Question about Cars & Trucks

Open Question

Does the suzuki swift 2008 have a self adjusting clutch

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
leetamara
  • 702 Answers

SOURCE: 2000 Suzuki Swift Clutch Question

A clutch cable doesn't take much to install. Who told you $600.00?? You don't have to take the trans. loose to do this. All you do is unhook the cable from pedal and unhook if from the trans. This job should only take you an hour if you've never done it before. How long has the clutch been in your car?

Posted on Jun 13, 2008

Ad
litoshop
  • 298 Answers

SOURCE: How to replace the clutch

you have to pull the tranny back and you'll see the clutch and pressure plate and the trow out bearing would be on the tranny useing the right tools it could be easy

Posted on Jul 11, 2009

  • 57 Answers

SOURCE: clutch self adjuster on a k reg escort van

the self adjust mechanism is made up of two pieces a pawl and ratchet. removing them is more awkward than difficult. you need to remove the clutch pedal by knocking out the pivot shaft that also supports the brake pedal just knock it out far enough to remove the clutch pedal after removing the clip. when the pedal is out you will see how it is assembled. the hardest part of the job is replacing the spring which is attached to the pedal this must be hooked back into the pedal last i find a strong piece of wire threaded through the hole in the pedal does the trick this is a job for someone who has some experience good luck

Posted on Aug 29, 2009

jeffbvegas1
  • 520 Answers

SOURCE: hi i need to change clutch on a 1993 suzuki

remove transmission and insure to have proper clutch plate alignment tool upon re-assembly...this makes installing trans into new components possible

Posted on Sep 27, 2009

  • 543 Answers

SOURCE: i bought a brand new 2007 suzuki swift,it has only.2007 SWIFT

i would say its wear and tear,you can kill a clutch in a day if your hard on it,,,or it could take 150,000 miles,,suzuki will classify that as a wear and tear item,,they are really tight with that stuff,

Posted on Oct 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replace ball joint Suzuki swift 2008


what country>?????? 1.3 gas or diesel?
so what is the question
what is the procedures, (its in the FSM and at alldata.com read it)
or who can
or how makes the best joints.
or do i need special tools
or or or..???
ask a real question
here : eg:2
I want to DIY my ball joints, where are the instructions.
read gen 2 swift here.
which one you have and made where.>????
Hungary, India, Japan, Pakistan and by Chang'an Motors in China


http://en.wikipedia.org/wiki/Suzuki_Swift

id not guess, all 5 cars are all the same body parts.
not me....
Maruti introduced the Swift with a Fiat-sourced 1.3 L DDiS engine

OR USA SWIFT USES THIS.
you remove the snap ring and press it out.
that can take , a very powerful press. and the obvious implications of that.


1778d39c-1451-490f-9b49-8d3920505930.jpg

Jul 08, 2014 | 2007 Suzuki Swift 1.3

1 Answer

1991 Suzuki Swift GTi very low idle and stalling


Oxigen sensor. Check accelerator pot also, and fuel pump.

Jan 13, 2013 | 1991 Suzuki Swift

1 Answer

How i can adjust clutch pedal of suzuki swift 2006 is there any adjustment for clutch pedal ,?


unfortunately no .... but I think you can add a Sporty Pad ,,, Which is available in most Moto shops ... If your Problem just is to increase height ...
Please Rate My answer well and Support me !!!

Nov 22, 2010 | 2005 Suzuki Swift

1 Answer

If I use the shift lock release to much will I damage my car?? I have a 2008 Suzuki Swift


No you will not damage your car. Repair usually involves replacing or adjusting the brake light switch, neutral safety switch, fuse, or shift lock solenoid.

However, people have broken the release button by overuse.

Nov 04, 2010 | Suzuki Swift Cars & Trucks

1 Answer

How to adjust clutch pedal nearly fully released before engaging


It's probably a hydrolic clutch and on those there is no adjustment you'll probably just have to bleed the clutch. There is a bleeder screw similar to one for disc brakes on the top or side of the clutch slave cylinder.

Feb 04, 2010 | 2005 Suzuki Swift

1 Answer

I need the vavle clearance on a 1995 suzuki swift


Hi, the Suzuki Swift 1.0 has hydraulic lifters (no adjustment needed). The 1.3: Inlet - 0.23 - .027 hot and Exhaust - 0.26 - 0.30 hot. The 1.3 GTI has hydraulic lifters (no adjustment needed)

Nov 04, 2009 | 1995 Suzuki Swift

1 Answer

I bought a brand new 2007 suzuki swift,it has only.2007 SWIFT


i would say its wear and tear,you can kill a clutch in a day if your hard on it,,,or it could take 150,000 miles,,suzuki will classify that as a wear and tear item,,they are really tight with that stuff,

Oct 08, 2009 | 2006 Suzuki Swift

1 Answer

How to replace the clutch of my 1984 Suzuki Swift


you have to pull the tranny back and you'll see the clutch and pressure plate and the trow out bearing would be on the tranny useing the right tools it could be easy

Jul 11, 2009 | 1989 Suzuki Swift

1 Answer

My daughters 2003 Suzuki Swift is not shifting right when it is really cold outside. When it is warm it is not too bad. It is not engaging all the way. It is cold here now so it is doing it all the time.


I recently had the same problem with my 2000 Swift. After having the transmission rebuilt the mechanic said he had adjusted the clutch cable and instaled a different spring on the clutch to compensate for the cold making parts stiff. I haven't noticed the same problem since.

Jan 29, 2009 | 2000 Suzuki Swift

1 Answer

2000 Suzuki Swift Clutch Question


A clutch cable doesn't take much to install. Who told you $600.00?? You don't have to take the trans. loose to do this. All you do is unhook the cable from pedal and unhook if from the trans. This job should only take you an hour if you've never done it before. How long has the clutch been in your car?

Jun 13, 2008 | 2001 Suzuki Swift

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...