Question about 1995 Ford Explorer
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
ok then here is the procedure
1 take off the axle nut
2 on the lower control arm you will find a large nut and bolt i belive the nut is a 21mm and the bolt side is an 18mm. this bolt is the one at the knuckle near the brakes. remove it
3 you will need to pull the knuckle out of the way or a helper to pull the knuckle out of the way so you can slip the axle out of the knuckle.( its a tight fit but there is room to slip it out.)
4 use a pry bar to pop the axle free of the diff. hosing its held in by a spring clip make sure the clip comes out with the axle if it gets stuck inside you will have to fish it out.
5 use a pry bar or screwdriver to pry seal out of housing then use a flat object that contacts the entire rim of the new seal so it can evenly be installed with out getting smashed and tap it in with a hammer. ( a good trick here is to use some grease and pack it into the new seal where the spring is this will prevent the spring from being shocked out of the seal during instalation . the spring keeps tension on the rubber in the seal so it stays tight to the shaft it is sealing.)
6 then revers the above steps. also make sure you are using the right gear lube it will most likely be 75w-140 but make sure you check your owners manual will tell you if it doesnt say on the diff cover. you can cause a lot of damage if you put in the wrong thing. and make sure you feel the axle spring clip snap into place.
as a note there are two types of axle seals that are used on these so if the new seal looks different than the old seal then the folliowing will be important to you.the seals on these have been redesigned so if you axle has what looks like a cup or dust cover pressed onto the shaft where it goes into the diff the new style does not use this and it will prevent the axle form going in all the way so the spring clip will not lock in and you will have a leak. so you will have to remove it and install the axle without it.
Posted on Mar 22, 2009
chances are that if the car is that important to you ,, your just going to have to do this one that hard way . by droppong the trans .
Posted on Oct 25, 2009
Tips for a great answer:
Mar 02, 2017 | 2004 Ford Explorer Sport Trac
Sep 23, 2012 | 2004 Ford Explorer Sport Trac
Jun 29, 2011 | Ford Explorer Sport Trac Cars & Trucks
Jun 02, 2011 | Ford F-150 Cars & Trucks
Mar 30, 2011 | 1996 Ford Explorer
Feb 26, 2011 | 2000 Ford Explorer
Feb 23, 2011 | 2002 Ford Explorer
Mar 14, 2010 | Ford Explorer Cars & Trucks
May 18, 2009 | 2001 Ford Expedition
Mar 21, 2009 | 1993 Ford Explorer Limited
716 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: