Question about 2002 Isuzu Rodeo Sport
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
There is only a pleated paper filter that is not replaceable. The only reason that I know it is there is because I ripped the dash out of one in the junk yard to get at the instrument panel. However, you can't order a replacement, so I think that is was meant to more or less keep large debris out of the system and not actually filter the air.
Hopw this helps ya!
Posted on Mar 19, 2009
Hello, Unfortuanetly the Rodeo does not have a dipstick and you must have a service technician check your transmission fluid by removing bolts on the tranny as if your were going to drain the transmission. I hope this helps you with your problem. A technician should not charge to much to do this for you either.
Posted on May 22, 2009
on petrol V6 engine its right rear side of inlet manifold(left side when looking into engine bay) see pics. below
diesel its on inlet manifold left side middle section of manifold
Posted on Nov 02, 2009
You have to the EGR valve (sometimes the Intake manifold to EGR Vlalve line also). After you remove it take a drill bit the about 20 % smaller than the actual hole of the outlet side and rotate the drill bit with your hand to dig out the carbon. Aditionally the line coming from the intake manifold to the EGR valve will clog near the connection to the EGR valve. I use either a single piece of copper wire or the wire that you would use to tie ribar together to clean the line. When your done cleaning take a piece of vacuum line and connect it to the diaphram side and **** on it... then plug the line well with your thumb. Grasp the valve and blow thru it... Air should blow thru it freely. Remove your thumb from the vacuum line and try blowing again.. No air should pass thru the valve.
Then reinstall the valve and start the vehicle with the vacuum line disconnected (but blocked off) Use another piece of vacuum line connected to the diaphram again and **** on the line.. The vehicle should die or run really bad. If it does this then you cleaned it correctly.
Posted on Jan 20, 2010
Tips for a great answer:
Jan 31, 2017 | 2002 Isuzu Rodeo
Dec 25, 2014 | 2001 Isuzu Rodeo
Mar 30, 2013 | 2002 Isuzu Rodeo Sport
Nov 21, 2010 | 2001 Isuzu Rodeo
May 13, 2010 | 2002 Isuzu Rodeo
Mar 16, 2010 | 2001 Isuzu Rodeo
Mar 14, 2010 | 2002 Isuzu Rodeo
Feb 02, 2010 | 2000 Isuzu Rodeo
Oct 19, 2009 | 2002 Isuzu Rodeo
Mar 24, 2013 | 2002 Isuzu Rodeo Sport
156 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: