Question about Cars & Trucks

Open Question

How do you remove the coil pack on 98 windstar 3.8l

Posted by on

  • JAIME BECHEL Feb 17, 2012

    does it snap off, or is there bolt(s) to remove it?

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 103 Answers

SOURCE: coil pack replacement

better off to replace all 3 as a set

Posted on Jun 20, 2009

Ad
c17hydro
  • 2984 Answers

SOURCE: i may need to cahnge out coil pack. Does 2001 V-6

You have one coil pack for all 6 plugs:

30f050e.jpg

Posted on Jun 28, 2009

  • 1 Answer

SOURCE: have to replace coil pack on 98 ford windstar

take off your breeder tube where your air filter goes and the one that goes into your throttle body you will see your coil pack you will need a 10 mm socket extension and a ratchet very easy be sure to mark your wires as you do not wanna mess up the firing order its very easy

Posted on Oct 30, 2009

MNfisherman
  • 11896 Answers

SOURCE: 98 pontiac trans port don the coil pack should all

All coil packs are attached to ignition module. Then module should have two wires running to Crank Sensor. If there are 3, then one goes to tachometer

Posted on Jan 13, 2010

alicantecoli
  • 22219 Answers

SOURCE: 2001 ford windstar-new coil pack,new spark plugs

head gasket?? blowing between two cylinders

Posted on Mar 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change the distributor cap


If it does have a cap there will be a rotor allso, But i highly dout that there is a distributor in that year of a van, That they use coil packs in it,

Nov 28, 2012 | 1998 Ford Windstar

1 Answer

No spark on 98 ford windstar


check to see if there is a code in the computer this may get you started in the right direction.these have problems with the crank sensors and coil packs causing a no start due to no spark.there have been a few were the computer caused the problem.these types of problems can be noticed with a scan tool hooked up to the computer to see the readings that the computer see`s.

Sep 12, 2011 | 1998 Ford Windstar

1 Answer

How do you install coil pack on 98 camaro v6 3800


#1 disconnect neg. bat cable. #2 unplug both leads from the coil your changing. #3 remove both mounting screws and pull up and remove on it to remove it...reverse to install. be careful when removing the screws they're small and you dont want to drop them. hope this helps.

Apr 29, 2010 | 1998 Chevrolet Camaro

1 Answer

Have to replace coil pack on 98 ford windstar


take off your breeder tube where your air filter goes and the one that goes into your throttle body you will see your coil pack you will need a 10 mm socket extension and a ratchet very easy be sure to mark your wires as you do not wanna mess up the firing order its very easy

Oct 24, 2009 | 1998 Ford Windstar

1 Answer

I have a 98 ford windstar 3.8 with a engine miss and two trouble codes, po401 and 402, would a bad EGR valve cause this problem?


I replaced the coil pack on my friends wind star when they had a mis. If you take the sparkplug wires loose and just set them on the plugs loose it will be easy to remove them with the engine running. Useing plastic plyers or some kind of insulated grabers, one by one take the wire away from the plug/or coil and see if it makes a difference.Take it away then put it back then go to the next one.If it runs the same when the wire is off then you probably will not hear a spark at that wire. The coils do go bad on alot of newer cars.
I hope this info helps you.

Sep 25, 2009 | 1998 Ford Windstar

2 Answers

I have a 98 ford windstar with a 3.8, that has an engine miss and two dtc's po401 and po402, would a bad EGR valve cause this miss?


HI you maybe having this codes and engine missing because of a plug up catalytic converter have it tested at your muffler shop

Sep 25, 2009 | 1998 Ford Windstar

2 Answers

I may need to cahnge out coil pack. Does 2001 V-6


You have one coil pack for all 6 plugs:

30f050e.jpg

Jun 28, 2009 | 2001 Ford Windstar

1 Answer

HOW TO INSTALL FORD WINDSTAR COIL PACK AND SPEED SENSOR


the coil pack is on the back off the mtr . i remove the wiper arms and remove cowl cover the wiper mtr will come with cowl cover. once you have done that the coil pack is easy to get to. there are two speed sensors input and output one will be right side tail shaft

Jan 08, 2009 | 1996 Ford Windstar

1 Answer

Engine light on my 1999 windstar is blinking


the windstars are very bad for cracked ignition coils, to check you have to remove the coil, remove spark plug wires from coil, disconnect main harness from coil and remove the 3 7mm bolts that hold it in place, once it is out inspect it for cracks, if it is the coil expect to pay around $105 for a new one from your Ford dealer

Sep 25, 2008 | 1999 Ford Windstar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...