Question about 1999 Dodge Ram
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Governor pressure sensor or solenoid is going bad. To replace them drop the tranny pan, remove the filter , and the parts are pretty ez to get to. These aren't cheep thou, but replace them as a set. Parts will probly run about $200.
Posted on Feb 20, 2009
usually they are at the back of the tranny with a 2 wire plugin and one bolt holding it in...if not it may be part of your rear ABS sensor in your rear end...do you have any codes about ABS
Posted on Jun 24, 2009
ON THE BOTTOM OF THE TRANY THERE IS A TAB ON THE SIDE OF THE TRANY ON THE BOTTOM LIP WHERE THE FILTER PAN IS BOLTED THE NUMBERS ARE STAMPED ON THE TRANY HOUSING ON THE BOTTOM NEXT TO THE PAN
Posted on Aug 19, 2009
Check the gauge by holding in the trip odometer reset button and turn key to run,hold button for 10 seconds this will iniate a diagnostics on all the gauges,and lights if gauge doesn't move during this test replace gauge,if it does move then check the wires on the plug at the engine coolant temp sensor (ects) you can check the sensor by using a ohms meter by unpplugging it and check ohm's or resistance when cold and then start engine as the engine warms up the ohm's reading should gradually lower as the sensor is a thermister and as it warms up the resistance will drop.
Posted on Jun 05, 2010
Tips for a great answer:
Sep 16, 2015 | Dodge Ram 1500 Cars & Trucks
Nov 09, 2014 | 1999 Dodge Ram
Jun 15, 2010 | 1999 Dodge Ram
Oct 04, 2009 | 1999 Dodge Ram
Sep 15, 2009 | 1999 Dodge Ram
Jun 14, 2009 | 1999 Dodge Ram
May 08, 2009 | 1999 Dodge Ram
Jan 20, 2009 | 1999 Dodge Ram
Mar 06, 2017 | 1999 Dodge Ram
91 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: