Question about Cars & Trucks

Open Question

How do I replace brake pads on skoda octavia 2007

Posted by Anonymous on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

agent91
  • 2100 Answers

SOURCE: front brake pads 2005 Skoda Octavia 1.9td

I have no idea what a skoda octavia is, but I know brakes are brakes. You have 2 bolts holding the pads in a slide, the bolts have threads only at the top, the rest is the slide, pull those bolts, if that doesn't release the slide, take out the 2 bolts holding the caliper on there, pull the slide out the other way. replace the pads, make sure they go back in the way came out. Put the bolts back on, tighten them up, you should be all set. The pad thickness sensor is just a ground, when the wire hits metal, it turns on a light, It should go off when it is not touching anything. You should have squealers on there too, they give an audible screech telling you it is time for some new pads. Hope this helps.

Posted on Apr 26, 2010

TDISLine
  • 1874 Answers

SOURCE: where is the oil filter located on the skoda

See picture below:

d824e4b.jpg

Posted on Aug 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why would the epc light come on skoda octavia 1.4 petrol and some time fail to start


first check the rear brake light if its working when apply brake if not replace rear brake light s.w .

Sep 04, 2014 | 2002 Skoda Octavia

1 Answer

Why would a skoda octavia epc light come on


dear please , check the rear brake light if its working when apply brake ,if not working ,epc light come , so replace rear brake light s.w

Sep 04, 2014 | 2002 Skoda Octavia

1 Answer

Why does my Skoda diesel engine 140 hesitate occasionally mainly at low revs?. This only started to happen after the cambelt has been replaced


Depending on the climate, you may need to try a different fuel supplier, could also be the fuel filter, if not already done.

Aug 08, 2014 | 2007 Skoda Octavia 2.0

1 Answer

When scanned it reads torque converter lock up clutch , , when engine is cold and try the back gear the Skoda Octavia 2007 AT stalls with a big ****, like it does not have a clutch, when i warm it for


dear . start engine then shift revers gear , apply brake then refill ATF more till its full , then shift at P . road test , check how , all problem
ATF was low level

Apr 08, 2014 | 2007 Skoda Octavia 1.9

1 Answer

Where are the Brake sensors on 2007 Toyota RAV4


there are 4 sensor for wheel speed ,direct to wheel bearing this when ABS light comes on , there are 4 sensor at brake pads
for brake pads level ,it wil indicate when brake pads is near to finish
you must replace brake pads

Apr 07, 2014 | 2008 Skoda Octavia 1.9

1 Answer

Location of oil filter in Skoda Octavia 2006 1.9 diesel


Octavia (a4 ) remove top engine cover the engine oil filter is at front cover, big black plastic cover remove with special tool the oil filter can be remove and replace with plastic ring

Nov 21, 2013 | 2006 Skoda Octavia 1.9

1 Answer

Problem with Skoda Octavia Engine management light


Sounds like faulty coil. Check this on a diagnostic machine at a garage and you will get the answer.

Oct 21, 2013 | Skoda Octavia Cars & Trucks

1 Answer

How to remove the air from the clatch system of skoda octavia estate 1.6 2005


most of the clutch hidraulic systems do not have purge valbe for air when I have that problem i follow the same steps of the brakes system and when the fluid is presurised I losse the bottom endon the clutch cylinder a few time untill no bubbles come out and that work for me very good.

Sep 01, 2012 | 2005 Skoda Octavia 1.6

1 Answer

Front brake pads 2005 Skoda Octavia 1.9td


I have no idea what a skoda octavia is, but I know brakes are brakes. You have 2 bolts holding the pads in a slide, the bolts have threads only at the top, the rest is the slide, pull those bolts, if that doesn't release the slide, take out the 2 bolts holding the caliper on there, pull the slide out the other way. replace the pads, make sure they go back in the way came out. Put the bolts back on, tighten them up, you should be all set. The pad thickness sensor is just a ground, when the wire hits metal, it turns on a light, It should go off when it is not touching anything. You should have squealers on there too, they give an audible screech telling you it is time for some new pads. Hope this helps.

Apr 26, 2010 | 2005 Volkswagen Passat

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

337 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...