Question about 1999 Isuzu Trooper

Open Question

1995 Isuzu Bighorn Lotus EFI Engine

I have just had the engine in this truck replaced as the last one overheated, I just picked it up from the garage yesterday and I have noticed that the wee sign on the dashboard that indicates that the truck is in 4WD stays on, I have tried to put it in and out of 4WD but the light wont go out The truck isnt actually in 4WD but the light stays on. Could this just be because a wire or something has been left off during the engine replacement or is it something worse, should I carry on driving or not, I cannot contact the garage who replaced the engine as they are closed for the next couple of days. your help on this would be very much appreciated. many thanks.

Posted by on

6 Suggested Answers

alicantecoli
  • 21949 Answers

SOURCE: 1195 Isuzu bighorn radio wiring.

remove the radio first and use a fitting kit ..easy

Posted on Nov 15, 2008

  • 31 Answers

SOURCE: Loud clicking noise when 4wd is engaged on left wheel when turnin

Check your cv (constant velocity joint) , It may have a big clearance which is the source of the noise when turning left or right and when 4wd is engage. Juts like front wheel drive cars, if the cv joint is with clearance it will tend to sound in the left or right turns. It is not exactly clicking sound , nmore like knocking sound , low in pitch, but not heavy.

Posted on Dec 10, 2008

honeymokey
  • 3113 Answers

SOURCE: 2004 Isuzu Rodeo 3.5ltr 4X4 hesitation/misfire acceleration

The upper intake gaskets may be leaking. They are made of plastic and metal and will leak air. Do not remove the cover on very top of manifold when changing.

Posted on Jul 24, 2009

simontricket
  • 235 Answers

SOURCE: Isuzu bighorn diesel 4jg2 engine timing diagram

http://www.jeepolog.com/UserFiles/downloads/trooper_manual.pdf

This site has it .

Posted on Aug 25, 2009

  • 162 Answers

SOURCE: Isuzu bighorn automatic transmission slips after heating

Change your gearbox oil, and clean out the oil strainer.
Should help.

( On some models, you have to remove the gearbox oil pan to clean the strainer )

Posted on Nov 01, 2009

  • 123 Answers

SOURCE: Wandering steering on Isuzu Bighorn

If the steering gear box has play in it (make sure to check it with the engine running so it has power assist) then it is time to get a new one.Have someone wiggle the wheel back and forth while looking at the steering linkage (tie rods, pitman arm etc..) If there isn't any play/looseness in the linkage and the ball joints are good you need to get the alignment checked. You may have too much negative caster as that will cause steering wander.

Posted on Nov 18, 2009

Testimonial: "Great.I hadn't even thought of the allignment.Thanks for your help."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Necesito el diagrama del cicuito electrico de un motor isuzu 4jg2, del 2004, de una isuzu Bighorn, donde lo puedo conseguir


spanish on English forum? really?
I need circuit electrical diagram of a 4JG2 Isuzu engine, 2004, an Isuzu Bighorn , where I can get it.
what country? we cant guess that, and i guess you dont know engines ,EFI , spark and many parts are all different by that fact.
if the USA car on this USA forum is a 4JG2
then all this is found at alldata.com
it a diesel engine, and we dont have them here.
it is direct injected diesel. sold in most markets, but not here.
Our isuzu dealers are gone now, they left uSA. for passenger cars.
so cant go there.
then go to yours and ask them?
"In 2002, the Trooper was discontinued in the United States."
so now i know car is not a USA car. and that our books dont cover cars not sold here.
so why not ask Isuzu this, go to the dealer buy the FSM book.
or join any non USA forum for isuzu. trucks. troopers


try here, link is random

http://forum.planetisuzoo.com/viewtopic.php?t=16663

they speak english only there too.
i dont see any spanish speaking isuzu forums.

best wishes.

Jul 03, 2015 | Isuzu Cars & Trucks

1 Answer

Why isuzu bighorn automatic transmission 4jg2 engine no shifting when engine is hot what is the trouble?


Have you checked the trans oil level correctly when hot? If its OK then you need a trans specialist to carry out various tests with gauges etc

Jun 23, 2014 | Isuzu Trooper Cars & Trucks

1 Answer

The windows in my Bighorn Lotus have stopped working.


check the switch of the window if will goes up or down if no reaction try to check motor of the power window inside the door..

Dec 09, 2013 | Cars & Trucks

2 Answers

Isuzu bighorn year 1995, not changing gear after 1st gear


This is the classic symptom of a vehicle with a failed torque converter lockup solenoid.
The lockup solenoid "locks up" the transmission to the drivetrain but only operates when the transmission progresses from first gear to second gear.

Dec 04, 2011 | Cars & Trucks

1 Answer

My 1995 isuzu bighorn need hard to shift into 2nd gear if the engine is not in peak temperature. I need to step the accelerator up to 2000 rpm before it shift to 2nd gear, but if the temperature goes up...


THERMOSTAT STAYING OPEN CAUSE PCM STAY IN OPEN LOOP WHICH WILL CASE ENGINE RUN POORLY TRANSMISSION SHIFTING LATE.REPLACE THERMOSTAT SEE IF IT HELPS PROBLEM.

Aug 09, 2011 | Isuzu Trooper Cars & Trucks

1 Answer

My 1997 Isuzu bighorn (trooper) appears to "miss"


When is the last time a tune up was performed on the vehicle? I would get some amsoil engine foam, and use it as described. Also get some fuel system cleaner and use that as well and go from there.
Thank you,
Lee

Nov 30, 2010 | 1994 Isuzu Trooper

2 Answers

My isuzu is 1996 bighorn . problem is check engine light come on engine stopped . how to read DTC .


Not sure about DTC but Diesel Bighorns have a real problem with cooking their alternators which present with similar symptoms to what you have described.
Hope this helps.

Apr 14, 2010 | 1995 Isuzu Rodeo

5 Answers

Isuzu bighorn automatic transmission slips after heating


Change your gearbox oil, and clean out the oil strainer.
Should help.

( On some models, you have to remove the gearbox oil pan to clean the strainer )

Nov 01, 2009 | 1994 Isuzu Trooper

1 Answer

How do you read the DTC´s from my Isuzu Bighorn 1992


a bighorn??should have an OBDII connection interface,then with the right software its not a problem.But by the time you pay for all that its cheaper to take it to garage

Feb 02, 2009 | 1992 Isuzu Trooper

Not finding what you are looking for?
1999 Isuzu Trooper Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...