Question about 2005 Ford Explorer
I CHANGED THE WHEEL BEARING BUT THE ADVTRAC AND ABS LIGHTS ARE STILL ON, WHAT DO I DO????
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
You will have to retrieve and clear codes from VDM module with a scan tool. You may also have to calibrate it as well.
Posted on Jan 30, 2009
The bearings on the wheels has to be installed one way only, the rotor ring is built into the bearing and if installed the wrong way round the sensor cant pick up the wheel speed causing the ligt to be switched on in the cluster. The diagnostic equipment should pick this up as a fault once the car has been driven, it will see the sensor when you do the diagnostic if the car is standing still but once the car is moving and no signal is send from that wheel it would register a fault into the memory of the PCM that you would be able to retrieve later.
There is a way for you to test the sensor yourself by using a multimeter set on volts, you jack the vehicle up at that wheel, install a vehicle stand to support the vehicle to be safe, disconect the wheel speed sensor and probe the two wires into the sensor, spin the wheel by hand and a small amount of current will be produced meaning the the sensor is working and the wheel bearing is installed the correct way, you can also do a continuaty test on the sensor by switching the multimeter onto ohms, but be very carefull, if this sensor has three wires you cant do the continuaty test because of the integrated circuit in the sensor, the three wire sensors opperate on a voltage from 5Volt and it would be destroyed by the multimeter opperating on 9Volt.
If the continuaty test passes and the bearing is installed the correct way, the most comon fault would be a break in the wiring leading to the PCM
Hope this will be helpfull.
Posted on May 04, 2009
It means you have a fault in your vehicles antilock brake system. Having the light on will disable the abs system. Antilock/traction control keeps your wheels from locking up and provides you with a more controlled stop, such as in rain or snow. Take it in to a repair facility and have them scan the abs system for fault codes codes
Posted on Oct 14, 2009
SOURCE: our abs light advtrac light
You may have a bad wheel bearing--do you hear a growing noise that gets louder with speed? The wheel sensors on your wheels are sensitive to excess motion between the wheel hub and the wheel, as they have a small gap between the sensor and the tone ring on the axle. The speed sonsors are used by both the ABS and the traction control systems on your truck. You can check your bearings for failure by jacking up the car and trying to shake the wheel. If the wheel doesn't have noticeable play, the bearing may still be bad enough to cause the sensor to misread the speed. If you're not sure, have your mechanic check the wheel bearings. If you have more questions, please let us know.
Posted on Oct 28, 2010
Tips for a great answer:
Apr 30, 2015 | 2005 Mercury Mountaineer AWD
Feb 22, 2015 | 2003 Chevrolet Monte Carlo
Feb 16, 2013 | 2005 Ford Explorer
Nov 14, 2012 | Cars & Trucks
Mar 02, 2011 | 2006 Mercury Mountaineer
Oct 28, 2010 | 2005 Ford Explorer
Sep 13, 2009 | 2005 Ford Explorer
Jul 25, 2017 | 2002 Ford Explorer
43 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: