Question about 2008 Dodge Avenger

1 Answer

Will not crank but light comes on.. - 2008 Dodge Avenger

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 5,763 Answers

First try to jump start and see what happens, some of these will light up but not crank due to low voltage, if jumping it doesnt work then i would have a look at the starter. have someone hold key in the start postion while you tap on the starter and see if that helps and if car starts then the starter may be bad.

Posted on Feb 17, 2012

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does check engine light come back on after replacing crank sensor


The check engine light is still on because the fault identified by the computer was not caused by a failed crank position sensor.

Mar 01, 2016 | 2005 Chrysler PT Cruiser

1 Answer

94 cutlass ciera s won't crank


It could be a near-dead battery. Sometimes they have enough power for lights/etc. but not enough to crank.

Apr 01, 2013 | 1994 Oldsmobile Cutlass Ciera

1 Answer

Engine light is on and sometimes my car will not crank, sometimes does a little spudder


Have your alternator tested. tune up afterwards would not be a bad idea

Jan 08, 2013 | 2006 Chrysler PT Cruiser

1 Answer

Cranks, but won't start


Could be the crank sensor is bad but If the check engine light does NOT come on when cranking at the times when it won't start, then your ECU is in need of repair. The engine will only start after the check engine light comes on and the ecu is what controls that. It's likely going bad, causing the delayed start problem typical of early 90's jeeps. Repair or replacement services for your jeep ECU are available on ebay.

Aug 01, 2012 | 1995 Jeep Grand Cherokee

1 Answer

Truck will crank but it won't fire.


My guess would be the key switch.

Jul 08, 2012 | 1997 Chevrolet S-10 Pickup

2 Answers

95 chevy lumina cranks but wont start, no spark, replaced the crank senser, no luck


Are there any lights on the dash when this happens? When you put key in and try to crank it over, does the securty light come on?

Apr 10, 2011 | 1995 Chevrolet Lumina

1 Answer

Cranks over but will not start


Look at your dash to see if the check engine light is lighting up when you turn the ignition on, before cranking. If it's not lighting up, your ecu might need to be repaired. Also, try leaving the ignition on for a while, about 30 minutes, to see if your check engine light does finally come on. The jeep should start if that light comes on. Could also be your crank sensor is bad.

Feb 22, 2011 | 1994 Jeep Grand Cherokee

1 Answer

1996 jeep grand cherokee 5.2L v8 is cranking but wont start doesnt look like its getting a spark


Might be your jeep's ecu is bad. Does the check engine light come on your dash, when you turn the ignition key to on, before cranking? If not, the ecu is bad. If the check engine light does come on, it may be the crank sensor is bad on your jeep.

Feb 08, 2011 | 1996 Jeep Grand Cherokee

1 Answer

The vehicles power is not working in our pontiac sunfire. We have tried a new battery, but no go. What could be the possible problems?


what is getting power and whats not? headlights work? horn? turn ignition switch on. lights on dash light up? crank car, cranks? no crank? cranks but wont run? ck eng light comes on when key on? clicks when turning ket to crank?

Jun 04, 2010 | 1999 Pontiac Sunfire

1 Answer

1999 Continental will not start


Does anti-theft light come on for a sec then turn off when you turn on the key or does it flash with key on?
You said that CEL turns off while cranking,does it come back on if you continue to crank after about 8-10 seconds of cranking?
If it does not then your PCM is not seeing a signal from the crankshaft postion sensor.You can try wiggling the harness at the crankshaft postion sensor and see if it will start.

Jan 31, 2009 | 1999 Lincoln Continental

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...