Question about 2006 Ford F-150

Open Question

2006 ford f-150 4x4 problems

Won,t engage

Posted by Anonymous on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

4 wd is not engaging in my F-150 2006

my 05 fx4 had the same problem... just had replace the 4x4 vacuum solenoid $20ish (the cause of the problem) under the hood behind battery and (if needed) replace the 4x4 actuator's in both hubs off the cv shaft as mine were making ratcheting sounds as well... luckly i caught before hub bearing were shot or else would have had to replace hubs as well.

Jan 18, 2014 | 2006 Ford F-150

1 Answer

2006 ford focus automatic transmission doesn't engage its stuck in reverse and is not able to start

look on side of shifter see if there is an emergency release button on it some where

Sep 25, 2012 | 2006 Ford Focus

1 Answer

Replaced battery on my 2006 Ford Escape. Still won't start but everything else works

Figure by everything else you mean the radio,lights,etc? Is the engine turning over? What happens when the key is fully engaged? If the engine does not turn over the first place to look would be your fuses. Ensure that none look to be burnt or blown.If so replace and try again.If fuses look good Next step would be to ensure starter connection is good and starter is turning over.If the starter is not turning over then I would focus on it.Hope this helps.

Apr 15, 2012 | Cars & Trucks

1 Answer

Does a 2006 ford expedtion need a vaccum on front hubs to make engage and disengage

The vacuum is to keep the 4x4 disengaged, once vac is removed the IWE ( Integrated wheel end ) is engaged, so the front hubs are locked.

Block diagram from the F150, EXPY should be the same routing ( could be slightly different )

The f150 had a TSB for the IWE solenoid where water could get into the system, and cause the IWE to not be disengaged in 2WD ( slightly engaged, ratcheting the IWE gear ).
Right Click, Save As

Jun 16, 2011 | 2006 Ford F-150

1 Answer

2006 Ford f-150 will not engage 4wd. I have a

check the vaccum lines behind your front tires if they are on, with the truck running and lever in 4x4 high pull the line off if theres vaccum then you need to replace iwe. On my 07 its was 25.00

Feb 01, 2010 | 2006 Ford F-150

1 Answer

Our 2006 f150 4 wheel drive won't engage- dash

I had the same thing happen this weekend.Ij ust talked to my service man and he said if all the fuses are good it might be the switch on the dash.

Jan 24, 2010 | 2006 Ford F-150

1 Answer

I have a 2006 ford focus and my back door automatic lock wont lock. all the other locks engage but that one wont lock and i cant even manually engage it. any ideas

sounds like the fuse that controls that switch has burned out. check your fuse panel and refer to either the manual. or to the cove for fuse location info. good luck.

also note if the fuse blows again then the problem might be related to a bad switch or a short condition ion the wire.

Oct 01, 2009 | 2006 Ford Focus

3 Answers

Ford f250 four wheel drive electric selector problem. Will not shift out of four wheel low.

i have 2006 f250 4x4 will not engage unless i lock in hubs. once hubs locked in i can engage 4x4 by using electronic selector. why will it not engage when hubs are in auto and electronic selector is on 4high

Dec 21, 2008 | 2006 Ford F-250 Super Duty

Not finding what you are looking for?
2006 Ford F-150 Logo

Related Topics:

285 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5653 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides