Question about 2001 Ford Windstar

Open Question

2001 windstar pcm wiring diagram

Pcm wiring diagram

Posted by Anonymous on


3 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 1305 Answers

SOURCE: need wiring diagram for 2001 ford windstar radio

2001 Ford Windstar Car Stereo Radio Wiring Diagram
Car Radio Constant 12v+ Wire: Green/Violet
Car Radio Switched 12v+ Wire: Yellow/Black
Car Radio Ground Wire: Black/Light Green
Car Radio Illumination Wire: Green
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Front Speakers Size: N/A
Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Orange/Light Green
Left Front Speaker Negative Wire (-): Light Blue/White
Right Front Speaker Positive Wire (+): White/Light Green
Right Front Speaker Negative Wire (-): Dark Green/Orange
Rear Speakers Size: N/A
Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Light Brown/White
Left Rear Speaker Negative Wire (-): Light Brown/Yellow
Right Rear Speaker Positive Wire (+): Light Brown/Green
Right Rear Speaker Negative Wire (-): Brown/Pink

Posted on Sep 12, 2009

  • 8836 Answers

SOURCE: i have a 98 ford windstar that all of a sudden

Hi, if you're talking about fuse "R", it powers most everything on the engine. What you can do is disconnect everything, put a fresh fuse in, and reconnect things one at a time. After reconnecting something, turn the key on to see if the fuse burns. When the fuse burns, the last thing connected has a short. Here are the things that run on fuse R:
EGR solenoid
IAC valve
intake runner solenoid (this one is on the back of the upper manifold)
runner position sensors (only on 3.8 liter engine)
evap purge valve
all 4 oxygen sensors
MAF sensor
all fuel injectors
cam position sensor


Posted on Mar 08, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I need a pcm wiring diagram on 2001 aurora 3.5 in order to check readings at the pcm for an P0335 code

Thought you mite like some additional info.
DTC P0335
Circuit Description
The crankshaft position (CKP) sensor used on this engine is actually 2 sensors within a single housing. There are separate power, ground (reference low) and signal circuits connecting both sensors to the powertrain control module (PCM). The PCM supplies 12 volts to the CKP sensors.
The PCM can use three different modes of decoding crankshaft position. During normal operation, the PCM performs an Angle Based calculation using both signals to determine crankshaft position. The dual sensor allows the engine to run even if one signal is lost. If either signal is lost, the PCM switches to a Time Based method of calculating crankshaft position. If the system is operating in Time A mode, the PCM is using only the signal from sensor A. Time B indicates that the sensor B signal is being used. If the lost signal is restored, the PCM will continue to operate in Time A or B mode for the remainder of the current key cycle. The PCM will automatically revert back to the Angle mode on the next start up if the fault is not present. The scan tool can display the Crank Position Sensing Decode Mode.

Free wiring diagrams here Enter vehicle info . under system click on engine ,then under subsystem click on fuel controls . First off click wiring diagrams not TSB's . Click the search button then the blue link . Scroll down to the third diagram . Good luck

May 22, 2018 | Cars & Trucks

1 Answer

I have a 2001 Ford Windstar I would like to know where the computer is located

2001 Ford Windstar PCM (Powertrain Control Module) is located behind the dash panel on the passenger side. The harness is accessed from under the hood. The PCM is accessible from the floorboard.
You can have it out in less than 15 minutes with minimal effort.

Jan 10, 2018 | Ford Cars & Trucks

1 Answer


yes you can replace PCM with same year model and motor
numbers must match
some online , US Ebay or a wrecker

for less issues
after fitting requires the correct diagnostic tool to link up
air bag, abs ,ignition ,immobilizer and other modules,

in most cases the internal wireing of a manufactures car
PCM is not released to the public

....only replacement PCMs

a full factory repair manual of a lumina
may will have limited wiring diagram



Mar 20, 2017 | Cars & Trucks

1 Answer

How to test my radiator fans on my 2001 mercury cougar myself?

Video's on youtube ! The fans are controlled by the PCM - engine computer . PCM energizes two relays . Find yourself a wiring diagram . Buy a volt meter . Watch a few video's on youtube on basic automotive electrical testing , how to read an use a wiring diagram . Check for B+ voltage at the relays at pin's 30 & 85 . If you pull the relay out of it's socket in the fuse box an look on the bottom you will see four set's of numbers . 30,87 this the load side . Being the fans are the load . 30 should have B+ voltage . 85 & 86 are the control side , one should have B+ voltage an the other the PCM controls by give a ground inside the PCM by a transistor . wiring diagram ! How To Test Relays EricTheCarGuy

Feb 24, 2017 | Mercury Cougar Cars & Trucks

1 Answer

Hi, looking for a ECM wiring diagram on a Chevy Captiva 3.2 2007. Please

Your question is a little broad. Can you tell us the problem? If your having a problem with ignition or fuel system, something like that, I can help with wiring diagrams. If you need voltage and ground for pcm, I can't help with that. Can you narrow the problem down, a little?

To post a diagram of every little wire that comes off the pcm and show where it goes, is too much for me.

Sep 20, 2016 | Chevrolet Captiva Cars & Trucks

2 Answers

Working in a mazda mpv 2001, i cant find the ignition control unit, when i look for the part on ebay they sell the part as: ECU-ECM-PCM, question: is the ignition control unit inside the ECU-ECM-PCM?

It appears from a wiring diagram that there is no ignition control module. The ignition coils' primary circuits are grounded through the PCM. And the wires to the sensors are all from the PCM.

Here is a link if you want to see all your wiring diagrams. I found the above information under System: engine; Subsystem: fuel controls.

Free wiring diagrams and TSB's for every make and model:

Jul 30, 2015 | Mazda MPV Cars & Trucks

1 Answer

I need wiring diagram for the spark plugs on a 2001 ford Windstar V-6;3.8L


Cylinder numbering:

  • Windshield side
    Frt. Of vehicle

Coil numbering:
    • --4 PIN--
      --1--- 2--- 3--
      --5--- 6--- 4--

Feb 12, 2015 | 2001 Ford Windstar

1 Answer

I need a wiring diagram for 2001 ford windstar lx. all of the ones i have found online do not match my van.

Need to know where wire are ford has leads all over for testing .and what kind of trouble you are having.

Nov 22, 2014 | 2001 Ford Windstar LX

Not finding what you are looking for?
2001 Ford Windstar Logo

Related Topics:

285 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

79851 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides