Question about 2007 Chrysler Aspen 4x2

Open Question

Where is the number 1 cylinder for a 5.7l hemi

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Witch coil pack is e and g on a 03 dodge 2500 5.7 hemi magnum the tester say there the bad ones


I don't know why they changed from numbers to letters, but.. Standing in front of the truck, First cylinder on your right hand side is A. B is the first cylinder on your left. Back and forth till you find the ones you need. So E and G are as follows
H G
F E
D C
B A

Jul 07, 2015 | Dodge Cars & Trucks

1 Answer

I have just imported a 2007 dorango with the Hemi engine? I need the engine number to get a certificate of conformity. But can't locate it?


  • The engine serial number is stamped into a machined pad located on the left, front corner of the cylinder block.

May 02, 2015 | Cars & Trucks

1 Answer

04 DODGE Ram hemi cylinder 3 misfire


Check engine compression and compare. then test running engine compression most engines have about 130-170 cranking compression and about 90-110 running compression. OR bring that cylinder to its Top Dead Center compression stroke apply air to the cylinder and check to see where the air is going open throttle plate bad intake valve, from exhaust pipe bad exhaust valve, from oil cap piston rings.

Mar 23, 2014 | 2004 Dodge Ram 1500

1 Answer

Hydraulic lifters


Pull #7 spark plug perform a cold compression test, then perform a hot compression test. What were your reading?

Feb 10, 2014 | Dodge Ram 1500 Cars & Trucks

1 Answer

Need cylinder 6 for replacing plugs 2500 03 5.7 litter hemi


Hi there:
On 2003 Dodge RAM 2500 3/4-Ton 5.7 liter Hemi V-8 VIN "D" check this diagram...

3_13_2012_4_09_20_pm.gif

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.


Thank you for using FixYa, have a nice day.

Mar 13, 2012 | Dodge Ram Cars & Trucks

1 Answer

On a 07 dodge ram 1500 hemi, where is the bank 1 sensor 2 (02 sensor) located?


bank one is the cylinder head with number one cylinder and sensor two is the second sensor from the motor.

Dec 03, 2010 | Dodge Ram 1500 Cars & Trucks

4 Answers

Firing order for a 1978 dodge 440


Here is the firing order diagram for that engine.




d59cc15.jpg

Jul 16, 2010 | 1978 Dodge Magnum

1 Answer

What is the firing order for a 2004 dodge durango


The firing order is a sequence of ignition time when the engine cylinders deliver their power-strokes starting with the number-one cylinder. If this sequence is faulty or arranged disorderly, the engine may not start at all, and if it does start, it may does so hesitatingly, or not run enough well to enable it to drive-or simply lacks the power to move. A waste of gas, and unecessary tear and wear on the engine and its critical components ultimately result. Once the firing oder is correc and in proper sequence, the engine should starts easily and promtly, running as quietly as posiible.

For Dodge 2004 Durango firing-order:
All 6-cylinder K 3.7L MFI SOHC distributorless ignition:
1-6-5-4-3-2 (front 2-4-6) (back 1-3-5)

All 8-cylinder N 4.7L SFI (including HEMI 4-WD)
1-8-4-3-6-5-7-2 (front 2.4.6.8) (back 1.3.5.7)
(distributorless ignition)
It is also a good thing to try and compare the thread lenghts of the old spark-plugs being replaced with the new.

Dec 13, 2009 | 2000 Dodge Durango

2 Answers

Need a diagram for fan belt or serpentine belt


Here is a diagram for a 5.7L Hemi, and 1 for a 5.9L diesel. Hope this helps!

9d0184e.jpg 5,7L HEMI
2fbd5d2.jpg
5.9L Diesel

Jun 06, 2009 | 2006 Dodge Ram 3500 Truck

4 Answers

Hemi engine/differential


hemis take 16 plugs every 30k. doesnt matter if its a 5.7 or a 6.1
9.25 axle take 75w140 plus limited slip additive. all others take 75w90 and dont require additive. t-case takes atf+4 should be done at 30k also

Oct 28, 2008 | 2006 Dodge Ram 2500

Not finding what you are looking for?
2007 Chrysler Aspen 4x2 Logo

Related Topics:

402 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8499 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...