Question about 2010 Chevrolet Camaro

Open Question

How to reprogram the metra dash kit for the 2010 camaro because the steering weel controls dont work anymore

Posted by on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

gazzzz42
  • 63 Answers

SOURCE: my 2005 uplander air bag light is on and my switches dont want to work on the steering weel

electrical check bumper sensor

Posted on Nov 01, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 91 jetta 1.8 l and the steering weel is loose and we have tryd to change the ignition but now we ar stuck the steering wheel doesnt want to fit anymore what can i do


Hi. I work on cars and motorcycles all the time. I can try to help you...Can you explain further? What where you working on? what did you remove?
What exactly do you mean the steering wheel is loose? Are you talking about the steering colum?

Sep 05, 2016 | 1991 Volkswagen Jetta

Tip

ALARM, CRUISE CONTROL, and STEREO Wiring Color Codes for 1993 Honda Civic This...


ALARM, CRUISE CONTROL, and STEREO Wiring Color Codes for 1993 Honda Civic

This FixYa Tip is for the purpose of installing an Alarm, Remote Starter, Cruise Control, and / or Car Stereo into the vehicle listed in the subject line.

The wires listed are the ones you will need to successfully complete the task.

Some vehicles require additional relays and / or modules to bypass factory security. If they are required - it will be in the NOTES section below the wiring colors.

The following FixYa TIP is good for all Honda Civics for the following production years:
1993


STEREO WIRING COLOR CHART:
Constant 12V+: White/Blue
Switched 12V+: Yellow/Red
Ground: Black
Illumination: Red/Black
Dimmer: n/a
Antenna: Driver's Pillar

Front Speakers:
Left Front (+) Blue/Green
Left Front (-) Gray/Black
Right Front (+) Red/Green
Right Front (-) Brown/Black

Rear Speakers:
Left Rear (+) Blue/Yellow
Left Rear (-) Gray/White
Right Rear (+) Red/Yellow
Right Rear (-) Brown/White

NOTES: - none -
Additional Accessories:
Metra Brand Dash Kit: n/a
Metra Brand Wiring Harness: 70-1720
Metra Brand Antenna Adapter: n/a




ALARM / REMOTE START WIRING CHART:
Constant 12V+: White - Ignition Switch Harness
Starter: Black/White - Ignition Switch Harness
Ignition: Black/Yellow - Ignition Switch Harness
Accessory: Yellow - Ignition Switch Harness
Tach: Blue - Distributor
Brake Switch: Green/White - Brake Switch
Trunk Pin: Green/Black - (-) Above Fuse Panel (Blue Connector)
Parking Lights: Red/Black - (+) Above Fus Panel (White Connector)
Head Lamp: Red/White - Steering Column
Hood Pin: n/a
Factory Disarm: Disarms with Unlock
Door Trigger: Green/Red - (-) Driver's Running board
Door Lock: Green/White - (-) Driver's Door at Door Lock Module
Door Unlock: Green/Red - (-) Driver's Door at Door Lock Module
Horn: Blue/Red - Steering Column (Relay Required)
Windows UP: LF=Red/Blue RF=Orange/White

NOTES: - none -



CRUISE CONTROL:
Constant 12V+: White - Ignition Switch Harness or Use Hot Side of Brake
Switched 12V+: Black/Yellow - Ignition Switch Harness
Ground: Use Chassis Near Cruise Control Module
Hot Side of Brake: n/a - Brake Switch
Cold Side of Brake: Green/White - Brake Switch
Tach: Blue - Distributor
VSS Wire : Yellow/Blue - Driver's Side Dash Footwell, Grey connector.


NOTES: 4000PPM
Vehicles with Manual Transmission require Clutch Switch.
Some vehicles may require a speed signal generator and/or other parts/adapters not listed above.
Rostra® Cruise Control module switch settings may differ if you use a speed signal generator or magnets and a pick up coil.

Thanks for using FixYa!! Please see my other tips on GPS, Car Audio, Large Appliances, and more.

on Apr 01, 2010 | Honda Civic Cars & Trucks

1 Answer

BCM location 2012 camaro ss


It is located behind the dash , I believe behind the radio. I have a 2010 and the models haven't changed that much. Through the years the bcm has always been located somewhere between the glove box and console by the radio. DO NOT DISCONNECT IT WITHOUT KNOWING WHAT YOU ARE DOING. They are flashed with codes and data that are specific to that car. If you remove it without reprogramming, your car is dead in the water and only an authorized dearler can reflash it . Doing it any other way will kill it.

