Question about Cars & Trucks

Open Question

I need to locate the Turbine Speed Sensor on 2006 Maxima

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 373 Answers

SOURCE: Speed Sensor

HI..
The Speed sensor on your Honda Accord 97.
Is located on the Transmission.
If you follow the Lower Radiator hose from the rad to the engine.
The hose end on the Thermostat housing.
OK.. Just on direction of the thermostat housing .
Under the housing you Will see on the transmission the Speed sensor, with a connector of 3 wires. Is the only sensor at this
Part of the Transmission..

Ok. I hope this work on your question.
Thank you for use fixya..

Posted on Sep 09, 2008

  • 316 Answers

SOURCE: input/turbine speed sensor circuit

Your speed sensor, is located on top of the transaxle, near the starter. To access it, remove the battery, then remove the battery tray (4 10mm bolts). You will see wires coming from the lower oxygen sensor, and they snap into the bracket that holds the speed sensor in place. The actual speed sensor has a 2 wire clip on it, and is held in place by the bracket and a 10mm bolt.

Posted on Apr 20, 2009

  • 1 Answer

SOURCE: I have a code p0715, which is the input turbine speed sensor

Have the same problem with the input speed sensor. The part, so far, is only made by Mitsubishi (Part No. 8651A111) and cost about $110 (w/ tax in TX).

Posted on Oct 07, 2009

  • 162 Answers

SOURCE: how do I locate the turbine speed sensor on a ford

its on the front of the transmission below the coil it compares the input shaft/turbine speed against the speed of the output sensor it is checking to see how much slip or diffrenece in shaft speeds the only time the two shafts are spinning at the same time is when torque converter is in lockup

get this sensor from ford dealer for a little more than $100 bucks

Part number F32Z7F040A

Posted on Apr 08, 2010

  • 1 Answer

SOURCE: Speed sensor location on a Nissan Maxima 2000 GXE...

There are two speed sensors one is called a revolution sensor that is located on the case of the transmission. You can take the driver side wheel off and see the sensor on the top of the case of the transmission. A 10mm bolt is holding it in. Easy fix

Posted on Jun 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Jeep wrangler 2006 6 speed std transmition, where is the speed sensor located can you pls provide a diagram, thank you.


as there are 2 speed sensors located in a transmission, you have to be specific
there is a TSS for turbine speed and a VSS for the output shaft /road speed
post again all the information and the question

Sep 22, 2016 | 2006 Jeep Wrangler

1 Answer

VEHICLE SPEED SENSOR LOCATION


  1. REMOVE BATTERY
  2. REMOVE AIR CLEANER ASSEMBLY
  3. DISCONNECT INPUT TURBINE SPEED SENSOR CONNECTOR
  4. REMOVE INPUT TURBINE SPEED SENSOR
Check attached drawing.

26068087-aeck0jymi5oleu25hgksiiwr-4-0.gif

Jan 25, 2016 | Lexus RX 300 Cars & Trucks

1 Answer

Input turbine speed sensor location


Hi Mario, I may be behind times, but believe the sensors you're referring to are the turbine pressure sensors. There are usually two, mounted onto he turbo inter-cooler. Regards John.

Apr 21, 2014 | 2002 Honda Odyssey

1 Answer

I have a P0715 code problem , where is the tubine speed sensor


The Turbine Revolution Sensor is on top of your Transmission with an electrical line on the underside, located directly beneath the front passenger seat.

Sep 12, 2012 | 2006 Nissan Murano

1 Answer

I need to locate the vehicle speed sensor on 2006 4 cylinder Nissan ALtima


if its a po725 code its engine speed fault ,replace crank sensor.for vehicle speed there are two identical sensors near each other on trans....one called revolution sensor other is called turbine speed sensor.

Feb 05, 2011 | 2006 Nissan Altima

1 Answer

Where is the input/turbine speed sensor on a 2006 buick rendezvous 3.5 v6?


I t is the valvebody which is located inside the side cover on the drivers side of the transaxle, this is not a diy job.

Nov 11, 2010 | 2006 Buick Rendezvous

2 Answers

I HAVE A 2006 FORD FIVE HUNDRED AND A CODE P715 COME UP WHAT DOES THAT CODE MEAN


The P0715 tells you TCM detected a loss of TSS signal during operation. Insufficient input from the turbine shaft speed sensor.

Sep 22, 2010 | Ford Five Hundred Cars & Trucks

2 Answers

2000 windstar transmission code 715 turbine speed sensor need to replace, where is it and should I do it.


turbine speed sensor is the torque converter speed ,but where and how it works i do not know,i would buy a manual vehicle nyself at least it doesnt cost the earth when the clutch wears out

Jul 16, 2010 | 2000 Ford Windstar

3 Answers

Speed sensor location on a Nissan Maxima 2000 gxe


There are two speed sensors one is called a revolution sensor that is located on the case of the transmission. You can take the driver side wheel off and see the sensor on the top of the case of the transmission. A 10mm bolt is holding it in. Easy fix

May 20, 2010 | 2000 Nissan Maxima

1 Answer

Input/turbine speed sensor circuit


Your speed sensor, is located on top of the transaxle, near the starter. To access it, remove the battery, then remove the battery tray (4 10mm bolts). You will see wires coming from the lower oxygen sensor, and they snap into the bracket that holds the speed sensor in place. The actual speed sensor has a 2 wire clip on it, and is held in place by the bracket and a 10mm bolt.

Apr 19, 2009 | 1997 Ford Escort

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...