Question about Cars & Trucks
The flasher will be under the drivers side of the dash. You will need to remove the trim pannel from under the dash. The flasher will be above and to the passenger side of the brake switch.
I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa
Posted on Feb 17, 2012
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: electronic flasher
It is in the fuse panel. Open your front car door and you will see a panel on the outside edge of your dashboard (hidden when the door is closed). That is where the fuses are and it is the big square fuse in the center.
Posted on Nov 26, 2008
Make sure you don't have delco loc 2 or theftloc audio system before disconnecting the battery. You should be able to do this by contacting your local dealer and they run the vin and tell you.
Before you put in the new pump you need to put grease on the splines.
take out the electric fan
take off the serpintine belt
use a large screwdrive or equivlent to hold the pump pulley and loosen all of the bolts holding the pulley on the pump.
After all are loosened then remove from the pulley and remove the pulley.
Take out the four bolts holding the pump to the engine block.
get a wood dowl or equilent and a hammer and give the old pump a few taps to break away the old seal.
Once the seals broke loose take the old pump out.
then clean up the block,
clean everything with brake parts cleaner
put RTV sealant on both sides of the new gasket and put it on the new pump.
try not to let the gasket move around so the bead isnt messed up to bad.
put the pump in and put all four bolts in finger tight
Torque on pump mounting bolts is 18 ft/lbs
Torque on pulley bolts is 18 ft/ lbs
then the rest is just reverse of removal
Posted on Mar 28, 2009
Well the biggest problems for the 98 and 99 cavaliers are that they mess up from the timing chain,..they make a rattling noise on the right side underneath the fender.
Posted on Jun 23, 2009
Drive it. Then have the rear abs brake sensors checked because they seem to be the first to go in a system like that. Someone with a scan tool should be able to read out any trouble codes in the abs system
Posted on Jul 08, 2009
Tips for a great answer:
Oct 19, 2014 | 1999 Chevrolet Cavalier
Apr 04, 2011 | 2000 Chevrolet Cavalier
May 24, 2010 | 1993 Chevrolet Cavalier
Dec 16, 2009 | 2001 Chevrolet Cavalier
Aug 22, 2009 | 1998 Chevrolet Cavalier
Mar 24, 2009 | 1999 Chevrolet Venture
77 people viewed this question
Usually answered in minutes!