Question about 2008 Chevrolet Impala

Open Question

How to remove the radio 2008 chevy impala ss

Remove radio

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: radio unlock coed for chevy impala

• A module which communicates on the class 2 serial data circuit which supplies VIN information to the radio is replaced and not properly setup with the correct VIN information for that vehicle. The only way to unlock the radio is by using a scan tool.

Posted on May 15, 2009

  • 245 Answers

SOURCE: my power antenna won't go down when i turn off my car or my radio. i have a 1995 chevy impala ss

this is normal the power antenna gets power from the radio and unless the radio is shut off either from powering it down or turning off the car it will stay up. if it is an aftermarket stereo and is staying up when you are on cd's check to make sure that your antenna is hooked to the antenna output on the radio and not the system remote as the system remote is hot any time the radio is powered to run amplifiers.

Posted on May 19, 2009

  • 58 Answers

SOURCE: how do you remove the old car battery on a 2008

  1. Disconnect the negative battery cable.
  2. Remove the right front diagonal brace. The brace goes from the rad support to the fender area.Three bolts need to be removed.
  3. Reposition the positive battery cable terminal cover (1).A red cover over the positive cable at the battery.It pops off.You may need a screw driver to pop it off.
  4. Loosen the positive battery cable terminal nut.
  5. Remove the positive battery cable terminal from the battery.
  6. Reposition the underhood accessory wiring junction block.See steps 9-14.
  7. Remove the battery retainer bolts (1) and retainer (2).
  8. With the aid of an assistant, remove the battery.
  9. Remove the electrical center cover (1).
  10. Disconnect the positive battery cable from junction box
  11. Remove the fasteners (1) securing the electrical center board (2).
  12. Unlock the tabs on the electrical center board.
  13. Lift up on the electrical center board.
  14. Remove the fasteners (1) securing the electrical center bracket (2) to vehicle.

Posted on Nov 01, 2009

  • 1 Answer

SOURCE: How to change the battery in 2008 impala ss

THAT IS THE QUESTION

Posted on Apr 14, 2010

  • 48 Answers

SOURCE: 2008 chevy impala ss acts like it is not getting

It sounds like you could have a plugged catalytic converter. An easy way to check is wait until it is dark out and try to drive up a hill when it boggs down pull off the road and look under the car. If the cat is glowing red hot then it is plugged. Otherwise you can pull the upper O2 sensor and put a compression gauge in and see if there is pressure there when running. If you have more than 2-3 psi then its plugged.

Posted on Jun 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will 235 70r16 tire go on 2008 chevy impala


For the 50th anniversary edition model, P235/50R 18
For the LS model Impala, P225/60R 16
For the LT model with a 3.5 liter engine, P225/60R 16
For the Lt model with a 3.9 liter engine, P225/55R 17
for the SS and LTZ models, P235/50R 18
Source: Goodyear Tire Manufacturer

Feb 19, 2017 | 2003 Chevrolet Impala

1 Answer

Yes my impale have an anti theaft


Chevy Impala 2008 won't crank and won't start, fix found ...

? 1:43
https://www.youtube.com/watch?v=ITvU_vXMrDY
Nov 26, 2012 - Uploaded by Artome001
Chevy Impala, 2008, does not crank or start. ... I have 2008impala ss i turned my car off an tried restart it an all i got was clicking .... How to Override Bypass GM VATS Passlock 1 2 Passkey Anti Theft System - Duration: 11:11.

Engine Starts and Stalls Due to Secutiry System Fault ...

repairpal.com > Problems > Chevrolet > Impala
my Impala also has this problem, the "Security" light comes on, I cannot start it. Ihave to wait ... car wont start due to no fire to the crank sensor and fuel pump.Missing: impale

How Can You Turn Off The Anti Theft Device - CarGurus

www.cargurus.com > Questions > Chevrolet > Malibu

CarGurus

Jan 23, 2016 | Cars & Trucks

1 Answer

I have a 2008 Chevy Impala SS it continues to show service traction control and service Stabilitrak. Any help fixing this problem?


check for codes in the ABS module to start as it controls traction control and I think works with Stabilitrak.

Jul 20, 2015 | 2008 Chevrolet Impala SS

1 Answer

Radio display in 2008 chevy impala doesnt work ?


What usually happens is the battery is dead. You buy a new battery, then you need a radio code for it to work. Drive to the dealership with the car and get the code.

Feb 06, 2015 | 2008 Chevrolet Impala

1 Answer

How to service stabilitrak on my 2008 chevy impala


Service stabilitrack can mean a number of things . When my 08 impala ss stabilitrack light came on it was just a spark plug that was bad

Nov 20, 2012 | Cars & Trucks

1 Answer

How do you remove the old car battery on a 2008 chevy impala ss? (5.3L) thanks sam


  1. Disconnect the negative battery cable.
  2. Remove the right front diagonal brace. The brace goes from the rad support to the fender area.Three bolts need to be removed.
  3. Reposition the positive battery cable terminal cover (1).A red cover over the positive cable at the battery.It pops off.You may need a screw driver to pop it off.
  4. Loosen the positive battery cable terminal nut.
  5. Remove the positive battery cable terminal from the battery.
  6. Reposition the underhood accessory wiring junction block.See steps 9-14.
  7. Remove the battery retainer bolts (1) and retainer (2).
  8. With the aid of an assistant, remove the battery.
  9. Remove the electrical center cover (1).
  10. Disconnect the positive battery cable from junction box
  11. Remove the fasteners (1) securing the electrical center board (2).
  12. Unlock the tabs on the electrical center board.
  13. Lift up on the electrical center board.
  14. Remove the fasteners (1) securing the electrical center bracket (2) to vehicle.

Oct 31, 2009 | 2008 Chevrolet Impala

Not finding what you are looking for?
2008 Chevrolet Impala Logo

Related Topics:

328 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...