Jan 23, 2015 | 2012 Chevrolet Camaro

1 Answer

I have Lexus gs450h 2010 with trouble code c1555 and steering wheel is hard to turn I already replaced steering ecu after calibrating work fine but for only 20 minutes and was unable to clear the same code...


The ECU wasn't bad. The power steering unit is. The ECU compensated for the bad unit, until it wouldn't take it anymore. Replace the steering unit under the dash. Just a note though. I would do a wiring diagnostic first, to make sure all the wires are good.

Dec 07, 2014 | Cars & Trucks

1 Answer

How do i replace my stock radio for a after market radio in a 1995 lexus sc400


There are several steps:
1. Take out the center cup-holder (it pops out with a little tug upward). unscrew the 2 screws.

2. On the shifter (lower part) there is a cover that covers 2 screws, unscrew and remove the shifter knob.

3.Take a pick tool and lift the shifter bezel console (black) it also pops up.. there are 3 or 4 connecters (disconnect with a small flat head screwdriver)

4. Once the shift cover is removed, there are several screws and tabs holding the bezel trim down unscrew the screws and lift bezel trim up,

5. Disconnect the ash-tray (blue connector)

6. Disconnect the hazard signal control , volume control connector and the climate control connector.( On the left side)

7. There are 4 screws holding the the radio and climate unit cage to the dash frame. (unscrew)

8. Now it gets a little tight, pull the unit towards you slightly and disconnect to connectors for the climate control unit (on top) and the factroy radio (on the bottom).

9. Next remove the radio and climate control unit from the cage(screws on the sides).

10. Next you will need a new cage: Metra 95-8157B Double DIN Installation Kit for 1992-2000 Lexus SC300 and SC400 (Black)
by Metra Link: http://amzn.com/B001TJG7SA

11. You will need the following harness: Metra 70-8112 Radio Wiring Harness for Toyota Amp Integration 15 Pin by Metra
Link: http://amzn.com/B0002BEUBW and/or Metra 70-1761 Radio Wiring Harness For Toyota 87-Up Power 4 Speaker by Metra Link: http://amzn.com/B0002BEQJ8

12. Match the wires according to the metra kit and new radio instructions.

13. Next follow instructions in reverse for re-stall. GL.

Feb 09, 2014 | 1995 Lexus Sc 400

1 Answer

2010 camaro ss window washer pump not working


this circuit grounds in the steering column by the switch that activates it..did you test the pumpitself? if not you can with a jumper to the motor on the washer tank..see if the pump works use a battery charger so you dont burn up wires..unless you are comfortable that way..good luck..

Jan 19, 2013 | Chevrolet Camaro Cars & Trucks

1 Answer

Aftermarket double din install having problems with int. dash lights,locks


I had soved my problem... That was stupid.. The cause is that I tried to connect the (illumination +) and the (illumination -) wires togetter on the dimmer wire of my double din unit. That make a short cut and blow the litening fuse (fuse 13 on passenger side fuse panel). I replaced correctly the wiring, keeping the (illumination +) wire unused. That solve my problem but, however I get back my dash illumination, I can't adjust the lightning level... I thing I have a problem with the level switch.. It don't matter to me but if you get the same problem and solve it, please tell me your solution.

Regards

jerome

Jun 02, 2009 | 2001 Acura 3.2CL

1 Answer

Remote key lock stopped working after wal mart put new battery in and now my head lights stopped workin!!!


check fuse for low beam, then possibly both low beam globes. they could have blown.
the key remote may need reprograming into system try put key in ignition in on position then press remote buttons a couple of times then try if no good need to go to dealer to be programed into system again or it needs repairing/replacing.

May 31, 2009 | 1996 Chevrolet Camaro

1 Answer

98 Camaro Headlights wont work


Dash lights were falsing ? I assume you mean pulsing .
driving lights come on ? daytime running lights or park lamps ,does the vehicle have daytime running lamps . Daytime running lamps module .
Daytime Running Lamps (DRL) Module (Headlamp Auto Control Module)
Mounted behind the radio and the HVAC control, left of the instrument panel compartment.

Jun 17, 2017 | 1998 Chevrolet Camaro

1 Answer

I NEED TO FIND A DASH KIT FOR AN AFTERMARKET HEAD UNIT!!!!!!


I found the dash kit on amazon.com The product name and number is the Metra Electronics Corp. - 99-8156. I still am not sure how to use the power seat controls. Please help me.

C

Sep 05, 2008 | 1994 Lexus LS 400

Not finding what you are looking for?
2010 Chevrolet Camaro Logo

Related Topics:

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...