Question about Dodge Avenger

1 Answer

Removing crankshaft nut 2000 dodge stratus 2.5 li

Should i lossen nut by going clockwise or counter clockwise

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Mentor:

    An expert who has written 3 tips or uploaded 2 video tips.

  • Expert
  • 245 Answers

Counter clockwise.

Posted on Feb 17, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

c17hydro
  • 2984 Answers

SOURCE: I HAVE A 2000 DODGE STRATUS 2.5 V6. WHERE IS THE

Cam is on the end of the block, crankshaft sensor is on the bottom of the block. Both are easy to change....are you changing these due to poor performance or no start condition?

Posted on Mar 21, 2009

  • 95 Answers

SOURCE: What is the trick to removing the harmonic balancer on a stratus

Theres no trick. It has to be cocked or something from all the pulling. Try tapping it back on, use spraylube on the crank and try again. Good luck.

Posted on Mar 23, 2009

old marine
  • 1921 Answers

SOURCE: Need the tool to take the crankshaft off of a 2002 Dodge Stratus

I think you mean the harmonic balancer, which is the pulley mounted at the front of the crankshaft. (You need to remove the engine and all of the pistons to remove the crankshaft itself.) Check your local parts store for a harmonic balancer puller -- I got one from NAPA for about $75 that allowed me to pull the balancer without removing the radiator/condenser.

Posted on Jun 12, 2009

polarcycle
  • 1392 Answers

SOURCE: 2004 DODGE STRATUS 2.7L, Location of Crankshaft Position Sensor?

it is located on the right side of the motor, in the trans area. Actually in the bell housing.

Posted on Jun 23, 2009

SOURCE: Manually close sunroof clockwise or counter clockwise '95 E320

Try it both ways and check , but do not apply too much pressure

Posted on Oct 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have to replace the passanger side mirror on 2000 dodge stratus. how do i go about doing this


remove the triangle trim piece on the interior side of door (usually snap on a delicate pry with a flat head screw driver will do the trick)
next remove the (3) 10mm nuts securing the mirror to the door, next unplug the mirror by squeezing the plug connector, pull the mirror of the outside of vehicle. Reverse this order during installation and you should be fine.
Note the mirror may fall and scrath the paint while the nuts are off, keep a hand on the old mirror to prevent from falling during removal

Feb 19, 2011 | 2000 Dodge Stratus

1 Answer

Removal of fan clutch on a 1999 Dodge Dakota 3.9 engine.


They make a specil tool to remove it, but you can use a long chisel and hammer to break the fan clutch lose. The chisel has to be long enough so you can reach the latge looking nut that is between the fan clutch and the water pump pulley. Take the top part of the radiator shroud off by removing the two bolts on each side of shroud. Than there is 4 to 6 bolts going across the front of the shroud. Next take the long chisel and catch the edge of the large nut and tap it so the large nut rotates counter clockwise when you hit it with fairly good force. That should break it loose. If not hit it harder. Once it is lose you can turn counter clockwise until it comes off. Remove the the fan blade and install it in the reverse order. Hope this helps. Leave comment.

Dec 11, 2010 | 1999 Dodge Dakota

1 Answer

2000 Stratus: My 2000 dodge stratus stalled today and the oil li...


mcdevito75 here, It could be the air idle valve or motor, Best Bet while that check engine light is on, have your auto repair shop take a scan of your vehicles computer and sensors.

May 18, 2010 | 2000 Dodge Stratus

1 Answer

I can't get the crankshaft damper pulley off of a 2000 Dodge Stratus, 2.4L, DOHC. My end goal is to remove the timing belt. I have already removed the accessory drive belts, but cannot remove the...


Download this link and find your Service manual for your vehicle. It will serve you well and to keep for future reference

http://ezinearticles.com/?Find-the-Free-Auto-Repair-Manual-You-Need-Online&id=92717

May 02, 2010 | 2000 Dodge Stratus

1 Answer

How do i take my fan off a 2000 dodge dakota?


you need a big wrench think its 22mm put it on the big nut inbetween the fan and waterpump pully andhit with a hammer carfully counter clockwise its a pain but will come off.

Feb 21, 2010 | 2000 Dodge Dakota Quad Cab

1 Answer

Im trying to remove crankshaft pulley am isuposed


the pulley nut comes off by turning it to the left yes counter clockwise and all you need is a steering wheel puller in most cases the pulley comes out by prying on it on one side with hand and tapping the opposite side with brass hammer.

Jan 10, 2010 | 2000 Daewoo Lanos

1 Answer

2000 stratus firing order....need help


Here's a link to the firing order including a diagram: It's 1-2-3-4-5-6 Clockwise

http://www.chiltonlibrary.com/content/images/7922/images/79223G29.gif

Hope this answers your question. All the best!
Greg

Jun 01, 2009 | 2000 Dodge Stratus

2 Answers

I have dodge stratus 2001 and I need to change the battery i couldn't find where it is


Front driver's side, black plastic panel towards the front of the driver's side fender. Jack the car and take the wheel off. There are 5 fastners that are there that need to be rotated counter-clockwise a quarter turn. Wiggle that panel out....there's the battery. A bracket keeps it in place, one bolt, one nut. Remove that and the battery slides right out. It is easier to remove it by taking off the tire but you CAN remove the battery with the wheel on. Just turn the wheels all the way to the right, like a hard right hand turn.

Nov 27, 2008 | 2004 Dodge Stratus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...