Question about 2003 Honda CR-V

Open Question

2003 honda crv idle process

Engine idles rough engine light comes on after starter change out

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Molson02536
  • 3854 Answers

SOURCE: idle is too low, car dies, engine runs fine

An IAC (idle air control) motor is designed to adjust the engine idle RPM speed by opening and closing an air bypass passage inside the throttle body. The car computer or ECM (electronic control module) receives information from various sensors and will output signals to adjust the IAC motor in or out to adjust engine idle speed by controlling engine idle air.
An IAC motor is highly susceptible to carbon and coking build up; if an IAC goes too long without cleaning it can cause stalling and poor idle quality. Some cars are designed with a large vacuum transfer hose that connects the intake manifold to the IAC (idle air control) motor. If a broken or dilapidated these vacuum lines can cause the engine to lose vacuum which will allow the engine to run rough and die. 
Inspect all engine and accessory vacuum lines to look for missing, torn or dilapidated lines and replace as needed. To check the IAC motor remove the unit, with the wires connected turn the key to the "on" position without starting the engine, the IAC should move in or out. 
If the IAC motor does nothing it has probably failed, replace it with a new unit and recheck system. Note: while the IAC motor is removed clean (use aerosol carburetor cleaner) the passages the IAC uses to control idle air speed.

Good luck and hope this helps

Posted on May 08, 2009

Ad
  • 178 Answers

SOURCE: rough idle stalls at low rpm's

hello first check your idle with the car running foot on brake see were your rpm reading is if your below 500rpm check your label underhood for your curb idle setting second see if theres a adjustment screw you can increase were your gas cable lever rest against your set screw underhood if you feel confident enough remove your iac motor idle air control valve if the bore were the end of the pintle extracts out to close has varnish builup our carbon it will stick creating vacuum leak type senario causing stalling rough idle sometimes even no start conditions good luck

Posted on Sep 18, 2008

  • 449 Answers

SOURCE: 98 honda crv has p0505 code, engine shakes, no power.

Get a can of carburetor cleaner and spray it into the throttle body while the car is running.

Posted on Oct 28, 2009

  • 449 Answers

SOURCE: location of Idle control valve on 04 CRV

It's not a easy job but I'm pretty sure you had one of those problems where the idle surges if this is the case take out the air intake tube that leads to the throttle body, get a can of carburetor fluid and spray around the throttle body. You will need someone to start the car and hold the gas peddle to 2500 rpm while you do this the car will shut of when you do this, restart the car and repeat the process until half of the can is used up. Now check your antifreeze level fill if needed and reset you check engine light. Now you can take the idle air back and get your money.

Posted on Nov 17, 2009

  • 77 Answers

SOURCE: 1996 Honda Accord Rough Idle Even After tune up

Perform a valve clearance inspection and adjust if necessary. Tight or sticking valves will cause a misfire or rough running concern. Note: Perform valve adjustment when the engine is stone cold. 4cyl: INT 0.26mm EXH: 0.30mm (V6 engine are hydraulic and no adjust necessary.) Also check for a sticking or stuck open EGR valve. For diagnostic purposes only: Remove the EGR valve. Place a business card over the EGR passage and bolt the EGR valve back on. This plugs the EGR ports and if the misfire goes away the EGR valve is partially stuck open and is defective.
Check for low fuel pressure. Check for low compression. Check cam timing. Check for a weak ignition coil. Also don't over look the possibility of worn or broken engine mounts which cause excessive engine movement and engine vibration. -hope this helps

Posted on Mar 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

CODE 1259 HONDA 2003 CRV


Need to pull the code. Also what color is the smoke.

Jul 28, 2016 | 2003 Honda CR-V

2 Answers

2003 CRV Engine Light Code 1457 keeps coming back on after delete


If the code is back that problem that the PCM detected is still ongoing. Please watch the Youtube video at the link.

Honda CRV Code P1457 Honda CRV EVAP Solenoid

May 22, 2016 | 2003 Honda CR-V

1 Answer

The owners manual says to inspect idle speed at 160,000 mi, how is it done 2003 Honda CRV


Are you having an idle issue ??
Vehicle equipped w/Tachometer ??
Cold engine idle speed ??
Warm engine idle speed ??
Warm engine idle speed @ A/C requested on ??

May 28, 2015 | 2003 Honda CR-V

1 Answer

Have a 1997 CRV. The engine idle is way high and


Try changing your idle control valve, that should do the trick!

Jan 15, 2010 | 1997 Honda CR-V

1 Answer

98 honda crv has p0505 code, engine shakes, no power.


Get a can of carburetor cleaner and spray it into the throttle body while the car is running.

Oct 28, 2009 | 1998 Honda CR-V

1 Answer

91 mercury tracer check engine light after starter replacement


when you disconnect the battery.when changing the starter.you lost computer memory.the computer is going through relearning its program.it effects idling.should clear up after driving around a day or two.if it keep stalling take it to the ford dealership to relearn to idle.

Jun 12, 2009 | 1991 Mercury Tracer

1 Answer

Rough idle with check engine light


Usually a rough idle on a Honda is a result of the idle speed being too low. What is your RPM suring idle now. Try to increase it using the screw on the idle air control by only a quarter turn at a time. Hope this helps.

May 09, 2009 | 2002 Honda S2000

1 Answer

Engine Stalls when Cold on 1999 CRV


this sounds like the idle air control valve could be dirty or stuck. you can remove it to clean it

Apr 06, 2017 | 1999 Honda CR-V

Not finding what you are looking for?
2003 Honda CR-V Logo

Related Topics:

493 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...