community you could probably check out that Im sure would have the answer for you.
Check out www.planetisuzoo.com, sign up and post your question there. There are several knowledgeable people there and some good information as well.
SOURCE: Burning smell when I drive in 1993 Honda Civic 4 door
the info of the problem is to broad, what type of smell is it plastic smell wire smell rubbery gassy? theres to many smells a car can generate while driving down a highway to narrow it down to just clutch plate or brake pads
although yes both can make a smell down the highway its more than likely a grease or liquid burning you should check your engine for leaks mainly around the head and tranny and also check your boots and joints it could even be you picked something up off the road and its now stuck on your pipes burning try it all out
SOURCE: torque specs for the main bearings, connecting rods and heads
Here you go...
Connection Rod Nuts: 37-38 Ft Lbs.
Main Bearing Caps: 55-61 Ft Lbs.
And Head Bolts...
1st - step; - 80 ft./lbs.
2nd - step, loosen all bolts;
3rd - step; - 80 ft./lbs.
SOURCE: 93 Honda Civic Sedan not shifting into overdrive
overdrive may be worn out and u dont feel it shift or ur tranny is messed up
201 views
Usually answered in minutes!
×