Question about Cars & Trucks
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
remove the door panel. be very careful and make sure you get all the screws out. Should be maybe 2 on the bottom half of the door, and 2 on the top half. one is right by the handle, which is the one i forgot the first time i took my door pannel off. carefully pull the panel upward, and outward at the same time. Once the panel is off, disconnect the controls, and remove the light from the panel. Remove the plastic cover very carefully, it will tear, just keeps noise, and air, and the elements out.
There will be 3 screws, they are torx bolts, once you pull those 3 out. They are located middle of the door towards the right side. The motor will drop down a little bit. disconnect the wires for the motor, and wiggle the motor off of the regulator. the crown vics have a decent size hole to get into the door panel, you can also remove the speaker if that would help you do it. other than that, it just lining up the new motor into the car, pushing it into the regulator, and putting the 3 bolts in, make sure they are snug, and not cross threaded. put everything back together, and your set.
Posted on Mar 19, 2009
First make an appointment for a front end alignment which will be required after replacing the ball joint. Securely support the vehicle under the lower control arm at the outer end, the end nearest the tire. The upper ball joint is attached to the upper control arm with 2 large nuts. Under the nuts are cams with hex heads for adjusting caster and camber. Mark the position of these cams in a way that will allow you to reinstall them somewhere near the same position. Next remove the outer end of the joint from the steering knuckle an then remove the 2 nuts and both cams from the control arm end. Reinstall and get that alignment asap !
Posted on Oct 05, 2009
Push the trim away from the back of the light—1992-98 Crown Victoria
The rear tailamp assembly is held by various fasteners
Remove the wing nuts retaining the light assembly to the lower back panel—1992-98 Crown Victoria
Remove the nut retaining the light assembly from the side of the luggage compartment
Pull the light assembly away from the vehicle—1992-98 Crown Victoria
Posted on Oct 12, 2009
Testimonial: "I was thinking I would get to the bulbs from inside the trunk. This info makes perfect sense. Thanks"
FORD CROWN VICTORIA - V8 4.6L 281ci CNG FI N 9
2002 FORD CROWN VICTORIA - V8 4.6L 281ci GAS FI N W
Belt Routing Diagram - Multiple Accessory
Hope helped (remember rated this).
Posted on May 26, 2010
Tips for a great answer:
Feb 11, 2013 | 2005 Ford Crown Victoria
Feb 17, 2012 | Cars & Trucks
May 26, 2010 | 2002 Ford Crown Victoria
Oct 12, 2009 | 1997 Ford Crown Victoria
Sep 20, 2009 | 1994 Ford Crown Victoria
Jun 19, 2009 | 2002 Ford Crown Victoria
Apr 06, 2009 | 2002 Ford Crown Victoria
Feb 12, 2009 | 1994 Ford Crown Victoria
Jan 17, 2009 | 1994 Ford Crown Victoria
Jan 05, 2009 | 2002 Ford Crown Victoria
May 25, 2018 | Mercury Cars & Trucks
22 people viewed this question
Usually answered in minutes!