Question about 1999 Mercury Cougar

1 Answer

Vent tube where is the vent tube located

Posted by on

  • yadayada
    yadayada May 11, 2010

    What vent tube, more info please

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mercury Master
  • 4,369 Answers

If you are asking about the vent tube for the fuel fill, it is inside the fuel fill tube.

Posted on Jan 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is transmission vent tube for 1996 chevy K1500 - suspect it is clogged but cant find it


vent from trans comes out of trans on the passenger side of the trans.it is located about 1/3 the way back on top of the trans.a rubber hose will be attached and usually connects with the transfer case vent hose.If the trans overheated chances are there is a problem with the transmission.if the fluid smells burnt you have bigger issues.

Mar 09, 2014 | 1996 Chevrolet K1500

1 Answer

Rear differential


The tube you mention is probably the "vent" for the differential. Since the differential is low on the vehicle, water and dirt are concerns. By moving the vent to a higher location, problems with dirt and water are reduced.

May 30, 2013 | 1997 Ford Explorer AWD

1 Answer

Heater core


Sounds like a bad heater core. You will get steam/vapor out of vents from this. If you are referring to the over flow tube being the evaporator drain tube at the firewall its because the heater core shares the same case with the A/C and its filling up with anti-freeze.

Feb 24, 2013 | 1992 Pontiac Grand Am

1 Answer

Looking for the vent tube for the a/c system, where is this located.


The vent tube is located on the passenger's side lower portion of the firewall.

Apr 18, 2011 | 1997 Ford F150 Regular Cab

2 Answers

A/C not coming out of the front vents only the


Scan for bcm codes. Possibile door actuator motor inoperable. Also check for vacuum leaks under hood and dash

Mar 11, 2010 | 2004 Chevrolet TrailBlazer

2 Answers

Front vents do not work, a/c is blowing through the defrost and floor vents ur 2004 Ford Expedition Problem


I had the same problem and found that the vacuum tube located behind the battery was cut. The tube is about the size of an ink tube inside a ball point pen. The size is 5/32" and can be purchased at most auto parts stores. A quick splice and you will be back to cooling.

Jun 30, 2009 | 2004 Ford Expedition

1 Answer

1998 Buick Riviera battery


Make sure that you have the ventilation tubing when replacing the battery. The car is designed to vent battery gases from beneath the car. Substituting a different type battery (without vent ports, a small hole that is located at each end of the battery ) or if you decide to use the battery without the ventilation tubing, you run the risk of an explosion. This is due to the proximity of the battery to the fuel pump, which is also located beneath the seat.Underhood batteries vent naturally into the air within the engine compartment. In your car there is a small hole in front of your battery that leads to the underside of your car.Your tubing is designed to carry the battery's vapors way and direct it out of your car through this hole.

Jun 28, 2009 | 1998 Buick Riviera

1 Answer

My taurus failed due to code p0442 ecap emiss ctl sys leak detected (small leak)


    Continuous Memory Diagnostic Trouble Code (DTC) P0442 indicates that a fuel vapor leak has been detected [as small as 0.10 cm (0.04 inch)] in the Evaporative Emission (EVAP) system.
    Note: Prior to performing the following diagnosis inspect the Canister Vent Solenoid (CV) for contamination. A situation may exist where contamination holds open the Canister Vent (CV) solenoid enough to set DTC P0442 and also plugs the port to atmosphere enough to keep system from being vented quickly.
    • After market parts and accessories nonconforming to the EVAP system specifications.
    • Damaged, cross threaded or loosely installed fuel filler cap.
    • Small holes or cuts in fuel vapor hoses/tubes (EVAP canister tube, EVAP canister outlet tube or EVAP return tube) in the EVAP system.
    • Loose fuel vapor hose/tube connections to EVAP system components.
    • EVAP system component [EVAP canister purge valve, fuel tank pressure (FTP) sensor, canister vent (CV) solenoid, fuel vapor control valve tube assembly or fuel vapor vent valve assembly] seals leaking.
    • CV solenoid partially open when commanded closed.
    • EVAP canister leaking.
  • Check for presence of fuel filler cap.
  • Verify that the CV solenoid is properly seated on the EVAP canister (if possible).
  • Visually inspect for cut or loose connections to fuel vapor hoses/tubes in following locations:
    • EVAP canister to EVAP canister purge valve.
    • EVAP canister to fuel vapor vent valve assembly.
    • fuel vapor control valve tube assembly to fuel tank (if applicable).

Jun 26, 2008 | 1997 Ford Taurus

Not finding what you are looking for?
1999 Mercury Cougar Logo

Related Topics:

134 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...